Question about 1990 Plymouth Voyager

1 Answer

Fuel line leak

The fuel line into my engine is leaking. I don't know if I need a whole new fuel line? It's the rubber hose. 1990 Plymouth Voyager

Posted by on

  • jamiesdork Jun 02, 2009

    I can't get it off

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 142 Answers

Best to replace the whole rubber hose.

Posted on Jun 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Plymouth Grand Voyager having issues starting


i would think that you need to look for a leak, there are rubber hoses attached to your steel lines under your van and in the engine compartment, as well as your fuel pump. start your van with the parking brake applied, and tires blocked, then you can trace your fuel lines out, just remember if you dont see a wet spot that doesnt mean theres no leak, your looking for dry rotted hose. what could be causeing a starting delay could be that its sucking air, and if your fuel pump is under the hood, then the fuel line going from the fuel tank to the front is a suction hose, if you have a fuel pump in the fuel tank the that line is a pressure hose. hope this helps

Aug 11, 2012 | 2000 Plymouth Grand Voyager

1 Answer

How do you remove a fuel pump on a 97 plymouth grand voyager


    • 1 Make sure the engine is completely cool. Relieve the pressure in the fuel system. Disconnect the negative battery cable. Elevate the vehicle and support the fuel tank with a jack.
    • 2 Disconnect the fuel line from the front of the tank. Remove the ground strap, the inboard side fuel tank straps and the front T-strap fastener, then lower the tank approximately six inches.
    • 3 Take the fuel lines from the fuel pump module. Plug the fuel lines with golf tees to prevent the spillage of gasoline. Remove the fuel filter.
    • 4 Install the new fuel filter. Set the bolts in place and torque them to 40 inch/pounds. Tighten the main tank straps to 40 foot/pounds and the T-strap to 250 inch lbs.
    • 5 Reconnect the fuel lines in the reverse order of their removal. Lower the vehicle. Connect the negative battery cable.
    • 6 Start the engine and let it run for several minutes. Inspect the fuel lines for any leaks.


Read more: How to Replace a Fuel Filter in a Plymouth Voyager ' eHow.com http://www.ehow.com/how_4519932_replace-fuel-filter-plymouth-voyager.html#ixzz1WBXAZ7d3

Aug 27, 2011 | 1997 Plymouth Voyager

1 Answer

On my 99 Voyager, 3.0, I have a leak in a pipe that comes from under the fuel injector housing. On the drivers side, the lower radiator hose and a heater hose connect to a pipe that leads to this pipe. The...


You will need a new pipe. You MAY get it out from the drivers side?? If not, you may have to take the intake manifold off. Job is on the line? so you are a mechanic? if not, pay a shop to replace it. I think the dealer is the only place to get a new pipe. I know the pipe you are talking about but never had to replace one.

Nov 15, 2010 | 1999 Plymouth Voyager

1 Answer

I have a 1996 plymouth grand voyager. new spark plug, new starter. when i start it it will crank but will not turn over. if it does the engine runs poorly and it backfires, when i put a little gas, engine...


Backfiring can occur in engines that are running lean because the air-fuel mixture has insufficient fuel (too much air in the ratio) OR whenever the timing is too advanced. On modern vehicles unless the timing chain or timing belt has slipped (not likely) you simply have an air leak that is permitting too much air to enter the motor, causing hard starts and poor driveability, especially at idle. Check for a hole or loose fitting connections in the air duct from the air filter to the throttle body. Make additional checks for holes in the rubber hoses between the PCV valve and the motor (PCV valve hoses run to the intake of the motor). Even small holes or gaps can cause significant issues. if you can't find the leaks with visual inspection and feeling or removal of the parts and replacement, try spraying carburetor around the intake and hoses. If motor revs it means there is a "leak" there letting air into the motor, (bypassing the mass air flow sensor that regulates air volume).

Aug 09, 2010 | 1996 Plymouth Grand Voyager

1 Answer

Wheres the vacuum hose on a 1990 plymouth voyager? i think i have a vacuum leak, car drives fine but occasionally starts idling rough at a stop, it will slowly die on its own but if i press on the gas it...


You need to get the Haynes Repair manual on your vehicle so you have a diagram of the vacum lines attached to your vehicle and where each connects. There is more than one Vacum line.

Jul 12, 2010 | 1990 Plymouth Voyager

1 Answer

Where is the fuel filter on a 1990 plym. voyager. is it on the fire wall somewhere ?


your fuel filter will be in line between the gas tank and the engine. It is usually under the drivers side door. Follow the fuel line from the gas tank to the engine and somewhere along the way you will see a barrel shaped metal object that is about as big around as a golf ball. That is your fuel filter. Be sure to pinch off your lines so you dont leak gas everywhere.

Park up a hill if you can, that usually helps to minimize fuel loss.

Mar 15, 2010 | 1993 Plymouth Voyager

1 Answer

1990 plymouth voyager stalls and I have a hard time restarting when engine is at running temp, Please help


A warm enigine takes more fuel pressure to start then a cold engine. Start by replacing the fuel filter. If that isn't the issue, then you might be looking at needing a new fuel pump.

Mar 04, 2010 | 1990 Plymouth Voyager

1 Answer

Gas line leaks to rear of gas tank


You Will Need to Replace The Flex Hose & Or the "O" Ring inside it.

Jul 28, 2009 | 1992 Plymouth Grand Voyager

3 Answers

Replacing the fuel filter


check under the van on passenger side door track area

Mar 24, 2009 | 1990 Plymouth Grand Voyager

1 Answer

Fuel leak by the gas tank on a 1993 Plymouth Acclaim


check to make sure hose clamps are tightened enough

Mar 16, 2009 | 1993 Plymouth Acclaim

Not finding what you are looking for?
1990 Plymouth Voyager Logo

Related Topics:

156 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7727 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...