Question about 1994 Chrysler LHS

2 Answers

This alarm goes off and cannot get it to shut off unless i unhook the positive cable of the battery. I am at wits end here i am going to altogether remove this system from my vehicle.

How do i disable the honking noise aside from taking off the positive battery cable

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Using your key, lock and unlike the passenger door look. the little red light inside on your dash signaling the alarm is armed should go off.

Posted on Jun 15, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 132 Answers

Your alarm has a fuse or fallow the posative wire from the modulator the red wire and disconect that from the battery. option 2 call the alarm manufacture

Posted on Jun 02, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Alarm goes off installing battery in Nissan 350Z


Try leaving key in door or ignition turned on to shut down the alarm...

Jun 09, 2015 | 2005 Nissan 350Z

1 Answer

I have a 1998 chysler town & coutry,,i need complite disarmed the anti-thif alarm hoe can i do it


Dealer needs to plug in a computer to reset unless you have the computer key. If you have the key with the chip, unhook the battery, lock and close all the doors. Tap the battery cables together then hook the battery back up and unlock the doors with the key. If you don't, then the alarm will keep going off. Low battery can also trigger the anti-theft system.

Apr 16, 2015 | 1998 Chrysler Town & Country

2 Answers

Car alarm going off after replace positive cable


If you do not have the remote control for the alarm (which can sometimes be purchased on ebay) You will have to uninstall the alarm.
The alarm is wired between the ignition coil wire coming from the ignition switch if the car is turning over and just wont start.
This can be complicated because of the amount of wiring, You have to cut the alarm wires out 1 at a time and match the cars wires back together.
I just did this for someone on a toyota recently and you really have to pay attention or put a peice of tape on each wire writing the color for example(white wire with rd stripe or white wire with red stripe ect.)
I hope this helps you,
Please rate me if this was helpful,
ETRONIC

Mar 14, 2010 | 1994 Saab 9000

1 Answer

Anti-theft alarm goes off, lights flash, horn blares & the van wont crank over even though battery is good . I unhooked the battery for 10 min the 1st time this happened and everything reset & the...


It's going to have to be looked at. But you can try unlocking a different door with the key. Hold it to the left (unlock position) for 2 or three seconds. Should shut off the alarm and allow you to start it.

Feb 25, 2010 | 1998 Ford Windstar

1 Answer

How to unhook my factory alarm.everytime i start car alarm goes off an wont stop unless i un hook battery cable


unlock the driver's side door with the key, then unlock the trunk, then push the automatic unlock for all of the doors, it worked for me.

Feb 10, 2010 | 1997 Volkswagen Jetta

1 Answer

2008 Toyota Highlander alarm goes off for no reason--unhook battery cable to stop it


You most likely have a bad hood latch switch you can unplug this switch until you get it repaired to stop the alarm from going off.
See Toyota TSB
T-SB-0331-08

Nov 04, 2009 | 2008 Toyota Highlander

1 Answer

Alarm and door lock malfunction 1996 Camaro z28 LT1


Hey just wondering if you ever go this problem fixed. I am having the exact same issue. Thanks

Jul 03, 2009 | 1996 Chevrolet Camaro

1 Answer

Anti theft alarm won't shut off


Lock all doors..Then with the key unlock passengers side door then it should stop..

Apr 04, 2009 | 1990 Dodge Dynasty

1 Answer

Alarm reset


Try shutting you door with you in it, lock it and then puch unlock it then you alarm should be reset. If you would like to find your code for your key less code let me know. or change you code,
Nikki2913

Dec 14, 2008 | 1996 Ford Explorer

2 Answers

96 town car wont start


try unhooking battery cable. hook back up and use key remote to unlock car and try to start if no remote use key to unlock

Oct 02, 2008 | 1996 Lincoln Town Car

Not finding what you are looking for?
1994 Chrysler LHS Logo

Related Topics:

287 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...