Question about 1990 Nissan Pulsar

Open Question

Own a 96 Nissan Pulsar / Lucino, I have removed all obvious screws to try and be able to remove stereo but still the plastic cover wont come off dashboard area which 'covers' the stereo - I cant find any owners manual anywhere - can anyone help?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

DR NITIN
  • 221 Answers

SOURCE: i put a new head gasket on my nissan oulsar..the engine is a ga15 what are the head bolts torque down to

Goto Service Center and you'll have the Latest Information.

Posted on Jul 14, 2008

fischmilch
  • 96 Answers

SOURCE: Fuel Guage Problem on Nissan Pulsar N14

Either the sending unit in the tank is bad, or the gauge is bad.

Posted on Mar 09, 2009

co7196
  • 3433 Answers

SOURCE: Dashboard lights not working

No insult intended, but are you sure the lights on dash aren't just dimmed out? I fell for that one when it went through the car wash. Wiping down everything one of them rolled the dash dimmer. Good luck. And that inj looks like an abreviation for injector. That needs to be looked into cause something or an injector is shorted. good luck

Posted on Jun 03, 2009

heavymetal77
  • 721 Answers

SOURCE: How do I remove the removable rear hatch?

Yea it does come off. I forget exactly how,kinda old & probably rotted enough to fall off,but if you insist.You raise the lid all the way & pull some pins out for the hinges & remove the gas struts that hold it up. There may be an electrical wire to disconnect too. Try the dealer for the exact instructions. Nissan will be around for many years unlike the American car makers.

Posted on Jun 28, 2009

  • 1 Answer

SOURCE: Hi there, we are trying

carefully chip away the plastic or get it cut out even..and put in the new seals and apply some silicone and let dry properly

Posted on Oct 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wiring diagram nissan n15 2000


I need the stereo wiring diagram for 96 pulsar please....

Sep 23, 2013 | Nissan Cars & Trucks

1 Answer

96 nissan maxima rear drivers side seat belt wont entend and makes clunking noise


only one answer here and thats to renew it and they are not cheap even from a scrapyard ,now if your carefull on the seat belt housing behind the panelling ,with it removed one side has a spring behind the plastic cover and the other side has a ball bearing in a plastic pendulem carefully remove the pendulem and it will work good enough for the inspection and it will still work in a accident but it will not lock up going around a bend .So i havent wrote this in case someone tries sueing me .

Feb 27, 2012 | 1996 Nissan Maxima

2 Answers

I need to replace plastic on the tail light of a 1990 pulsar hatch and cant see how to get the old one out, there seems to only be one screw holding it?


The fasteners may be behind the interior panel of the hatch. Take the one screw out, and if that doesn't release the light, then look for the interior fasteners.

Jan 03, 2011 | 1990 Nissan Pulsar

1 Answer

Trying to remove the cover over the gauges to replace the stereo in a 87 ford ranger


there is plastic trim in the middle of the complete dash,between the metal bottom and the dash pad,it just pops right off, remove the ashtray,you will see 4 screws directly under the section you trying to remove,remove them,now above the gauges,and above the stereo, and under the dash pad you will see ,i think 5 or 6 screws, remove them,now take a putty knife or straight screwdriver ang get under the plastic on top, carefully pry down and pull towards you, once you get it pulled out, pull it up out, just be carefull..it is plastic and will break..

Oct 03, 2010 | 1987 Ford Ranger

1 Answer

How do you remove the original stereo in a '97 nissan 200sx?


There's a plastic bezel around the stereo and climate controls. Next to the hazard switch is a blank panel. Behind that blank is a single screw, once out the bezel comes out and the stereo is easily removed.

Aug 18, 2010 | 1997 Nissan 200SX

1 Answer

I own a 1993 nissan pulsar, i think also known as...


Have you checked whether you removed the screw door handle? It's accessible when you pry off the plastic of the door handle carefully..

May 17, 2010 | Cars & Trucks

1 Answer

Remove door panel on 97 nissan maxima


remove screws - they is probably one around the door handle (carefully pry out cover piece) - and underneath any big round (1 inch diameter) plastic screw hole cover - then carefully pry off.

Jan 19, 2010 | 1997 Nissan Maxima

1 Answer

How do you remove a dash out of a 1986 Nissan truck?


You must first disconnect the battery cables.
Then you begin work from the driver's side with a 4-corners screwdriver, palm-type and 6-inch long.
Remove the screws holding the speedometer.
Open the doors and locate the screws holding the dash to side of frame.
In the gearbox areas are screws holding the center console panels to frame, remove as well.
Use flat-end screwdrivers to remove the snap-fit plastic panels.
Open the glove compartment and remove its screws holding it up. Then lift it out.
Continue to locate/remove the screws holding the dash to frame.
Pull out the radio knob, and unscrew the stereo from the sides.
Reach behind stereo to unplug its wires, and disconnect antenna cable.
Unscrew the speedometer screws, and unplug their wires from behind.
Lightly shake the dash and see which screws remain. Remove as necessary.
Reverse this procedure to install back the dash.
I'd recommend getting a reapair manual such as Hanyes to due to the complexity of arrangements of parts.

Nov 25, 2009 | 1986 Nissan Pulsar

1 Answer

Want to do my own service on a 1997 nissan pulsar lucino SRV


First off go to autozone and get a book for your car.

Nov 24, 2009 | 1990 Nissan Pulsar

2 Answers

89 Pulsar Headlight


you need to replace it from the back, if its not accessable try removing afew things if not remove the entire headlight as it must be fitted from the back.

May 23, 2008 | 1989 Nissan Pulsar

Not finding what you are looking for?

Open Questions:

See all 1990 Nissan Pulsar Questions

1990 Nissan Pulsar Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...