Question about 2005 Ford Freestyle

1 Answer

Keyless remote wont work

After my battery went dead. I put a new battery in my 2002 Ford Explorer and now my Keyless remote will not work?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 93 Answers

Try to reprogram the remotes using these instructions..........
i assume for 02 explorer not th 05 frestyle listed (although similar procedure)
Remote Transmitter Programming NOTE: All remote transmitters are programmable and must be set at the same time.

  1. Make sure that the anti-theft system is not armed or triggered and key code programming is not active.
  1. Open the door, then press the driver door lock control switch UNLOCK button.
  1. Turn the key from OFF to ON 8 times within 10 seconds, with the eighth turn ending in ON. If the program mode is sucessfully entered the doors will lock and unlock to confirm.
  1. Press any button on a remote transmitter, and the doors will lock and then unlock all doors to confirm that the remote transmitter is programmed. All remote transmitters must be programmed within 20 seconds of each other. Up to four remote transmitters can be programmed to the vehicles security module each time programming mode is entered.
  1. If the door locks do not respond for any remote transmitter, wait several seconds and press the button again. If the door locks still fail to respond, refer to Locks, Latches and Entry Systems — Late Build or Locks, Latches and Entry Systems — Early Build in this section.
  1. NOTE: Exiting is acknowledged by locking and unlocking the doors if at least one remote transmitter has been programmed.
    Exiting the programming mode is accomplished if one of the following has occurred:
    • The key transitions to OFF.
    • 20 seconds have passed since entering programming mode or since the last remote transmitter was programmed.
    • Four remote transmitters have been programmed.

Posted on Jun 02, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I reset my car alarm for 2002 ford explorer? replaced battery and now the alarm wont turn off


With your remote unlock the door if you dont have a remote with your door key unlock the passager door and the rear hatch

Mar 10, 2015 | 2002 Ford Explorer

1 Answer

Keyless entry remote doesn't open doors anymore on my 05 ford focus


Sounds like the contacts in the buttons are not making contact.. you may want to try taking the remote apart and cleaning the contacts and seeing what happens. If the remote is truely dead you may need a new remote

Feb 01, 2015 | Ford Cars & Trucks

1 Answer

Keyless Remote Activation


The remote batteries are dead and need replaced. Most remotes are held together with clips or screws and are easy to open if done carefully. Then replacing the batteries is easy and put remote back together.

Jan 23, 2014 | 1996 Ford Thunderbird LX

1 Answer

95 ford explorer battery went dead due to lights being left on, now keypad doesnt work


try closing and locking all the doors then unlock the drivers door with the key

Feb 26, 2012 | 1995 Ford Explorer

1 Answer

I have an 2002 vw gti 1.8T. Last night my alarm went off. when i went down stairs to look at it. the light on the door was no longer blinking but the doors where locked. so i tried to unlock the door with...


the button in the fob may be stuck connecting the circuit, remove the battery and reconnect if the alarm goes off again it could be because of this.

Jul 10, 2017 | 2002 Volkswagen GTI

2 Answers

My battery went dead now my radio wont work


hello duk.... Often when the battery is disconnected on newer vehicles you need a code to reactivate the radio. Call your local Ford dealership for this code. Joe

Thanks for choosing Fixya!

Dec 16, 2010 | 2002 Ford Explorer

1 Answer

My 2002 ford explorer wont start. lights come on


first thing to check is the battery and the connections at the battery. if all this checks ok then you should try and look at the fuses for the ignition system. this should get you going in the right direction.

Oct 23, 2009 | 2002 Ford Explorer

1 Answer

KEYLESS REMOTE FOR 2004 FROD EXPEDITION NOT WORKING, DID THE RESET FEATURE AND STILL DOES NOT WORK ANY OTHER SUGGESTIONS?


Replace the battery. If that does not work, you can re-program it with another remote if you have one. If this is the one and only remote you have, you probably will have to take it to the dealer to have it reprogrammed.

Jun 23, 2009 | 2002 Ford Explorer

1 Answer

2002 ford explorer gauges do not work when car is running, also keyless remote does not work


fuse or relay issues or fusible link and battery in remote may need replacing

Jun 14, 2009 | 2005 Ford Freestyle

Not finding what you are looking for?
2005 Ford Freestyle Logo

1,154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...