Check that the pinion teeth are the same ratio as the flywheel teeth. There are differences in pinions . Check that there is not metal stuck in the flywheel teeth. Check that when the starter is in position it is butted up all the way around the housing and is not misaligned by incorrect mounting bolt tension.
SOURCE: where is fuel pump on dodge ram 50 1988...
If its the same as my 1989 dodge ram 50 it sits on the engine block by the carburator
SOURCE: 85 dodge ram 50 2ltr 4cl 4sp wont start.....i
first thing clean battery connectors an post with baking soda an water solution an a piece of sand paper to get any rust off,keeping cables disconnected,next go under truck to where the starter is,an disconect the battery cable wire from starter an clean with sandpaper to get any debris off,check wires for cracks in the plastic covering,an check all wires leading from starter to battery an selenoid,another solution take hammer an hit starter a few times not to hard then try starting truck if that works it means you have a dead spot in your starter an need to replace it which is not hard.
SOURCE: I Have an 88 dodge ram 50 with 2.0 mitshibishi
2.6lt Ram 50 is your only other choice without a lot more work.
Testimonial: "Thats what I figured but always best to get other opinions. Thanks."
SOURCE: Is there more than three bolts on starter motor 1997 Dodge Ram
No...but there might be a front support bracket
SOURCE: need to replace my starter, 1989 dodge ram d50,
There are no allen bolts on the starter( should not be). They are 9/16 bolts.
83 views
Usually answered in minutes!
×