Question about 1985 Jaguar XJ6

1 Answer

Jaguar xj6 head remove

How does camgear assembly dis-assemble?PLEASE 7 L engine

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

It has big circlip on timing wheels undo clips then lock tags then four bolts each side on cams take sprockets out

Posted on Jul 18, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Antifreeze in engine


Anytime you have coolant in the oil and it's not the oil cooler it means the engine must be disassembled to locate the failure. The next options are not so pretty. There are three remaining causes for coolant in the motor oil and all require engine dis-assembly. This can be tricky because the repair overlaps and it is difficult to tell which one is causing the problem. For example: A repair shop has told you the cylinder head is cracked, and as they start dis-assembly they can discover it was the intake manifold gasket that has failed. It's up to the honesty of the repair shop to inform the customer that the cost of the repair will be less. Or the opposite can happen, example: A repair shop has told your engine has a blown head gasket, once the dis-assembly is complete they inform you the head gasket is ok, and the cylinder has been pressure checked and is ok. This only leaves the engine block as the failure and must be replaced to repair the problem, and that can be very costly. Always check the intake gasket first on V6, V8 and V10 engines. Then the cylinder head gaskets, cylinder heads and finally the engine block.

Apr 09, 2013 | 2005 Dodge Durango

1 Answer

Removing ignition lock tumbler for 87 jaguar xj6 vanden plas


If you have the key no problem but without the key you will need to change the entire steering lock assembly

Mar 21, 2013 | 1987 Jaguar XJ6

1 Answer

2003 jaguar xj6 heater problem


You vehicle is equipt with a climat control module,the system uses a auxillary water pump on top of that water pump is a water valve assemble. This operates by means of a eletrical assembly. To find why the heater system is not functioning is by the use of a scan tool that can diagnosis of the climate control this system is electrical controlled

Mar 06, 2012 | Jaguar XJ6 Cars & Trucks

1 Answer

How to Change alternator on 2003 jaguar


Hi!!

This instruccions are for supercharged and non supercharged engines, if your engine is not supercharged disgreggard steps 4 and 8
.
To replace the alternator, remove or disconnect the following:

1 Negative battery cable 2. Air intake assembly 3. Cooling fan assembly 4. Supercharger drive belt, if equipped 5. Accessory drive belt 6. Alternator air intake ducting 7. Alternator wiring connectors 8. Supercharger water pump, if equipped 9. Alternator Good Luck!! Don't forget to rate this post!!

Aug 08, 2010 | 2003 Jaguar X-Type

1 Answer

Broken headlights switch of 1985 jaguar xj6


yes you can do it might be tough but it can be done

Mar 09, 2010 | 1985 Jaguar XJ6

1 Answer

How to remove trim and panel to replace inside left door handle assembly for 1995 Jaguar XJ6?


There is a square plate, behind the chrome opener, prise this out and there is a screw behind it, there are screws in the bottom of the arm rest, the rest is just on plastic push fit rivits so the door card should just gently pull or prise free.

Jan 27, 2010 | 1995 Jaguar XJ6

1 Answer

Adjustment nuetral park switch for 95 jaguar xj6


The switch is mounted on the side of the shift lever assembly. You must remove the centre part of the center console. The switch is on the side of the assembly and has 2 screws to allow adjustment, slacken the screws, put the transmission in neutral and move the switch a fraction at a time and try to start the car, when you can, then this is ok, also check that the lamps are working correctly when you move the shift lever, that they illuminate in the right position, tighten the switch and put everything back.

Oct 19, 2009 | 1995 Jaguar XJ6

1 Answer

I have Jaguar XJR 2001. How do I replace Blower Motors Left and Right side? ( Noise bearing )


Driver side :
1- Remove upper steering column 2- Remove driver stowage compartment 3- Remove driver's footwell duct 4- Remove cable tie 5- Remove duct connecting blower assemble to heater/cooler unit 6- Disconnect harness connector from blower assembly 7- Remove blower assembly.
Install in reverse order. Tighten nuts to 5-7 Nm
Passenger side :
1- Remove Instrument panel 2- Remove passenger footwell duct 3- Disconnect harness connector from blower assembly 4- Remove festeners securing duct to heater/cooler unit 5- Remove duct connecting connecting blower to heater/cooler unit 6- Remove blower assembly
Install in reverse order. Tighten nuts to 5-7 Nm

Sep 11, 2009 | 2007 Jaguar XJR Sedan

2 Answers

How can I replace AC blower.


try these websites www.autozone.com and www.alldatadiy.com if all fails stop by your local dealer in the parts department and ask them to print you off a diagram showing you where the motor goes.

Jul 30, 2009 | 1994 Jaguar XJ6

2 Answers

Jaguar xj6 1997 radio wont turn on till engine is


try pressing the tape eject botton every time you have that issue. If it don't work get back with me...dmakia@gmail.com

Feb 20, 2009 | 1997 Jaguar XJ6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

228 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...