Question about 2004 Volkswagen Passat

1 Answer

Check engine light comes on even though i replaced the faulty camshaft senors

The radio will not even turn on to safe mode so that I can enter the security code. Everything but the radio works fine. Fuses are fine as well. just replaced camshaft sensors on my 2004 6cyl passat. but the check engine light comes on, the code indicates that the camshaft sensors are faulty but i just replaced them, now my radio doesnt work what can i do anyone

Posted by on

  • neil Dec 18, 2013

    you need to turn on ignition for 1 hour so radio resets itself, that is in the radio operating manual supplied with the car.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Volkswagen Master
  • 14,036 Answers

Take it back to shop because.some of the 2.8 v6 passat had 2 cam sensors.one for right bank and one for left bank.if shop already replace them.they need to remove code from computer.

Posted on Jun 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine speed sensor


are you sure it was the speed sensor.... speed sensor fail will also affect the abs.... now cam or crank sensor will put engine in limp mode.

Nov 29, 2013 | 2002 Nissan Sentra

1 Answer

2006 Cobalt 2.2 litre has check engine light come on, then "engine disabled"


That code dsoesn't 100% mean the sensor is defective, other factors can set it. See list below.
Possible causes- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty Camshaft Position Sensor
- Faulty starter motor
- Starting system circuit
- Dead (Weak) battery
P0601 CHEVROLET - Power Control Module Internal Fault

Cause: Faulty PCM. (Powertrain control module)

Jun 14, 2012 | 2006 Chevrolet Cobalt

2 Answers

P0011 code


If it keep reading camshaft need replacing,what does the mechanic needs to look for to repair the promblem.

Nov 28, 2011 | 2006 Chevrolet Impala

1 Answer

Smart car keeps cutting out whilst driving


If all power is lost in the car, it could indicate a bad battery connection, bad wiring, or loose main wire harness, etc.

If a warning light comes on - it may be going in to Safe Mode.

Safe mode is the set of parameters that the car will use if it believes there
is a fault with the engine that could cause irrepairable or long term damage.

Generally it is an excess in expected boost pressure entering the engine.
This excess boost from the turbo tends to happen for 4 reasons.

The boost pressure sensor (MAP sensor) is faulty.
The wastegate is seized shut or slightly open.
The wastegate actuator is faulty.
The air line to the wastegate actuator is damaged or off.

Obviously, if the sensor is faulty, it will tell the ECU lies about the boost pressure.
If the wastegate assembly fails in any way it will fail to open to bypass the turbo.
The turbo will continue to spin up, increasing the boost pressure, causing the fault.

Initially I would suggest disconnecting the battery for 5 minutes (make sure you know your
radio code before doing this), this will turn safe mode off and your car should run normally
again. Drive home with a bit of care, you may find the car might never do it again. If it does
go into safe mode again, you know you have a real problem and not just a glitch.

Best to contact your dealer and have it checked out.

Nov 03, 2011 | Smart fortwo Cars & Trucks

2 Answers

Have 100,000 miles on Passat. check engine light keeps coming on. Had fuel filter changed, throttle plate, but engine light back on. Now they think it may be fuel regulator near manifold. Car runs...


Have the PCM scanned, you are about due for a timing belt replacement. If it shows camshaft or crankshaft corralation error them you need to replace it very soon.

Jan 17, 2011 | 2001 Volkswagen Passat

2 Answers

Misfire in two cylinders


Check to see if the two cylinders misfiring are on the same coil pack. If so, change the coil pack in question.

This happened to me on 1997 Cadillac Deville Limousine.

Also, check for a blown head gasket with compression test.

Jul 04, 2010 | 2001 Oldsmobile Aurora

1 Answer

Changed battery in 2004 VW Passat - radio is completely dead


there is another fuse at the back of the radio. if that fuse is ok check if there is power comeing to the radio if there is u will need a new radio

Apr 10, 2009 | 2004 Volkswagen Passat

1 Answer

1997 Jetta will not start with abrand new battery!


Dont have a clue about the hazards but the connections on the starter could be bad

Nov 03, 2008 | 1997 Volkswagen Jetta

Not finding what you are looking for?
2004 Volkswagen Passat Logo

537 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...