I have a 1996 mercury sable. I have done the on off with the ignition many times. My locks do not open and close to confirm I am in programming mode. I have tried with door open, closed. Lock up and down. I am not sure if I am missing something. Is there a fuse or relay for the key fob?
SOURCE: mini cooper key fob settings
Try pushing the unlock button twice.
Mechanic @ Large Mobile Automotive Service Tucson,AZ
www.mechanic-at-large.com
SOURCE: 2004 Civic Drivers door lock
The driver's side door lock button is designed not to lock from the inside unless the handle is pulled, or the power switch is used. This serves as a reminder to not lock your keys inside.
If you are inside, and push down on the button (not the switch) hard enough to lock it, you've probably damaged it.
SOURCE: 2002 Jeep Liberty, rear window latch is ''locked'' & window is open
rear door of my 2002 liberty will not unlock . I do not have power locks $
SOURCE: programming keyless remote
2003-04 Mazda 6 REMOTE PROGRAMMING
Step 1: Open drivers door and leave open.
Step 2: Lock and unlock the driver’s door using the power door lock switch on the door.
Step 3: Insert key into the ignition.
Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.
Step 5: Open and close the driver’s door 3 times. (Door should be left open after this step).
Step 6: ECU should respond by locking and unlocking the doors.
Step 7: Press any button on remote #1 twice. ECU responds by locking and unlocking the car doors.
Step 8: Press any button on remote #2 (etc.) twice. Each time the ECU will respond by locking & unlocking the doors.
Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks. You're done!
Good Luck.
SOURCE: back door on drivers side locked wont open or
can you lift the lock knob up at all?? If you can lift it and the door stays locked, the linkage inside the door is broken.. if you can't lift it up, then the linkage is most likely seized... you'll need to remove the door panel to actually see it
113 views
Usually answered in minutes!
×