Question about 1991 Toyota Celica

1 Answer

Does the motor need to be taken out to replace the water pump?

Water pump needs to be replaced.. do you have to pull the whole motor out to replace it?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 2,187 Answers

If you are referring to the engine, no need to remove it but you may have to remove the belts and a cover... depending on the engine

Posted on Jun 03, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How can I tell if the seals are bad and not the whole water pump on a 05 envoy. Before I purchase the whole pump and all I need is the seals?

You can't buy a water pump seal by itself. Gasket, yes. Seal, no. If you're going to go to the trouble to remove it to replace a gasket, you replace the whole thing

Aug 10, 2017 | Cars & Trucks

1 Answer

How can i tell if my coolant leak coming from my water pump

The water pump is in front of your motor. If the coolant is leaking from under the water pump, then the gaskets on your pump need to be replaced. Depending on how many miles you have on your vehicle, you're better off replacing the whole pump, plus the belts and thermostat. Yes, new gaskets come with the pump.

Jan 07, 2014 | 2002 GMC Yukon Denali

1 Answer

Need to replace water pump on nissan 1997 quest

Not sure why all other parts removed? Locate the water pump by following the lower radiator hose to the motor...the connection is part of the water pump housing...Also look at the replacement water pump to see what few bolts need to be removed to switch the pump. Be sure to use a water pump gasket sealer when applying the new water pump gasket...coat both sides as this also helps to hold in place while re-assembling. Reconnect all hoses and clamps...install the belt before testing...Talk with your local parts store also...the water pump usually comes with a replacement diagrahm too. Hope this helps.

Jan 21, 2013 | 1997 Nissan Quest

1 Answer

How to replaced the water pump.

You didn't mention the model of your car. Regardless of what model it is, if you have a mechanical fan, you need to remove it. You will need to buy or make a tool that is a flat strap of metal with holes drilled in it spaced to fit over the heads of the 10 mm bolts that hold the fan pulley on. The tool holds the fan pulley from turning while you loosen the fan. The fan unscrews with left handed threads.
The plastic shroud around the fan comes out together with the fan. On some cars, the water reservoir is attached such that it is easier to pull the whole radiator out with the shroud.
The water pump fits pretty snugly in its hole. There may be a threaded hole in the pump cover that is 'blind. That is, when you screw a bolt in the hole, it pushes against the engine block to pull the pump out of its hole.
While you are replacing the water pump, you will want to replace the thermostat as well as preventative maintenance.
That is about all I can tell you without knowing what model car you have.

Feb 21, 2011 | BMW 325 Cars & Trucks

1 Answer

I need to replace main oil seal on side of motor with fan belt,water pump,etc. Is this possible? If so, how?

yes it is possible but you have to disassemble the whole front side of the motor.i would not sudjest doing it unless you are a experianced mechanic

Jan 21, 2011 | Suzuki Swift Cars & Trucks

1 Answer

How difficult is it to replace water pump on a 1997 dodge grand caravan 3.3L?

Very easy. You can do this. Just take off the serp belt by pulling down on the tensioner with a 15mm wrench. Then remove the three or four bolts for the water pump pulley. You will need to be under the vehicle for this. Then remove the five or six bolts for water pump. Pull the pump out and install new one in the reverse order. Just slip the belt off the water pump so you don't have to figure reroute the whole thing unless you are replacing it. Also clean the mating service for the pump before installing the new pump with the new gasket. Should take about an hour

Oct 07, 2010 | 1997 Dodge Grand Caravan

1 Answer

Windscren washer not working on my peugot207cc

Check the fuse for windscreen washer.
If you can hear the washer motor running but no water comes out then check the washer motor under the side wing cover.
Pull the rubber pipe from motor and then let the washer run to check wheather water will be pumped or not.
If yes the problem is on the side of rubber-pipe to spray-jets on bonet (may be spray jets need some cleaning).
If not then then the problem is in washer pump. The dirt that reside during the time inside washer pump (the plastic pump attached to the washer motor) causing the problem.
Pull out the whole pump motor from tank and disassemble the pump to clean the free moveable conical metal rod and rubber washers (takes about 1.5 hours for cleaning). If you don't want to do it then convenient is to buy another washer (set of motor+pump).

Jan 16, 2010 | 2006 Peugeot 405

1 Answer

PT Cruiser Timing chain and water pump problems removing

you need to drop the sub-frame. thats the only way

Apr 19, 2009 | 2001 Chrysler PT Cruiser

2 Answers

Water pump replacement

the water pump should be located front right of motor the only thing that may take some time is if the belt needs to be replaced some models require you remove part of the engine mount. Job should take a pump / belt if damaged / antifreeze.

Dec 18, 2008 | 1992 Pontiac Grand Am

Not finding what you are looking for?
1991 Toyota Celica Logo

Related Topics:

112 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides