Question about 1989 Chrysler LeBaron

2 Answers

Dies out when i start it and wont go past 35mph

I have a 89 chrysler lebaron and it wont go pass 35mph if i press the acclerator down it sounds like it wants to die out. i just changed spark plug wires,spark plugs,fuel filter,coil pack any suggestions plz let me know thx.

Posted by on

  • Richard Scordino May 11, 2010

    check converter and egr valve

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Not sure but the 89 probably has a mechanical fuel pump and this is a symptom of one getting weak.

Posted on Aug 04, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 6,982 Answers

What goes in, must come out...have the converter tested to make sure it's not plugged up.

Posted on Jul 22, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Adjusting headlights on my 89 chrysler lebaron


normally 3 screws at the back of the head light case set in a triangular pattern

May 23, 2013 | Cars & Trucks

1 Answer

I have a 1992 chrysler lebaron about every 3 months it will start but wont tay runnig unless i have my foot on the gas and the tac barley registers I have done a tune up and changed the gas filter hel


As far as I know the only thing you are doing by holding the gas pedal down is bypassing the idle air control valve. The computer controls idle speed by that valve.
Most times the valve is faulty or there is dirt in the throttle body that blocks air flow to the valve.
If the check engine light comes on there should be a trouble code for the valve or the problem.

Aug 23, 2012 | 1992 Chrysler Lebaron

1 Answer

Where do I find the fuel filter on an 89 chrysler lebaron


On 1989 Chrysler Lebaron 2.2L TBI 4cyl the Fuel Filter is located under vehicle, passenger side, below trunk area, next to fuel tank, mounted in fuel line.

Hope this helps; remember to rating this answer leaving a testimonial comments. Thank you for using Fixya.

Oct 17, 2011 | 1989 Chrysler LeBaron

1 Answer

1984 chrysler lebaron turns over but wont start


The old dodges had a ballast resistor that would cause this. It is a ceramic rectangle shaped part held on by a screw with 2 wires plugged into it. It should be on the firewall. New ones are $5 at part stores. If they crack, the car can die going down the road, won't start if there is even a little moisture in the air.

Mar 19, 2011 | Chrysler LeBaron Cars & Trucks

1 Answer

My 1995 chrysler lebaron starts and dies. runs great on eather but wont squirt gas into the motor. fuel pump works great injectors open when key is on and then close and wont reopen.


You might also want to check to see if you vehicle has an anti theft function i have the 95 lebaron and if the anti theft is activated it starts runs for a few second and dies. if battey dies or is replaced i have to go to the passenger door and put in the key and turn it 4-5 times then it starts and runs so try this first.


Read more: http://wiki.answers.com/Q/Why_does_my_1995_chrysler_lebaron_start_but_only_runs_for_seconds_what_are_the_possible_problems#ixzz1Pmb08o4d

Aug 05, 2010 | 1995 Chrysler LeBaron

1 Answer

I have an 89 Lebaron 2.5L coup with only 20000 miles. It runs great but....at random the engine will die. After waiting for about 20-30 minutes it will start and run fine m aybe for one or two months then...


Possibly the catylatic converter look under vehicle at night after car has been running for at least 10 minutes see if the converter is bright red if so it needs replaced

Jun 15, 2010 | 1989 Chrysler LeBaron

1 Answer

Right side wiper blade operation has failed. Left side works fine. 89 Chrysler LeBaron 2.5L turbo


Sounds like plastic clip that connects right side wiper transmission to left side & motor broke. You can get the clip at an autoparts store. HELP/Motormite sells them.

Jun 15, 2010 | 1989 Chrysler LeBaron

2 Answers

Do you have a diagram on how to install a serpentine belt on a 1994 Chrysler LeBaron?


1994 CHRYSLER LEBARON - V6 3.0L 2972cc 181ci GAS FI N 3

Open the hood, the diagram for the serpentine belt is on the cowling.

From DAYCO Catalog
Belt Routing Diagram (Alt., P.S., Idler & Tens.)
9e1b1eb.jpg


From comments to other users and Lebaron Owners; for remove, starting at the alternator pulley and going clockwise around the pathof the belt, the belt drops down and forward and goes under the idlerpulley, continues forward and less steeply downward and goes around thecrankshaft pulley clockwise, rises rearward going over the top or thetensioner pulley counterclockwise, then drops down and around the powersteering pump clockwise and rises to go around the alternator pulleyclockise (which is where I started the description). To loosen thetension to remove the belt, or to give you slack to install the beltwithout having to force it over a pulley while under tension you rotatethe tensioner pulley arm around its pivot clockwise according to the'94 shop manual. It doesn't show by what means to effect this rotation,but in the earlier manual I have ('89) it shows there to be a 1/2"square hole in the tensioner arm into which you insert a breaker barwith a 1/2" square drive which gives you the temporary lever to rotatethe tensioner against its spring action. I assume there is a similar1/2" square hole on the '94 you are working with. Interestingly,between '89 and '94 the idler pulley was added, and the requiredrotation of the tension arm changed from counterclockwise to clockwiseto relieve the tension."

I think this will help you get the belt on. Good luck.

Oct 13, 2009 | 1994 Chrysler LeBaron

1 Answer

89 Chrsler New Yorker Lebaron won't start


possibly the fuel filter. Try taking of the battery cables and resetting the computer

Sep 07, 2008 | 1989 Chrysler New Yorker

Not finding what you are looking for?
Cars & Trucks Logo

210 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...