Question about 1990 Oldsmobile Cutlass Calais

1 Answer

Right window elc control for all window cannot let 12 volt to other swich where can l get a wire dirgram right window dosnt work,curcuit breaker gets hot

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 378 Answers

You try to clean-up all the contacts of your power window switches, this will because the switches has Normally close interlocking to each other.

Posted on Jun 01, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What are the 4 wires going into the head light swich? theres 1 blue 1 red 1 red with white stripe and a black

since you didn't tell us what kind of car you have I can tell you how to figure out the wires. first get a voltmeter. then using the 20 volts setting. black probe to the ground or metal part of the car. then check each wire to see which one has 12 volts. if the key has to be on the turn the key on. once you figure that out. you can assume the other 2 wires have to be for high and low beam. the other wire is going to be for the marker lights.

Feb 11, 2015 | Cars & Trucks

1 Answer

How can i close the sunroof on a 2002 chevy

check the 25 A breaker (PWR WDO) in fuse block I/P
if the driver power window is working your breaker is ok
check terminal B of the connector 2( pink wire) of the sunroof control module for 12 volts. check terminal D connector 2 of the sunroof control module(black wire) for a good ground. If the sunroof does not work with the switch you could jumper the power to the motor. You could try jumping terminal B to terminal A ( dark green wire) and jumping terminal D to terminal C (dark blue). If the sunroof goes the wrong way, change terminal B to terminal C and terminal D to terminal A. If it doesnot work the motor is dead.

Oct 15, 2014 | 2002 Chevrolet Cavalier

1 Answer

I want isuzu hombre 1999 bcm wiring dirgram and color code

BCM, the body cont. module?

what country, cars are made by country and are wired by laws for their country. and what engine option.?
what dont work right? just a clue to get in right page, would help 100%

if in uSA> has this. log in and look, or tell more....

Apr 30, 2014 | 1999 Isuzu Hombre

1 Answer

Where is the window curcuit breaker for a 2002 honda civic

Its probably the window motor circuit breaker should power all of them and only one doesnt work.

Feb 18, 2013 | 2002 Honda Civic

1 Answer

1990 buick century All power windows will not move fuses on fuse block (locaated in back of glove box door )checked ok with ohm meter T.I.A. ****

Well I was wrong, the window on pass side worked from the switch on the pass door !! So now that I know this I took apart the driver side door switch controll panel ( ie. 4 windows switch up/down & 4 door lock / unlock switch) I found 12 volts to the door lock section but NO 12 volts to the window section ( with key on) !! ratheer then trying to trace out this wire (oange) I took 12 volts from the door & jumpered it to the window 12 volt supply { now I know the door wire is thicker ( more amps) then the window supply but I dont't think I'll be useing all 4 window moters at once...} oh well what the hell it's almost 20 years old has three sets of seats & gets close to 28 MPG....

Oct 16, 2009 | Buick Century Cars & Trucks

2 Answers

I have a 2000 towne and country with a bad passenger side window. My husband tried replacing the motor but the window still wont work. what else could the problem be? The driver side window works fine. We...

I'm assuming you checked all the fuses -- they should be good, but in some cases, the right and left side windows may be on separate fuses.

The best procedure to find this problem is to start at the motor and work your way back to the power source (fuse box) testing each component to see if it is getting voltage.

If you fail to get 12 volts at either of these steps then the component leading to the one which failed to show 12 volts is bad.

First step is to test, with a multimeter, the motor leads for 12 volts when the window switch is engaged.

If you get 12 volts, there, then you should test the coil side of the window motor relay for 12 volts under same conditions.

If you get 12 volts there, test the window switch leads for 12 volts on both sides of the switch. You can also use the multimeter to test the window switch for continuity to see if it is passing current. If it fails the continuity test, replace the switch.

If you get 12 volts there, let me know and we'll take the next step.

I know this is complicated, but electrical troubleshooting is not simple.

More info, let me know.


Aug 23, 2009 | Chrysler Town and Country Cars & Trucks

1 Answer

Power window problems!!!!! window stuck down and it looks like

use the switch from the other side connect just use it and unplug the switch does not work go to motor

May 08, 2009 | 1999 Chevrolet Camaro

1 Answer

95 GMC safari electric windows dont work

the cur kit breaker was shorted out gave me 12 volts still but when I used a volt light and touched the out side metal housing the light lite up that means a short so I replaced the breaker and wala they work.

Dec 01, 2008 | 1995 GMC Safari

1 Answer

Where is the driver side power window cicuit breaker.

check the wireing to the window motor an at the conector as well where it comes thru the door =- i have seen them break there an its covered === also check the circuit breaker in the fuse pannel position number 16 in the breaker for the window motors ok

Nov 23, 2008 | 1996 Chevrolet Cavalier

1 Answer

Location of window circuit breaker

All of the window motors utilize the same circuit breaker. Look for a broken wire between the left side of the dash, which goes thru the inner fender to the door. According to my 1988 schematic, the wire you are looking for should be BLUE, and should have 12 volts with the key on.

Oct 02, 2008 | 1988 Toyota Camry

Not finding what you are looking for?
1990 Oldsmobile Cutlass Calais Logo

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides