SOURCE: door panel toyota
three steps.
1. locate screw holes for door handle (and other areas maybe) and remove. the screws may be located behind plugs that you remove with small flat screw driver
2. disconnect and remove power lock/window unit, usually pries up from one end (rear of car) and slides out. be careful not to stracth leather or upholstry
3. using screwdriver, pry bar, nail bar or other flat piece of metal pry panel away from door one clip at a time. try to pry near the clip, otherwise you risk damaging the panel's interior
post another problem if you get further and still have trouble.
paul
SOURCE: To remove the interior door panel of a 1996 Toyota camry so that
My 96 Camry LE has 9 attachments that are visible. Some have plastic caps covering the screws; others do not. There are screws at the door handle, at the forward portion(with covers) when the door is open and the back edge (small covers). As I recall, there are several friction type fasteners around the perimiter of the panel that can be removed by prying carefully away from the metal portion of the door to free up the trim panel. Once these are loose, the trim around the inside door release handle (the one you pull to open the door) can be pryed in a backward motion. Then the entire panel can be removed by pulling upward and backward at the same time (it easier to do this with the window down). Then it is a matter of disconnecting the wires attached to the various controls for the electric windows and door locks to free up the panel itself. There is probably a plastic skin covering the metal portion of the door. Carefully pull that away to expose the inner workings of the door latch mechanisim. The rest of the procedure should become easy to figure out. I have not removed the exterior door handle itself; but it is a simple mechanism as I recall. Best of luck to you.
Timmy P.
SOURCE: remove door panel for 2002 toyota camry
I was looking for similar and had just seen this.. Hope this helps..
http://www.bodyshopzone.com/archives/trim/door_panels/Toyota/Camry_2000_front/removal_f4.html
SOURCE: removing door panel in 2000 toyota corolla
remove phillips scew and the door handle. remove padded arm rest on the door by lifting it up, and remove 2 screws. You can use a panel tool to remove the plastic toggle like pins holding the panel border in. Be as gentle as possible they may break due to becoming brittle.
SOURCE: I need to remove 2004 toyota sequoia tailgate door
Slide the plastic cover off the tailgate ******** the passenger side to reveal a 10mm bolt.
Remove the bolt and the strap/
Using a flat prying instrument, remove the center trim section one the inside of the tailgate above the window.
Grab the top edges of the side trim sections on the inside of the tailgate and pull down to remove.
Using a flat instrument, pry at the bottom edge of the tailgate main trim panel, it is held on with about 12 plastic pop-in fasteners so it will take several 'pops' before it is released.
Behind that there is a metal access cover the width of the tailgate, held on by ~5x pop in fasteners and ~10x 10 mm bolts. Remove the bolts and pop the panel loose, it will hang by the wiring so support it while you do your camera work :)
The license plate trim panel, should you need to remove it, requires remoaval of the license plate.
Then remove ~3x 10mm bolts from the top of the panel, accessed from the inside.
Using long needle nose pliers compress the pop-fasteners holding the lower corners of the license plate trim panel on, being careful not to let it drop and slide down the vehicle, scratching the paint :)
Testimonial: "Very helpful. thanks"
558 views
Usually answered in minutes!
×