Question about 2005 Jeep Grand Cherokee

1 Answer

A/c control panal light bulb out how do i replace it myself?

My light behind the ac control knobs does not work, how would i go about replacing the lightbulb myself. I cann't seem to find any instructions on how to take dash board apart.

Posted by on

  • Douglas Fields
    Douglas Fields Jun 23, 2009

    thanks i'll just have to turn the dome light on at night to see the panel whe i need to switch it... lol



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 90 Answers

This is not a easy fix and it does not have a bulb to illuminate it the illumination is part of a circuit board and the whole unit requires replacementand it is quite expensive,sorry

Posted on Jun 22, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I replace a climate control panel light bulb for a 2000 VW Cabriolet. I've pulled off the fan control knob and do not see a bulb?

the "bulb" is usually built into the switch/knob , i've never seen one that can be replaced without getting a new knob , or the other variation is an LED behind the panel , these are also non replaceable but can be repaired if you can find an auto electrician to carry out the job

Dec 27, 2014 | Volkswagen Cabriolet Cars & Trucks

1 Answer

How to replace a light bulb on 2006 Rav 4 fan control knob?

micro bulb behind the panel may have burnt out.

Mar 19, 2014 | 2006 Toyota RAV4

1 Answer

How do I replace the light in the dash for the heating knob ( vent, defroster, etc)

The tiny incandescent light bulb is behind the knob soldered to the circuit board, you must remove the climate control head unit and take it apart to access the knobs back light bulb on the circuit board. You can buy the replacement bulb at Radio Shack, the part number is 7219 Micro Lamp.

Dec 05, 2011 | 2006 Chevrolet Equinox

2 Answers

Lights on fan knob does not work

the bulbs are made into the a/c control head and are not replaceable. the only way to get them working again is to replace the hole assembly.

Aug 18, 2009 | 2004 Mazda 6

2 Answers

The center console in 1999 passat works AC etc but no lights. fuse looks fine.

There should be a VERY small bulb (if this is a manual control) behind the fan speed selection knob, Pull on the knob and it should come out, and i usually get the light out using some vaccum line.

Jul 07, 2009 | 1999 Volkswagen Passat

1 Answer

Interior lights on climate clontrol knobs don't work

I have this same problem, have you found a way to fix it?

Jun 02, 2009 | 2005 Jeep Grand Cherokee

1 Answer

One of the lights for the heat/ac unit is out

If you pull out that knob assembly that controls the drivers side heat behind it you will see little black clips that hold in the bulbs.But if you dont the bulbs are inside the controller and it will have to be disassemble to change them...

Mar 31, 2009 | 2003 Chevrolet Impala

1 Answer

Light bulbs behind the 3 heater/ac controls

to get to these you need to remove the box above by taking out the rectangular screw cover at the back and take out the one screw. gain access to the edge of the box with a flat tool and gently pull the box clear from its clips. now the 2 retaining screws should be visible that hold the controls in place after removing these you need to pull the controls quite firmly from its clips being careful not to damage the wiring to the back. this multiplug has to be released by pressing a retaing clip on the plug itself. once removed the whole unit needs to be separated into 2 halves being careful of static, by removing the screws on the back.once inside there are grey and white bulbs, white for the illumination and grey for the buttons (heated rear window and a/c etc)

Jan 02, 2009 | 2002 Honda CR-V

1 Answer

AC panel lights 05 camry

those bulbs cannot be replaced individually, you have to replace the whole ac control panel.

Sep 07, 2008 | 2000 Toyota Camry

Not finding what you are looking for?
2005 Jeep Grand Cherokee Logo

345 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides