Question about 1994 Buick Regal Gran Sport

1 Answer

A/C starting cutting out after i replaced the compressor, it was working fine and then the air started cutting in and out now it just puts out hot air. Thinking it could be the relay switch or something else. Open for suggestions.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 142 Answers

Did you vacuum the system when you replaced the compressor?? sounds like you have air and non condensibles in the refrigerant system.

Posted on Jun 02, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The AC keeps cutting in and out?


New compressor? Was it filled enough? High pressure switch could be on it's way out. Especially if it did it before the compressor change. The relay could also be going out. Swap it with another.

Aug 04, 2015 | 1991 Buick Regal

2 Answers

Why ac blowing hot air


start off with the cheap possibilities and make your way threw.
I'd start off with replacing Air Charge temperature sensor, make sure your AC Hose isnt leaking anywhere, if those dont solve it then replace ur AC clutch, last chance would be replacing AC compressor. sometimes the compressor will malfunction randomly. or the AC clutch might malfunction aswell. covering these steps somewhere along the line you will have working AC again! good luck

May 18, 2013 | Volvo V70 Cars & Trucks

1 Answer

My GMC Sierra's air conditioning works great but the driver side vents will spontaneousely start blasting out hot air. The passenger side continuse to blow cold air. If iI turn the truck off and...


  1. Air conditioner system is discharged. Have the system evacuated, charged and leak tested by an MVAC certified technician, utilizing approved recovery/recycling equipment. Repair as necessary.
  2. Air conditioner compressor clutch not engaging. Check compressor clutch wiring, electrical connections and compressor clutch, and repair or replace as necessary.

May 24, 2011 | 2005 GMC Sierra

1 Answer

1999 gmc Jimmy only Blows hot air. Diverter actuator is moving and working. Even when compressor starts all pipes are hot. Check 134A and was low. When put in less than a can the compressor would cycle on...


When recharging the ac you need to recover the old refridgerent. That means you have to take out all the old 134 and replace with new 134. On the engine sticker under the hood should tell you how many pounds of 134 it takes. When put in the 134 make sure your ac is on high.

Jun 30, 2010 | Cars & Trucks

1 Answer

My 2002 Expedition air conditioner will sometimes blow hot air and others cold air


I would check the following possibilities:
1. Is compressor clutch working? - You need to do this when the ac is blowing hot air only - locate compressor drive pulley on engine - rubber belt wraps around it. Start engine and set to max ac. When the ac is blowing hot air, look at the center of the compressor drive pulley using a good flash light - watch it for a while, it should be spinning with the pulley - this means the compressor is engaged. If not, the compressor is not engaged. If your ac is blowing hot air, then the compressor should be engaged and running (trying to cool). If it is not engaged, then your compressor clutch is probably going out. Could be low voltage to clutch, but more likely the clutch is worn out and only working some of the time. Note: if working normally, the compressor clutch will engage and disengage in cycles- but the air should always be cold. If clutch is bad, compressor would need to be replaced (sold as one unit). This is tricky to diagnose and could take some time - you need to do it when ac is blowing hot air but set to max cooling.

2. Low on refrigerant or refrigerant has moisture in it? If your ac blows cold initially after being off for a while, then heats up, and continues to regularly cycle back and forth between hot and cool air, then the system may be low on refrigerant or the refrigerant may have moisture in it that is freezing and restricting refrigerant flow. An a/c shop can check refrigerant level and even replace refrigerant if moisture is suspected.

Could be other issues, but I would start with these.

Good luck

May 07, 2010 | 1999 Ford Expedition

1 Answer

2002 Lincoln LS V6. AC blowing hot air but sometimes it works fine and blows cool. Is it a sensor problem?


its probably the compressor cutoff switch cutting your compressor off at the wrong time and causing your ac to blow hot. that switch is under your hood right on top of the engine easy to get to. I hope that helps you out!

Jul 17, 2009 | 2001 Lincoln LS

4 Answers

03 suburban ac problem


Put a new belt on it and spray the condenser coil in front of the radiator with a hose when it gets up to temp or the sound starts and see if it stops. Thats what I did today. Flapping/clacking stops for about 10 minutes until thing get hot again.A/C blowing cold air the entire time.

Jun 24, 2009 | 2004 Chevrolet Suburban

1 Answer

1998 Jeep Wrangler a/c problem


If you still have freon in it you can try a new low pressure switch. You should find it around the oblong tank. You can unplug the switch and jump the plug to see if the clutch engages. Moderation is the key. Put in the correct ounces of Freon and the system should cycle. Too much freon it will cut out-too little it will cut out. You want the pipes to sweat or frost and the compressor to go off and on. Also be sure you put in an oil charge for that new compressor.

Jun 02, 2009 | 1998 Jeep Wrangler

1 Answer

Ac compressor does not turn on when car has been sitting & it's hot outside. Works fine in the morning.


either the freon charge is about 1/3 low, or the expansion valve needs to be replaced. Freon is getting into the evaporator, but not in great enough volume to cool the air unless it is coming in cool to start with. check your ac charge, and if it is full, then have it emptied, change out the expansion valve, and recharge it

May 14, 2009 | 2002 Jaguar S-Type

Not finding what you are looking for?
1994 Buick Regal Gran Sport Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...