An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: no money! need key code 1990 buick lesabre
Contact your local Ford dealer. They may make you tow the car in or just provide proof of ownership (registration, bill of sale etc) that has the VIN number on it. They can find the right key with the VIN. Hope this answers your question. Best of luck.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I would ask a buick car dealer. Someone in the service dept should know. Maybe one day you could just drop by there, go to the service dept and ask the guy at the service desk. He can pull out a service manual and in about two min. tell you everything.
30-Minute Learn Procedure 1. Turn ON the ignition, with the engine OFF. 2. Attempt to start the engine, then release the key to ON; the vehicle will not start. 3. Observe the SECURITY tell tale light. After approximately 10 minutes, the light will turn OFF. 4. Turn OFF the ignition switch, and wait 5 seconds. 5. Repeat steps 1 through 4 - two more times - for a total of 3 cycles of 10 minutes. 3x10 = 30 minutes. The vehicle is now ready to relearn the Passlock Sensor Data Code and/or passwords on the next ignition switch turn from OFF to CRANK Important: Turn the Ignition Switch OFF. The vehicle learns the Passlock Sensor Data Code and/or password on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle. 6. Start the engine. The vehicle has now learned the Passlock Sensor Data Code and/or password. 7. With a scan tool, clear any DTCs if needed. History DTCs will self clear after 100 ignition cycles. Without a scan tool you may have momentary starter interruptions while history clears itself. Good luck and hope this helps, keep me posted, be glad to help.
dont know what the code are w/out looking them up however i do know that is a common problem when ignition coils or 1 ign coil goes bad. or distributor shaft wears out, which i dont think 92 buicks have. your 92 buick should be ign. coils . ignition coils need tested at a auto part store.most are free test call them to make sure.
I had the same problem with my 89 Buick Le sabre. It turned out that I had to replace the computer. It was giving the wrong signals and cutting off the fuel. My engine light came on each time it happened. Since the computer was changed it has run like a charm. It cost about $500.
Also when they ran the tests for the eng light data the computer was giving the wrong info and so many of the wrong parts were first replaced.
Can I please have a bit more detailed description of exactly HOW it won't start does it not turn the engine over?
Does the egine turn over and just won't start?
Does the starter "click" or do nothing ?