Question about 2000 Ford Ranger SuperCab

1 Answer

Need help with my ford ranger air conditioner system

I get full power when I put the cables directly to the compressor from the battery but when I take it off it quit working

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 90 Answers

May you should check your alternator

Posted on Jun 01, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

AIR CONDITIONER FORD RANGER GOES HOT TO COLD AIR


Could be a blockage in the ac system, or a blend door problem.

Jul 04, 2012 | Ford Ranger Cars & Trucks

1 Answer

Air conditioner blows hot air on reg. ac or max ac.. even after couple of min. running it.


System needs some type of service. Low freon, compressor failure, system clog, or blend door system failure. Have a certified tech give it a check and go from there

Aug 24, 2011 | 2007 Ford Ranger FX4 Off-Road

1 Answer

Air conditioner compressor not turning on bought a new compressor last year it is full of freon/the new stuff


hopefully when they regassed it with the new freon they put dye in the system if the gas has leaked out somewhere slowly this will stop the compressor from working as the have a back pressure release valve, when the pressure isnt high enough the compressor will not engage. you may need to take it in to have them check the pressure in your system.

Jun 23, 2010 | 2000 Pontiac Montana

3 Answers

Heat in my 98 ford ranger not working it blow out cold air from defrost only


check antifreeze level make sure its full with antifreeze and not just water if full check heater core for leaks see if it is antifreeze on the passenger side floor

Feb 05, 2010 | 1998 Ford Ranger SuperCab

2 Answers

How do i change the starter on a 96 century


If it's the 3.1 or the newer 3100 the starter should just be a couple 13 and 15mm bolts. Plus the nut for the cable. Hope this helps.

Jul 13, 2009 | 1996 Buick Century

1 Answer

Air conditioner in a 1998 ford ranger is not working


since u need a special pump to pull the system down after repairs no u can't do it at home, the problem however is the O ring seals on the AC lines, replace all of them, in most cases this corrects the leak, also check the bottom of compressor for oil residue, if found replace the compressor front seal, that also will require special tools.

Apr 07, 2009 | 1998 Ford Ranger SuperCab

1 Answer

Air Conditioner


relays for air conditioners are normally close to the thermostat and tx valves
the problem amy not be with the fan but with the ac compressor not turning on from lack of gas
tell him to check for leaks or take it to an accredited ac shop and have the job done properly

Apr 18, 2017 | 2003 Ford ZX2

1 Answer

A/C will not turn off


you need to replace the controll station this is a common problem on the ranger the controller seems to send a signal to turn on the air con compressor go to the scrap yard and get the correct controll panel and replace it alot cheaper than the oem unit from the dealer at 195.00 here in canada so give that a shot or wire switch direct to the 12 volt compressor clutch wires alot cheaper good luck waiting to hear more re issue

Jul 06, 2008 | 2003 Ford Ranger Regular Cab

1 Answer

1991 ford ranger 4l supercab


idle air control is ran by the power of motor cause the compressor is attached to motor for the compressor you need an idle air control module for a/c compressor this should bring life back to your a/c

Jun 06, 2008 | 1991 Ford Ranger Supercab

Not finding what you are looking for?
2000 Ford Ranger SuperCab Logo

Related Topics:

154 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

fordexpert

Level 3 Expert

5572 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...