Question about 2001 Jeep Cherokee

2 Answers

Where is the crankshaft sensor located in a 2001 jeep cherokee sport?

Posted by on

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 6,784 Answers

Your sensor is located next to the crankshaft pulley. it is halfway into the block and, the housing will have wire clips protruding outwards. it should be around the top left or right side of the pulley.

Posted on Jun 01, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Jeep Master
  • 75,814 Answers

Look just behind the down pipe of the exhaust manifold. right at the 2 o'clock position of the bell housing top on a 4.0 when looking at it from front of the car, yes its behind the lip at the hardest place to get to. or access from under the car.

Posted on Jun 01, 2009

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 10 Answers

SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997

left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,

Posted on Jun 13, 2009

  • 285 Answers

SOURCE: crankshaft sensor located 98 jeep grnd cher 4wd 6cy

it is located at the back of the engine on top of the transmission bell housing,the plug runs over to the passenger side of the engine bay and it comes out from behind the engine,you can actually get your hand on the sensor itself from under the hood on the drivers side,and i believe its a 13mm bolt holding it in,the new sensor will have a sticker on the end of it...leave it there,it is used for correct spacing between the sensor and the flywheel,hope this helps

Posted on Sep 23, 2009

Testimonial: "Everything was just like you said but as a not atleast for my jeep it is an 11mm not 13mm. Works great so far (keep fingers crossed) "

  • 5 Answers

SOURCE: My 1996 Jeep Cherokee Sport dies or will not start when hot.

Sounds like the ignition coil is getting bad.

Posted on Jan 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the css819 sensor located on a 1997 jeep Cherokee Laredo and how do I change it


Check the attached links,
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info

1997 Jeep Cherokee Sport Crank Sensor Replacement

Crankshaft Position CKP Sensor Removal

Mar 06, 2016 | Jeep Cars & Trucks

1 Answer

Where are the oxygen sensors located on my 2001 Jeep cherokee sport?


oxygen sensors are always located downstream of exhaust manifold. theres the primary and secondary oxygen sensors. the primary is located before the catalytic converter and the secondary is located after the catalytic converter.

Aug 29, 2014 | 2001 Jeep Cherokee

2 Answers

No spark on a 1998 Jeep Cherokee Sport w/ 4.0L


Have you checked the computer for trouble codes ?
Could be a long list - pickup module, coil, ignition module, distributor, rotor, power relay, etc.

Jun 28, 2012 | 1998 Jeep Cherokee

1 Answer

Locate crank shaft sensor on 1998 jeep grand cherokee


4.7L ENGINE CRANKSHAFT SENSOR LOCATED ON THE ENGINE BLOCK ABOVE THE STARTER. ON THE 4.0L ENGINE CRANKSHAFT SENSOR LOCATED TRANSMISSION BELL HOUSING AT THE LEFT REAR OF THE ENGINE. THE 5.2L 5.9L CRANKSHAFT SENSOR LOCATED ON THE ENGINE BLOCK BEHIND THE RIGHT CYLINDER HEAD.

Nov 26, 2010 | 1998 Jeep Grand Cherokee

2 Answers

Where is locate the camshaft position sensor on 2001 jeep grand cherokee laredo limited 4.7 l


The camshaft position sensor is located inside the distributor. It is a hall effect swich, simply remove the distributor cap and the rotor and you can lift it out, unplug and replace.
Have fun but beware a bad crankshaft position sensor can cause a false cam sensor code to be set sometimes.
Good luck.

Dec 05, 2009 | 2001 Jeep Grand Cherokee

1 Answer

I have 2001 jeep grand cherokee 6cyl need


On the top of the bellhousing. From the drivers point of view it is in the 11:00 o'clock position. The harness wraps around the back of the bellhousing and plugs in on the passenger side of the block near the oil sending unit.

Oct 25, 2009 | 2001 Jeep Grand Cherokee

2 Answers

Where is the crankshaft position sensor located on a 1996 Jeep Cherokee Sport? Is there a website with removal and installation instructions?


i acn give the position of the crankshaft
it is located on the rim of the bell housing at 11:00 if you are facing front, 1:00 if you are standing in the front looking back.

Jun 14, 2009 | 1996 Jeep Cherokee Sport

1 Answer

Tried to hook up computer to get diagnosis and read error


have you checked your crankshaft position sensor. they tend to go out pretty regularly

May 20, 2009 | 2001 Jeep Cherokee

1 Answer

In my 1996 jeep cherokee sprot i have a problem with starting my car after i have been driving it i dont know what it could be the cam positioning sensor? getting to hot and sometime it will just die


The crankshaft position sensor located @ 11:00 on the rim of the bell housing from the driver position. seems to be a very common problem on the Cherokee. They cost between $70 and $80. or $250 installed.

Mar 28, 2009 | 1996 Jeep Cherokee Sport

Not finding what you are looking for?
2001 Jeep Cherokee Logo

Related Topics:

234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...