Question about 2000 Chrysler Cirrus

1 Answer

A/c not working

I have a 2000 chrysler cirrus. I had freon added and it worked for about ten minutes now its back blowing out hot air. I put a 18 oz can in there... Do you think it was enough or if the compressor gone out. I got the car in february and the a/c wasnt working..... ITS HOT NOW!!!!

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 90 Answers

Did you checked for a leak ? put freon and measure the pressure , the turn on the a/c for couple of hours then measure it a gain if you saw diffrence then you have leak . if not check the condensor if its clogged

Posted on Jun 01, 2009

  • haider alharbi
    haider alharbi Jun 01, 2009

    did you checked for a leak ? put freon and measure the pressure , the turn on the a/c for couple of hours then measure it a gain if you saw diffrence then you have leak . if not check the condensor if its clogged



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

The front air blows cold but the back air is blowing hot

Low on freon. It needs to put on a set of gauges at minimum to check. Just adding freon, does't always fix the problem. To much freon, you will start blowing seals or lines.

Jul 24, 2015 | Cars & Trucks

1 Answer

Heater in 1996 Cirrus not blowing hot air. Radiator hose is cold

did you put new thermostat in the right way ? do you have a 50/50 coolant mixture in rad, 50 % water in rad is what gives you heat, aside from your thermostat, are your heat controls in the proper locations ?

Feb 02, 2013 | 1996 Chrysler Cirrus

1 Answer

My heater will not blow hot air in my 1999 Chrysler Cirrus

When the coolant flush was done, did you have the thermostat changed as well? I would have the thermostat replaced. If the temperature gauge was reading properly, but you still had warm, not hot air, it would lean more towards the heater core being clogged, but that deosn't seem to be the issue your having, so i would go with the thermostat replacement. And whereever you have the repairs done at...make sure they fully bleed all the air out of the cooling system, this could also cause poor warm-up / heating problems. Hope this helps...

Oct 27, 2012 | 1999 Chrysler Cirrus

2 Answers

When I turn on my air conditioner in my 2004 Chrysler Sebring 2.7L it blows cold air until the car has been running for 10 plus minutes and then air blows hot and the RPMs go up and down drastically.

A mechanic would check for voltage at the ac compressor and the freon charge when the ac stops working.
If the compressor is cutting on and off the idle speed will change.

Jul 13, 2012 | 2004 Chrysler Sebring

1 Answer

Air conditining starts out cold then after 5-10 minutes begins to blow hot air. It will work again after the car has been off for long enough to melt and drain frost.

You really need a set of gauges to properly diagnose the A/C system, this is a web page that has pictures and explanation of the problem, iceing up the evaperator is poor circulation or blockage,

Jul 23, 2011 | 2004 Chrysler Sebring

1 Answer

Just had a/c recharged and in one day it is hot air again

That's why you do a leak test, o-rings and leaks at compressor do happin,
I hope you added freon dye, or it's going to cost you freon again, when vaccuming the system for 30 min. and static pressure for 15 min.. the static is when you turn the vac. pump off for 15 min. and there is no loss of vacumn, you have to have A/C gauges, with front and rear A/C takes 46 oz freon and 13 oz of pag 46 oil, only front A/C 34 oz freon and 9 oz pag 46 oil,

Jul 21, 2011 | 2000 Dodge Grand Caravan

1 Answer

My 99 dodge durango's a/c is blowing out hot air, put in coolant didn't work, put in freon it seemed like it was getting a little cooler but still warm, turned air off next day it was back to hot air...

Most likely cause is a leak in the AC system. Adding refrigerant alone won't cure your problem. Get a can of R-134A with leak detector in it. It has a UV dye that will glow wherever the system is leaking. Best of luck.

Jul 02, 2009 | 2000 Nissan Frontier

1 Answer

My a/c was blowing cool air, but my brother added

Sounds like he may have overcharged it and knocked the valves out of the compressor. Is it making any noises rattling and such? Does the compressor turn at all?

Jun 29, 2009 | 2000 Chrysler Town & Country

1 Answer

My a/c is blowing hot air in my 1999 Chrysler Cirrus and 134 freon didn't work.

they prob blew the charge on the a/c it will have to be recharged

May 25, 2009 | 1999 Chrysler Cirrus

2 Answers

Air conditioning problem

sounds like not enough freon or orfas valve is clogged. but most likely it is low on freon

May 05, 2009 | 2000 Oldsmobile Bravada

Not finding what you are looking for?
2000 Chrysler Cirrus Logo

Related Topics:

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides