Question about BMW 535

1 Answer

My car won't start, dealer said battery is dead, but i'm still able to use the horn, signal lights, and remotely open the car, and trunk.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 145 Answers

The starter takes @180 amps to turn the motor over as compared to 5-10 amps for horn and lights

Posted on Jun 02, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tried to start car- message trunk open. removed keys closed trunk tried to start car- everything is dead!


THAT IS ODD UNLESS THE TRUNK HAD BEEN OPEN/ CAR SITTING & WEAK BATT DRAINING W ELEC SHORT. NO PUN INTENDED! OPEN THE TRUNK & TRY AGAIN., DONT THINK IT WILL, BUT IF NO START CK BATT CONN , BOOST.& HAVE BATTERY ,ALTERNATOR CHECKED ALONG W/ PROPERLY HAVING IT CKD FOR ELECTRICAL SHORTS. if IT WAS SITTING AROUND A WHILE WITH THE TRUNK AJAR,CLOSE THE TRUNK BOOST IT, RUN IT TO RECHARGE THE BATTERY BY ITSELF (20MINS) SHUT IT DOWN, RESTART CK LIGHTS,HORN, ETC. ALL WELL YOU GOOD TO GO. NO START AGAIN THEN THERE'S AN ISSUE W/ THE BATTERY & POSS AN ELEC SHORT.. GOOD, FRANK M

Feb 15, 2016 | 2011 Dodge Avenger

1 Answer

2010 escape remote start horn chirps


battery in remote is dead, contact ford dealer

Oct 30, 2014 | 2010 Ford Escape

1 Answer

2003 lexus ls430 wont start


your battery is low . You must need to load see the diagram se2ecbaae-396f-420d-9264-d2f8b001071a.jpg722bfa4f-f46b-46e9-9cce-a8c49e9d358c.jpg3e216f2d-c8a1-4afd-9c9a-ff99dc661e07.gifattached.
God bless you

Jul 28, 2013 | Cars & Trucks

1 Answer

Remote won"t start car


first off all doors hood and trunk have to be locked or closed. the check engine lamp must be off. hold down the lock button and while holding lock press your rvs button the turn signals should blink letting you know the request has been made and car should start. Also make sure you have a good batt in the remote. a weak one will cause erroneous signals and the receiver may think ur are tryin to do something else

Nov 29, 2011 | 2006 Pontiac G6

1 Answer

2006 Hyundai Tucson Car - the battery is totally drained & dead so it wouldn't open with the remote opener. Now that we used the key when the car starts to get battery power back the alarm sounds...


this is for honda acura but it also might work for you too.
Open hood ensure new battery is disconnected.
Open main fuse panel cover under hood and remove horn relay (so you don't have to listen to the horn).
Use the key to lock the drivers door.
Connect the positive battery terminal.
Connect the negative battery terminal (security system will now activate, hazards lights will flash and horn would be going off if the relay was not removed).
Use the key to unlock the drivers door.
Get in, close drivers door.
Use the key to start the engine.
Security system will deactivate.
Get out of vehicle, reinstall horn relay, replace fuse panel cover, close hood.

Oct 15, 2017 | 2005 Hyundai Tucson

1 Answer

My battery goes dead on my 1996 Lincoln Mark VIII overnight. I found that the lights come on by themself after I park the car. There is a clicking sound coming from the security module in the trunk when I...


security module in the trunk ???? There is no security module in the trunk . What light's come on by them self ? Park lamps , headlamps , brake lamps ,turn signals etc.... The module for anti-theft is under the right hand side of the dash . The remote keyless entry module is located in the trunk. Is this the part you hear clicking in ?
Door Lock Control Processor, Electronic NOTE: The electronic door lock control system will not function when the ignition switch is in the RUN or ACC position.
The electronic door lock control processor:
  • is located on the LH side of the luggage compartment.
  • contains a radio receiver that receives a signal from the keyless entry remote transmitter (15K601) through electronic door lock control processor antenna, and sends the appropriate command to the power door locks, the horn relay, the indicator flasher, or the anti-theft warning system.
  • is equipped with a battery backup which holds the programmed code in memory in the event the vehicle battery is disconnected.
    • Doors Do Not Lock or Unlock Using Keyless Entry Remote Transmitter
    • Circuit.
    • Electronic door lock control processor.
    • Keyless entry remote transmitter.
    • GO to Pinpoint Test B .

Aug 17, 2017 | Lincoln Mark VIII Cars & Trucks

1 Answer

I bought a new Keyless remote for a 2007 Forester from a Subaru Dealer to replace an original one that went bad after 2 years. I have followed the directions in the owner's manual to program it, but can't...


IMPREZA: 2005, 2006, 2007 and
FORESTER: 2005, 2006, 2007, 2008
Check for Immobilizer key on Forester XT models only.
information is always subject to change and correction imp05keylessremote1.jpg
new remote for 2005 Imprezas.
This is not the same remote as the 05 Legacy/Outback remote which also has truck/gate release on the front and a red panic button on the back.
Lock: press Lock button for 2 seconds or so to lock car, and arm optional security system. The car with chirp once and turn signals flash for locked, 5 short chirps and signal flashes if any door is not fully closed. The dome light goes on for 15 seconds and ignition key ring (if present) will light for 30 seconds when unlocked.
Unlock: press unlock one time for driver's door, press again within 5 seconds to unlock all doors inkling rear gate (wagon). The system does not open the trunk.
Panic mode: press and hold lock button for approx. 3-4 seconds to activate Panic mode. I panic model the horn honks and turn signals flash until either the lock or unlock button is pushed again.
Finder mode: Press lock button 3 times within 5 seconds to activate Vehicle Finder mode. The horn will honk once and the turn signals will flash 3 times
Distance: works within approx. 30 feet depending on battery strength, nearby concrete walls and etc.
Audible Chirp On-Off: the system will chirp when locked or unlocked. To turn OFF the chirps, unlock the door and then push both lock and unlock buttons at the exact same time for 2+ seconds. There will be 2 chirps indicating the the audible is off. To turn the chirp back on, repeat the process and the system will chirp one time when it is back on.
Battery: as the battery ages it will only work as you get closer to the car. When a battery is replaced, the transmitter must be re-synchronized with the Keyless control unit. To synchronize, press the lock or unlock button 6 times.
Programming: 4 codes may be programmed.
Sit in driver's seat and unlock all doors. Open and close the driver's door
Turn the ignition key from LOCK to ON position 10 times within 15 seconds. Be sure to stop at both lock and on. The horn will HONK once to indicate transmitter programming mode is activated. Leave key in LOCK position and don't remove it from ignition.
You now have 45 seconds to complete the programming as below.
Open and close driver's door again.
Push either lock or unlock button on the remote you want to program. The horn will honk 2 times when successful.
To continue and program other remotes at the same time: open and close the driver's door and push lock or unlock on the remote. The driver's door must be opened and closed between each remote you want to program.
Done programming? remove the key from the ignition and the horn will honk 3 times.
DELETE old codes? Reprogram 4 times, it will overwrite old codes.
Alarm Security System: optional on all models. When locked there is one chirp (can be turned off, see above), the turn signals will flash and the red 'security' light will start to flash once every 2 seconds except for STi which flashes twice every 2 seconds.
There will be 5 chirps if a door, hood, and trunk or gate is not fully closed
You can also arm the system by using the power lock button on the driver or passenger door as you get out of the car and then closing the door behind you.
Disarm the system: push unlock for 2 seconds
Lost remote, alarm activated? When you can't use a remote to turn off the system: open the door with a key or try to start the car and the horn will start to honk. Turn the key on-off 3 times within 5 seconds and the alarm will go off and you can start the car. It's simple!
VALET mode: To set valet mode or just to disable the security alarm system: 1. unlock all doors 2. physically open the driver's door 3. hold the UNLOCK button on remote for 2+ seconds. The red 'security' light will then flash 2 times a second until the car is turned on.
System has been Tripped (except for STi): if you unlock the door with the remote and it chirps the signal light flash 4 times, the system has been triggered;
Identification mode: To find out what happened and why the system was triggered:
Open and drivers door, leave it open. Turn ignition key from LOCK to ON 2 times and then leave in LOCK position.
Tripped code: 1 security light flash: a door has been opened, 3 flashes when the impact sensor was triggered, 4 flashes when the ignition was messed with or battery disconnected

Nov 19, 2009 | 2007 Subaru Forester 2.5X L.L. Bean...

2 Answers

I have a 99 camry the went dead and i tried to jump it the horn blows good the head lights comes on but when i turn the key it says nothing the dash lights doesnt come on its like its not getting any power


There could be several reasons for your problem:
  1. Check your connections for tightness and corrosion. A corroded battery cable/post will diminish the current going to the dead battery.
  2. Check jumper connections
  3. Dead battery; the worse off the battery is, the more time it will take to charge the battery sufficiently enough to start the car; a completely dead battery with bad cells will never recharge sufficiently enough to hold a charge and start the car on a regular basis
Hope this answers your question. Best of luck.
Greg

Sep 04, 2009 | 1999 Toyota Camry

1 Answer

Locked Out!


the hood should stell open no matter what un less the cable is broke i have the same car all that happens when the alarm is set off is the horn blows and the lights flash it doint stop the hood from oping

Sep 07, 2008 | 1990 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers

Frankie B

Level 2 Expert

65 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...