Question about 1983 Chevrolet Monte Carlo

1 Answer

Need to remove window knob from 1979 monte carlo.

I'm trying to remove my door panel on my 1979 monte carlo I need to know how to remove the window knob to complete removal.Thanx

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 181 Answers

Getting to be an old vehicle now days. The mount that the window knob mounts on is usually a star type gear that the handle is pushed onto. There should be a very small hole in the round part of the handle that an allen set can slide into. Then loosened the hanle should pull off the star gear. Once the handle is removed the inside door panel should easily pull out over the gear.

Posted on Jun 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2002 chevrolet monte carlo drivers side window will not go back up. what are the posssible problems?


I believe if you hold the widow button in just the right position it will go back up. You need to remove the door panel and see if your window buttons are aligned right. I don't think it is a short.

Jun 17, 2014 | 2002 Chevrolet Monte Carlo

1 Answer

1999 monte carlo passenger power window


Sounds like your window is off track. You will have to take door panel off to get to it. Fairly simple to do once you remove the panel.

Oct 22, 2012 | 1998 Chevrolet Monte Carlo

1 Answer

2004 monte carlo heater door actuator replacement


This job requires the complete removal of the dash from the car and dis-assembly of the duct work to replace the blend door. You must have a factory manual to have any chance of not messing this up completely.

Aug 26, 2012 | 2004 Chevrolet Monte Carlo

1 Answer

How do you take off door panel 1996 Monte Carlo se?


1. Remove the screw holding the door-open handle bezel, and remove the bezel. Unhook the power door lock switch (if equipped) and set the bezel aside.
2. Carefully remove the power window switch from it's bezzel. There are 4 small clips, 2 on each side of the switch. Once you remove the switch from the bezel, the bezzel can be gently pried out the top of the panel w/ a small screw driver from the front.
3. Starting at the front w/ a small screw driver, pry out (gently!) the trim inlay that's above the arm rest... it was wood-grained plastic on this model.
4. Use a #30 torq bit to remove the large screw towards the top of the opening where the trim inlay was.
5. Remove the 4 Philips head screws around the perimeter of the door panel.
6. Lift up on the door panel... you may have to shake it a bit.... and after moving upwards no more that an inch... the panel should come off.

Jul 20, 2012 | 1996 Chevrolet Monte Carlo

1 Answer

2001 chevy monte carlo diver side window wont go up


Check if switch is broken with an ohm meter (unplug it first). The motor may also be blown out. If you have the confidence, open the door panel and remove these parts & test them.

Oct 06, 2011 | 2001 Chevrolet Monte Carlo

1 Answer

My driver side door lock on 1997 Monte Carlo will not engage. Basicaaly can't close door. Help low on money.


There are small springs inside the door latch that can either break of fall off. You need to remove the door panel and repair/replace the latch mechanism

Jan 02, 2010 | 1997 Chevrolet Monte Carlo

1 Answer

Electric Window on a 1999 monte carlo is in the down position and wedged in the bottom of the door. Window motor drove window down but will not drive upward. Can I drill off the 3 rivets holding the motor...


can you place a thin screwdriver down through the top of door, between the DOOR GLASS and OUTER door panel. If you can, try to raise glss electrically SLOWLY guiding it past the the binding edge. Door glass will need alignment to perrmantly repair

Apr 05, 2009 | 1999 Chevrolet Monte Carlo

2 Answers

I need instructions on replacing driver side rear view mirror on 2003 chevrolet monte carlo


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Feb 26, 2009 | 2002 Chevrolet Monte Carlo

1 Answer

1979 monte carlo


you need to call portsmouth alliment thay can tell you any thing about front ends this is what thay do i deal with them all the time

Jun 18, 2008 | Chevrolet Monte Carlo Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...