Question about 2006 Nissan Xterra

1 Answer

2005 Xterra fuel sensor bad and service engine light on!!!

Ive had my xterra for 4 years and ive experienced the same issue as others i fill up and the light stays on E and the service engine light came on... i took it to pep boys they want to charge me $300 for the part and $200 for labor!! Absolutaley insane, they claim that the gas tank has to be dropped in order to get to the part that needs to be replaced...I agree that we should all complaint about this issue obviously is a continous problem. I love my xterra and will like to get it fixed but $500 is out of my budget at the moment and i dont think we should have to pay for the repair if we are all have the same problem!!! Lets come together and complaint!!

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I dont have a solution, but i have the exact same problem with my 2006 xterra. when i fill my tank, it appears as empty, then it takes a day or two for it to register as full. and not only that, ive ran out of gas twice because the gauge didnt register as empty, on the gauge it still registered as a quarter and 1/2!

Posted on Jun 04, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How is the best way to get to get the crank postion sensor on 03 nissan xterra 3.3motor


I am sending you a link and there are 3 pictures. Click on the middle one or the far right if you recognize your engine you will notice that CPS is on the right rear of the engine good luck. http://www.2carpros.com/questions/2003-nissan-xterra-ive-been-looking-crankshaft-sensor-find-you-send-picture-tha. Click on this and then click on it again to open.

Jan 25, 2015 | Nissan Cars & Trucks

1 Answer

My 2001 Nissan Xterra engine stopped while driving... It jerked intermittently and finally came to a stop. The mileage is 61450 and I have not changed the timing belt. I bought last year February. The


You might want to check the distributor. Take the cap off and check if there is play on the rotor shaft. It's only supposed to turn, but if there's play when moving it back and forth, better you replace the distributor now. The 2000-2004 Xterras have a bad distributor shaft and the throttle positioner sensor is on the shaft. Just FYI.

Feb 03, 2014 | 2001 Nissan Xterra

2 Answers

I have a 2007 Nissan Xterra. Check engine light is on, gas cap gasket has been replaced and the O2 sensors are being replaced tomorrow. Today it would hesitate/slow acceleration when at 40-60mph (2000...


if you have an O2 sensor faliure you will have a code for it. in fact youe exterra doesnt have O2 sensors. it has A/F sensor or "air/fuel sensor" if it went bad, than you will have a code for that sensor. What is the code number that you have?? need to start there.

Oct 09, 2011 | 2007 Nissan Xterra Off Road

1 Answer

SES light on code P0171, 2005 Xterra, what to do??


P0171 is a lean oxygen sensor code for bank 1 on your engine.
It indicates that there is a lean condition (engine not getting enough
fuel or getting too much air) on that side of your engine.
Bank 1 is always the side of the engine where #1 cylinder is
located. In your case it is front-most cylinder on the right side
of the engine. (As viewed from the driver's seat)
So bank one is the passenger side.

If there are any other engine control codes, you need to fix those
first, as they may be the cause of the lean condition.

If that is the only code you are getting, then diagnostic testing
needs to be performed to determine the actual cause of the problem.

Possible causes are:

* Intake air / vacuum leaks
* Faulty / dirty fuel injector(s)
* Incorrect fuel pressure (Likely to cause both P0171 and P0174 at the same time)
* Low fuel volume (Pressure OK) (restricted fuel filter,etc.)
* Fauly Mass Airflow Sensor
* incorrect PCV hose connection
* Exhaust gas leaks
* Faulty Air Fuel Ratio Sensor

Dec 01, 2010 | 2005 Nissan Xterra

2 Answers

HOW TO REPLACE A FUEL PUMP FOR A NISSAN XTERRA



Removal & Installation

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Relieve the fuel system pressure.
  3. Drain the fuel tank.
  4. Remove or disconnect the following:

    Negative battery cable Fuel pump module harness connectors Filler hose shield Fuel pressure and return lines Filler hose Vent hose Evaporative Emissions (EVAP) hose Fuel tank skid plate Fuel tank Fuel level sender Fuel pump

To install:
  1. Install or connect the following:

    Fuel pump Fuel level sender. Tighten the screws to 17-23 inch lbs. (2.0-2.5 Nm). Fuel tank. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). Fuel tank skid plate. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). EVAP hose Vent hose Filler hose Fuel pressure and return lines Filler hose shield Fuel pump module harness connectors Negative battery cable
  2. Fill the fuel tank.
  3. Start the engine and check for leaks.

Mar 31, 2010 | 2005 Nissan Xterra

3 Answers

Diagram available for 01 Nissan Xterra Knock Sensor location?


V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace.

9bd8ec7.jpg

Fig. Engine compartment component locations

Hope this help (remember rated this free help) Good luck.

Feb 08, 2010 | 2001 Nissan Xterra

1 Answer

Fuel Gage reading E after I Fill up.


The fuel level sending unit is bad. Part is $90 from dealer. You can replace it yourself and save $500 from stealership. Drop gas tank and remove fuel pump. Sending unit is attached to fuel pump.

May 31, 2009 | 2005 Nissan Xterra

2 Answers

Fuel Gage reading E after I Fill up.


the problem would be that of the fuel gauge which in newer models are mounted in the fuel tank, or the fuse for the gauges are burnt out, or there is a loose connection

Apr 20, 2009 | 2005 Nissan Xterra

2 Answers

Fuel Gage reading E after I Fill up.


WE HAVE THE SAME PROBLEM WITH OUR NISSAN X-TERRA. HOPEFULLY THEY CAN COME UP WITH A RESOLUTION FOR THIS PROBLEM THAT WAS CAUSED FROM THE MANUFACTURING OF THE VEHICLE. WE CAN ALSO TRY THE BBB ( BETTER BUSINESS BUREAU) AND PUT UP A COMPLAINT TO THEM AS WELL. IT'S PATHETIC THAT WE WOULD HAVE TO PAY OUT-OF-POCKET FOR THEIR MALFUNCTIONS. -NL

Jan 18, 2009 | 2006 Nissan Xterra

Not finding what you are looking for?
2006 Nissan Xterra Logo

284 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

79186 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...