Question about 1994 Toyota Pickup

1 Answer

Need a diagram for the vacuum hoses on a 22 re for a 1994 Toyato

We just installed a new engine and when we started the motor it began to run ruff. We think we have mixed the vacuum hoses. A print out of the layout for the hoses would help greatly. Thanks for your help.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

You could turn off radio and listen or feel for seeping air from one of your vacuum lines

Posted on Jun 01, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How many vacuum lines run from engine to heater/air con.block

  1. Vacuum Hose Diagrams‎‎Engine Vacuum Line‎ for
    Engine Vacuum Line. Search Now!
    Over 85 Million Visitors.
  2. Vacuum Hose Diagrams‎‎
    We Are Here To Help You For Free!
    Solving Problems Is Easy As 123.

Jan 21, 2016 | 1998 Oldsmobile Bravada

1 Answer

Why is my truck idling and running so ruff? But when I un plug the MAF it runs fine

Vacuum leaks. Check hoses. Also check the intake manifold at the gasket. To check the intake (have the MAF plugged in) Spray some wd40 around the intake at the gasket seal. If the engine starts running fine at some point. Replace the intake manifold gasket.

Mar 06, 2015 | 1999 Chevrolet Silverado 1500

1 Answer

Turns over but wont start and was running very ruff before

Try starting while depressing the gas pedal. Did it start? If so, remove engine cover (if equipped), inspect vacuum hoses and lines for cracks or breaks. If need be, have an assistant to keep the car running while you also listen for hissing noise which is also an indication of a vacuum leak. Did this work?

Mar 01, 2014 | 2002 Lincoln LS

1 Answer

I have 93 pathfinder. it started to run a lil ruff so i changed sparkplugs .. now its barely ideling n dieing when i come to a stop.. i noticed a vacuum hose is off n i cant see where it goes . its about 8...

If its a vac hose it will have vac in it when the engine is running, or you will have a pipe on the intake pulling air where the hose is supposed to connect.
You may be able to look at a similar vehicle to figure out where the hose goes.

Feb 11, 2014 | 1993 Nissan Pathfinder

2 Answers

Ruff running

there are many vacuum hoses,i dont know if this is a s10 or full size blazer, heres a diagram for the s 10 blazer with the 4.3 if this is not your engine let me know, but heres a diagram, just look over all the lines, hope this helps.446c260.gif

Mar 29, 2010 | 1999 Chevrolet Blazer

2 Answers

My 1989 Toyato is running hot, wher is the

follow your return hose to your radiator

Jan 10, 2010 | 1989 Toyota Corolla 2 Door

1 Answer

The destributor cap was loose, engine was running ruff, replaced cap, tuck running fine. After 100 miles it is running ruff again and check engine light is on. I found a hose around the destrutor cap,...

When's the last time you replaced the spark plug wires? Try that for you mis-fire. As for the vacuum hose, there should be a routing diagram somewhere on the hood or engine compartment somewhere. Trace it out and find where it should go. Oh BTW, bad spark plug wires can ruin a distributor cap.

Jun 30, 2009 | 1997 GMC Jimmy

1 Answer

My map sensor hose and other hoses arent connected

google vacuum diagrams for your car, they should have a black and white diagram which can be hard to read, but it covers everything...

Apr 30, 2009 | 1990 Nissan 300ZX

1 Answer

Engin dies after warm up then, hard to restart, will not stay run

use carb cleaner to trace remaining vacuum leaks .spray while running around plenum and hoses..engine will get happy when it sucks in carb cleaner.. that will allow to find leaking area ...good luck

Dec 17, 2008 | 1990 Toyota Pickup

Not finding what you are looking for?
1994 Toyota Pickup Logo

355 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8729 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides