2001 mitsubishi galant cruise control fuse where is it located

SOURCE: 2001 mitsubishi galant trunk problem

yes a screwdriver or pliers depending if you can see the lever from where the key fits from .just turn it or open the lock itself

SOURCE: where is the starter located on a 2001 mitsubishi

First disconnect the battery. Next remove the flat, angular heat shield from the starter itself (1x 8mm nut and 2x 8mm bolts). Do NOT try to remove the heat shield from the Exhaust pipe - it can't be removed with the starter in place and it's not necessary anyway. Next remove the oil filter. You'll loose a few ounces of oil so be prepared for that with a drain pan and either cover the removed filter to keep debris out or replace it and remember to check the oil level later. Remove the small signal wire from the solenoid (released by pushing in a tiny lever with a finger tip) and also remove the 12mm nut attaching the positive battery cable to the starter. The starter is held in place by two 14mm bolts. On the engine (passenger) side, there is a 14x30mm bolt threading into the transaxle from the bottom of the starter. On the transaxle (driver) side, there is a longer 14x50mm bolt threading into the top of the starter.

SOURCE: Need help in locating starter on a 2001 mitsubishi

they at the back of the motor just at the top or could be at bottom at back of gearbox

SOURCE: 2001 Galant: I replaced the fuel pump on my mitsubishi galant 2...

check fuel pressure

SOURCE: P 0705 transmission range sensor

P0705 - Transmission Range Sensor Malfunction. The park/neutral position (PNP) switch includes a transmission range switch. The transmission range switch detects the selector lever position when the shift lever is in the N or P shift position and sends a signal to the Transmission Control Module (TCM). The possible causes of this are the following: Open or short park/neutral position switch circuit. Poor park/neutral position switch circuit connection. Misadjusted park/neutral position switch. Park/neutral position switch may be faulty. Inspect the pnp switch and replace if needed.