Question about 2003 Nissan Xterra

Open Question

Vehicle starts idle well check engine light on but won,t accelera

2003 nissan x-trail starts idles well but won,t accelerate over 1500rpm check engine on 2.5lt petrol

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
radar001
  • 1051 Answers

SOURCE: 2003 nissan x-trail starts idles

You need to adjust the ignition timing. If your not familiar with how to do this I'd suggest going to a reliable mechanic.

Posted on Sep 23, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 2.2dci run on when you take foot off accelerator Nissan x trail


Dirty throttle body and idle air control motor. First guess.

Dec 19, 2016 | Nissan XTrail Cars & Trucks

1 Answer

My nissan 200sx s14 95 model idles at 1500rpm and


have you cleaned the crankcase vent and rocker cover vent , try running engine with the air intake hose off , just at idle and see if there is any change ,is the accelerator cable moving freely when released , return spring or stepper motor returning correctly , try a fuel addative , get one that covers the catalytic convertor as well as the valves,injectors etc ,follow the manufacturers instructions and take for a good long drive , at least 50 miles at a good speed , motorway would be best to get the engine up to a good temperature , keep me posted if you wish

Sep 28, 2014 | 1995 Nissan 200SX

1 Answer

My 1994 Nissan Quest engine starts up properly and idles when cold. After the engine has been running for a while the idle is a little off every time I stop at a light or when it gets to about 1500 rpm....


Looks like you have a wire harness problem check your harness around the engine and see if there is any broken or making contact specially with the exhaust manifold also check you crank sensor and your fuel pump, because something is getting overheating.
Good luck.

Jan 01, 2014 | Cars & Trucks

1 Answer

My nissan 2001 sylphy is not idling less than 1500rpm whats wrong


Have you check you speed sensor. Ot idle sensor

Feb 28, 2013 | Cars & Trucks

1 Answer

2003 nissan x-trail starts idles well but won,t accelerate over 1500rpm check engine on 2.5lt petrol


You need to adjust the ignition timing. If your not familiar with how to do this I'd suggest going to a reliable mechanic.

Sep 23, 2010 | 2003 Nissan Xterra

3 Answers

The engine starts and runs in idle, ABS light is


that is your anti-lock-brake system warning light take to a pro

Oct 07, 2009 | 2003 Nissan Pathfinder

1 Answer

Tickover at 1500rpm when engine warm Nissan Navara 2003


Could be a bad TPS or IAC. If you have not cleaned the throttle body in a long time a dirty one will cause all kinds of bad running/idling and drive-ability issues. Its the easiest thing to do and the least expensive. Remove it to clean properly, then clean it and any sensors, as well as the passages in the intake manifold. Then reassemble with a new gasket, and see what happens.

Sep 07, 2009 | 2003 Nissan Frontier Crew Cab

1 Answer

2003 nissan altima rpm goes crazy (at 2 then drops to 0, back and forth)then it dies. it is doing it more frequently


I have also read in the service manual that doing an idle relearn helps with RPM problems. This is the procedure below. It is complicated to do unless you have a watch or something to count the seconds with.

DESCRIPTION
“Accelerator Pedal Released Position Learning” is an operation to learn the fully released position of the accelerator
pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time
harness connector of accelerator pedal position sensor or ECM is disconnected.
OPERATION PROCEDURE
1. Make sure that accelerator pedal is fully released.
2. Turn ignition switch “ON” and wait at least 2 seconds.
3. Turn ignition switch “OFF” wait at least 10 seconds.
4. Turn ignition switch “ON” and wait at least 2 seconds.
5. Turn ignition switch “OFF” wait at least 10 seconds.
Throttle Valve Closed Position Learning UBS002OA
DESCRIPTION
“Throttle Valve Closed Position Learning” is an operation to learn the fully closed position of the throttle valve
by monitoring the throttle position sensor output signal. It must be performed each time harness connector of
electric throttle control actuator or ECM is disconnected.
OPERATION PROCEDURE
1. Make sure that accelerator pedal is fully released.
2. Turn ignition switch “ON”.
3. Turn ignition switch “OFF” wait at least 10 seconds.
Make sure that throttle valve moves during above 10 seconds by confirming the operating sound.
Idle Air Volume Learning UBS002OB
DESCRIPTION
“Idle Air Volume Learning” is an operation to learn the idle air volume that keeps each engine within the specific
range. It must be performed under any of the following conditions:
 Each time electric throttle control actuator or ECM is replaced.
 Idle speed or ignition timing is out of specification.
PREPARATION
Before performing “Idle Air Volume Learning”, make sure that all of the following conditions are satisfied.
Learning will be cancelled if any of the following conditions are missed for even a moment.
 Battery voltage: More than 12.9V (At idle)
 Engine coolant temperature: 70 - 95ーC (158 - 203ーF)
 PNP switch: ON
 Electric load switch: OFF
(Air conditioner, headlamp, rear window defogger)
On vehicles equipped with daytime light systems, set lighting switch to the 1st position to light
only small lamps.
 Steering wheel: Neutral (Straight-ahead position)
 Vehicle speed: Stopped

Apr 29, 2009 | 2003 Nissan Altima

Not finding what you are looking for?
2003 Nissan Xterra Logo

Related Topics:

305 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...