Question about 1999 Chevrolet Venture

Open Question

How to fix the rear wiper for 1999 Chevy Venture

I just bought the 1999 Chevy Venture and I have problems as follows,

1) When I push the rear wiper button, the wiper move only once and stop after that, any body know how to solve the problem?
2) The water rear windshield only spray little spray, some body mention that i need to clean the pipe, any body know how to do this?

Thank you for your helps in advanced.

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 48 Answers

SOURCE: 2001 Buick Regal LS windshield washer fluid does not spray

There are a number of different issues that could cause this.

-The circuit for the wiper should be the same as the washer; same fuse. -I'd suggest trying to run the washer while the hood is open and the engine off. If it runs, you should hear a dull whine.(a 2nd person might be of use to help look and listen)...(find the pump by following the hoses from the wipers to a unit mounted close to the dashboard in the engine compartment)
-If it runs, check to see if any fluid is coming from a hose that might have become disconnected.
-If the pump runs, and if you see no fluid coming from anywhere, and if you can reach the hose connected to the washer pump, pull that hose off the pump. Try running the pump again to see if anything comes out in a good stream.
-If the pump doesn't run at all, check to make sure the connector hasn't come loose.
-If the pump still doesn't run, check to see if you have 12 volts at the connector at the pump. A simple check can be done with an auto bulb connected to the plug at the motor while the pump switch is pushed.
-If you have power at that point, you likely need to replace the pump and motor.(depending upon the age of vehicle & your mechanical abilities...a call to a local wrecking yard is suggested ..atleast to compare the cost vs. new)

hope that helps

Posted on Oct 08, 2008

  • 78010 Answers

SOURCE: Timing Venture wipers

disconnect the wiper transmission from the motor, then run the motor and turn the motor off with the wiper switch, this will park the motor, re-attach the wiper trans linkage so the wipers are parked/down

Posted on Dec 05, 2008

  • 90 Answers

SOURCE: 1999 Chevy Venture, Windshield wipers stop in upright position

You will need to replace the wiper transmission.This is a common problem.

Posted on Jan 24, 2009

  • 1985 Answers

SOURCE: On a chevy venture one windshield wiper is moving

when you shut the wipers off and the right one return to the park position,move the left one to its park position,at the base of the wiper lift up a plastic cover,you will find a 13mm nut ,you need to tighten that nut up so the wiper will slide down on the spline further.

Posted on Jan 30, 2010

  • 158 Answers

SOURCE: My 2004 Ford Expedition will

chall5031, When you try the washer fluid you should be able to hear the pump operating. Yes, it could be caused by a fuse but sometimes the hoses will break or become disconnected. Open the hood and have someone try the washers. If you hear the pump working, look for any hose breaks or disconnections. If you dont hear the pump working then follow the hoses and find the pump. If you have a test light then test for power at the plug while someone tries to operate the washers. If you have power then the pump will have to be replaced. If you dont have power then check the fuses and wires. Ford doesn't list what fuse is for what at the fuse box so you will have to consult your owners manual for this. Good luck with this.

Posted on May 17, 2011

Testimonial: "Thank you for your help. It appears it is the motor."

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1999 chevy venture, windsheild wipers only work on high , and does not go into park position unless you are close to park position

I would be looking at replacing the wiper motor....the wiper switch is just that, a switch to tell the wiper motor what to do.....most of the wiring is housed internal of the wiper motor such as the park circuit and the speeds........osunds like an internal fault.....replacement would be advised

Feb 21, 2011 | 1999 Chevrolet Venture

1 Answer

How do you know what size window you need for a 1999 chevy venture rear (P) window

You dont need to know the size, window go by the year ,make and model and what glass, so you would tell them the same info you just gave me, 1999 chevy venture rear window pass /side,

Jan 11, 2011 | 1999 Chevrolet Venture

2 Answers

I an '03 Chevy Venture van whose windshield wipers won't go down.

Your windshield arm is in need of repositioning. Take off the cap on the windshield arm and loosen the nut under the cap. Reposition the arm so that it faces 180 degrees flat to the passenger side of the car. Tighten the nut. This should solve the problem you've described.

Apr 11, 2010 | 2003 Chevrolet Venture Passanger

1 Answer

1999 Chevy Venture, Windshield wipers stop in upright position

You will need to replace the wiper transmission.This is a common problem.

Jan 24, 2009 | 1999 Chevrolet Venture

1 Answer

On my chevy 1999 venture the right wiper go off its limite,

GM has a Bad track record with Wiper Motors on ALL their Makes and Models. You will need a New Wiper Motor.

Jan 22, 2009 | 1999 Chevrolet Venture

1 Answer

My back wiper is not working

Of course it could be a fuse.Always start with the cheapest fix.

Dec 16, 2008 | 1999 Chevrolet Venture

1 Answer

Front wiper motor not working

I will give you my honest opinion here. Goto Autozone or any other local parts store and get the Haynes Repair Manual (around $15). Follow the directions in there. Its the best book you can buy for your car and save you alot of money on labor for things like this. I have done a few of these myself and its a decent afternoon project but its easy enough that anyone can do it following the Haynes manual. Good Luck to you.



Nov 11, 2008 | 1999 Chevrolet Venture

Not finding what you are looking for?
1999 Chevrolet Venture Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77947 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides