Question about Honda del Sol

1 Answer

Loosing anti-freeeze,heater control valve wet with cooliant

The heater control valve is wet with cooliant,also wet againt fire wall and on top of manford

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 40 Answers

Your heater core is leaking

Posted on Jun 02, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

No heat

- Check the heater pipes routing.
- Heater radiator.
- Heat control valve.
- Control panel.

Mar 08, 2014 | 2003 Mitsubishi Montero Sport

1 Answer

Heater control valv doesnt operate.feels like control valve lever on dash is not hooked up to any thing. fan , defrost, vent etc lever above does work and blower does work but only getting cold air. as I...

Sounds like the cable is disconnected from the water valve. Check under hood at the fire wall where heater hoses connect to heater core. Water control valve should be in one of the two hoses and the cable end should be visible . Water is off when A/C is on.

May 22, 2017 | 1989 Chevrolet G30

1 Answer

Where is the Heater Control Valve in 2005 Ford Crown Victorian? How best to access and change

If its digital A/C heater unit then it's at the top of heater housing inside the engine bay close to the fire wall

Oct 10, 2013 | 2005 Ford Crown Victoria

1 Answer

Where to add cooliant

the coolant reservoir is near the fire wall on the drivers side look near the hood hinge it has a large cap on it

Jul 17, 2012 | 2003 Jaguar S-Type

1 Answer

Need help finding inlet heater hose from fire wall to engine

The inlet going TO the heater core should be the top one (I think) but in any case it would be the one with the heater control valve on it (see picture below) Hope this is what you were looking for....


Mar 05, 2012 | 1998 Lexus ES 300

1 Answer

Location of heater assembly fire wall bolts and how to remove heater core on my 1993 YJ Wrangler?

you will need to remove the heater housing(air box) . the blower is mounted in it. start by removing the control cables (slide your heater controls and you will see them move under the dash),they just snap in careful not to break the plastic tabs. unhook the defroster tube(looks like a corrugated paper pipe in the center and on the top of the housing). unplug the wire harness in the upper corner of the passenger side. now under the hood remove both heater hoses. then remove the four mounting nuts on the firewall [they are 7/16] . one nut is on right side of the just left of the battery. one is under the battery toward the bottom of the firewall.the 4th is by the left rear corner of the valve cover. there may be an accelerator cable loom snapped over this stud,it just pries off. lay a towel or rags on passenger floor to catch any anti freeze. with all 4 nuts now removed,pull the housing away from the may have to tilt the bottom out slightly. once the housing is removed take it to your work bench. There will be a metal panel on the fire wall side of the air box remove the screws to remove this panel to gain access to the heater core. fairly simple,but the nut under the battery can be a pain to get to.

Nov 16, 2010 | 1993 Jeep Wrangler

1 Answer

There is water puddling up on the passenger side floor and actually seems to be coming up thru the floor, nothing leaking down from anywhere.

ok you got some possibles.1 check cabin filter if signs of water than drain plug on fire wall cloged.causing water to enter by over filling and no were to go.but thru the filter.easy fix.also if you losing anti-freeze than that will point at your heater core leaking from line or core itself.need to test it,turn on heater and check floor with a towel. lay it on floor going up to firewall inside truck.go for a good drive so pressure can build and heater on.while engine hot look at floor towel top part by firewall wet prob heatercore.also check if door is wet to eliminate possbility of door seal leaking.let me know.

Aug 13, 2010 | 2004 Chevrolet TrailBlazer

1 Answer

Heater blows cool air instead of warm air

check your coolant level if it is low top it off. if it is full you may need to change your thermostat to get the temp back to normal. for the heat check the heater control valve to make sure it isn't stuck (heater control valve should be located against fire wall connected to heater hose.

Dec 07, 2009 | Dodge Grand Caravan Cars & Trucks

1 Answer

Where is reset button on jagquar

it is located againts the inside fire wall above where your left foot sit towards the top you have to feel for it. its hard to see

Feb 28, 2009 | 1993 Jaguar XJ6

1 Answer

Heater on 99 QX4 does not heat adequately

The Heater control valve that mounted on the fire wall may be at fault some what common on Nissan vehicle. Open valve manually with the lever on top if you get heat replace vale but first chech vaccum house connected to valve for vaccum. Good Luck

Dec 12, 2008 | 1999 Infiniti.5 QX4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

163 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides