Question about 2002 Chrysler Town & Country

1 Answer

FAN DOES NOT BLOW AIR OUT ON LOWER SETTINGS ONLY ON HIGH

WHEN YOU TURN ON THE HEAT OR AIR , YOU HAVE NO AIR BLOWING ON THE LOWER 3 LEVELS , YOU HAVE TO PUT IT UP TO HIGH FOR HEAT OR AIR, WHICH MEANS YOU HAVE TO RIDE WITH THE FAN ON HIGH AT ALL TIMES TO HAVE ANY COMFORT , NONE BLOWS OUT ON LOW SETTINGS

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 6,674 Answers

Need a new blower motor resistor. Check under hood on firewall, on passenger side under cowl, behind strut tower area is usual spot. If not may be on housing/ducting under dash on passenger side near blower motor.

Posted on Jun 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 2009 Nissan Quest I can't turn the heat off. Just stays on a high level of blowing out heat .


If you have a fan that has different speed settings (1234, or low med high etc) and the only one that works is high - then the blower resistor pack has failed. If you have a climate control unit (where you just pick a temp you want) then the fan is controlled by the heating system and it sets fan speed. If you have climate control style try lowering the temp to a lower setting (current temp in vehicle) and see if fan slows down. If not then climate control unit or fan resistor bad. If dial type and you get nothing on lower settings (only high works like mentioned above) you need to change blower resistor. It is located under dash near the fan itself. Look for small unit bolted in duct near fan with wire plug going to it.

Feb 23, 2015 | Nissan Cars & Trucks

1 Answer

2007 Yaris Air/ Heat Barely Blowing


If the motor is running, and you just can't feel the air it may be that when the filter was changed something fell in and is blocking the airflow. If on the other hand the fan motor is not blowing at all you likely have a bad switch or motor.

Apr 21, 2014 | 2007 Toyota Yaris 1.4

2 Answers

Kia Sedona- center and third row heating vents blowing cold air


There is a separate button on the lower dash labeled RR HTR for the rear heater. If you do not engage the switch it will blow cold air.
kia-sedona-center-third-row-heating-ir03o0ur3ff3pxc4zrfsqvc4-3-0.jpg

Nov 13, 2013 | Kia Cars & Trucks

1 Answer

Air/heat not blowing from vents, can feel the heat but it's not blowing, I turn the knobs to high blow and it won't do anything, its cold outside,


if the fan does not increase speed as turned up replace resistor assembly usually in heater housing under dash.if doesn,t nave separate resistor assy.it is the fan switch

Feb 11, 2011 | 2002 Buick Century

1 Answer

My ac/heater fan stops blowing then it blows sometimes? The air is still cold just not blowing out. when it does blow it is cold.


replace fan speed resistor block if this only happens on lower fan settings if it happens on high fan speed also, replace blower fan

Jan 20, 2011 | 2001 Isuzu Trooper

2 Answers

2003 trailblazer I have no heat or air coming out of my dash vents


Is it no heat/air when sitting still, or no heat air period? If the heat and air blow slightly when driving you have a bad blower mower/resisitor and its not allowing the air to blow into the cab. If not blowing period when moving probably bad heater controls or fuse... Worst case scanario is you have an electrical problem that needs to be diagnosed

Jul 15, 2010 | 2003 Chevrolet TrailBlazer

1 Answer

Blower for ac/heat only work on lower 3 levels.


Check the blower motor resitor. Use a 12v test light at the switch and notice the bulb brightness change as you switch settings.. Probably have a bad blower resiter.

Jul 07, 2009 | Chevrolet Blazer Cars & Trucks

1 Answer

The AC blows on #4 fan setting but doesn't blow at all on 1-3


That is the blower resistor. 4 is wide open, so, no resistance. I had 4 of them put into my truck. The wires were burnt and shorted the others until the problem was found. Check the plug if you do this yourself.

Jun 13, 2009 | 2005 Chevrolet Colorado

1 Answer

Fan won't blow on levels 1, 2, and 3 but will on 4 and 5


you need a blower motor relay under the pass side of dash

Mar 09, 2009 | 2002 Chevrolet Malibu

2 Answers

2001 monte carlo 3.4


Have you tried the heat also? If neither blow out, chances are it's the resistor on the blower motor. Mine went out in my 2001 Monte Carlo about two weeks ago and sure enough it was the resistor! The part runs around $35. Installation will vary depending on where you take it to.

Hope this helps!

Aug 04, 2008 | 2001 Chevrolet Monte Carlo

Not finding what you are looking for?
2002 Chrysler Town & Country Logo

397 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...