Question about 2001 Pontiac Grand Am SE

1 Answer

Tial light bulbs keep blowing

2001 pontiac grand amm rear taillight bulbs keep blowing out due corrision in the sockets can I replace just the socket?

Posted by on

  • Anonymous Mar 15, 2014

    C4 PICCASO FRONT BULBS KEEP BLOWING

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 129 Answers

Yes, you can replace the socket. Pick up the socket a t your local auto parts store and splice into the wires, or go to your local recycle yard and purchase a tail lamp wire harness and just plug it in.

Posted on Jun 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to replace the rear signal light


The whole light assembly comes out and you can remove the bulb assembly from behind. There will be a couple of screws accessible from the trunk compartment behind the concealment panels.

Apr 07, 2014 | 2001 Ford Taurus

2 Answers

How to you change the rear turn signal bulb?


Open back hatch
Remove screws holding the lens on
Apply some force pulling it out side to side because the have alignment pins that are a little stuck
Push in the thumb lock and turh the wire connector on the back to remove bulb holder
Reverse of removal
Hope this helps

Jan 20, 2011 | 1993 Dodge Grand Caravan

1 Answer

How to access bulb for rear taillight 2001 aurora


In the trunk, remove the plastic caps for the storage net. Use a 10mm socket to loosen and remove the three nuts holding in the taillight assembly. The entire assembly will come loose.
Twist the socket for the bulb you are replacing and it will pop out. I would recommend replacing both of the stop lights at the same time - two on each side.

Dec 30, 2010 | 2002 Oldsmobile Aurora

1 Answer

My tail lights are not working, it keeps blowing my fuse.


1.Unplug your taillights at the sockets and the front running lights from sockets.
2. put in new fuse after unplugging taillights.
3 turn on taillights if fuse blows then the wiring is grounding out somewhere between the switch, fuse panel, and rear and or front parking lights.
4.If fuse does not blow then plug in one socket at a time keep rechecking fuse. when the fuse blows after plugging in a certain socket suspect that one to be bad and replace.

Sep 15, 2010 | 2005 Infiniti G35

1 Answer

Left brake light dont work when brake peddel is applied


Replace the bulb,
1. Open the lift gate on the rear of your Blazer or drop it if you have the tail gate that folds down. Locate the screws on the inner edge of the lift gate frame. There are two screws--remove them with a Phillips screwdriver.
2. Slide the taillight assembly out of the rear of the truck, being careful to not break the locating tabs on the rear of the housing. Locate the bulb sockets on the rear of the taillight assembly.
3. Rotate the light bulb socket counterclockwise about a quarter turn to unlock it from the taillight assembly. Pull the socket straight out of the assembly with the bulb attached to it.
4. Remove the bulb from the socket by pulling it straight out of the socket. If you are removing the entire assembly from the truck, remove the remaining sockets from the rear of the taillight assembly, lay them aside and remove the assembly completely.
5. Reinstall everything in revers and don't for get to *** some grease to your socket before you place the new bulb in place and test the operation of the new bulb before you reinstall the tail light.
Thank you for using fixya and here is the bulb you need for the trail light.The 1999 Blazer uses a 3057 bulb available at most auto parts stores.

Apr 29, 2010 | 1999 Chevrolet Blazer

1 Answer

2007 Pontiac G6. Rear license plate bulb socket dead


park lamp and license plate share same fuse.check park lamp fuse.if fuse good you have ground wire problems.

Nov 30, 2009 | 2007 Pontiac G6 GT Convertible

2 Answers

How replace a brake light in 2001 pontiac grand am


open trunk, pull down carpet around break lights you will see 3 or 4 wing nuts remove them pull out complete tail light section

Jun 29, 2009 | 2001 Pontiac Grand Am SE

1 Answer

My left rear taillight keeps blowing a fuse... and then going out...the brake lights work and the turn signals work... but taillight does not.


you should look at the socket and the wires at the socket for a burn mark or damage.if so you can replace a socket.

Jun 22, 2009 | 2002 Chrysler Town & Country

1 Answer

Changing tail light


Pop the trunk open and on the inside opposite of where the tail light is,you will see black plastic wing nuts.These are mounting nuts and you need to remove them to get the tail light off.Once off,you will see a couple of bulb sockets that twist and lock into place on the taillight.Look for a tab on the side of the socket,push it in and turn counter clockwise.Once you have done that it should pull out and expose the bulb,then the bulb just pulls out of the socket.

Mar 03, 2009 | 2002 Pontiac Grand Prix

1 Answer

Left break light and tail light (same bulb) keep quickly blowing


make sure bulb 1157 is in socket correctly- offset pins in proper slots of socket, and socket properly installed in taillight assembly- two small tabs one larger tab in proper slots- hint ground terminal is up

Nov 16, 2008 | 1994 Volvo 940

Not finding what you are looking for?
2001 Pontiac Grand Am SE Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...