Question about 1995 Buick LeSabre

1 Answer

Security light stays on

Just recently, after turning on engine the security light stays on I wondered why, or know the possibilites

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 355 Answers

You will find a great write up on this website:http://newrockies.ca . That was the only way I saved my 94 Park Avenue that has the exact same system.

Posted on May 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1996 Buick Skylark engine turns over but will not stay started


Is there a SECURITY light lit on the instrument cluster ? What's the fuel pressure at ? Do you know how to test fuel pressure ? Does the check engine light come on when turning the key to run ,not start just the run position ? Did you try holding the gas pedal down a little way ? Go to you tube an check out videos on trouble shooting , engine won't keep running .

Dec 10, 2015 | Buick Cars & Trucks

1 Answer

2007 focus 2.0 engine stumbles sometimes when driving. when this occurs with car idling, the engine dies but cranks ok and restarts normally and drives fine until this happens again. Car is at deale


i had a similar problem with 2007 focus,car stumbled couple times,stopped at store for milk, car wouldn't start back up,alternator light blinking erratically.wound up replacing alternator,actually had the old one repaired,shorted diode.bad job was removing it from car.came out from underneath.

Jan 27, 2013 | 2003 Ford Focus

1 Answer

My blazer will start but wont stay running long and the security light is on too and this after i put a new motor and trans in it it has been sitting over a year so i was needing help


By switching out the motor, you have most likely interrupted the antitheft system. The security light proves this. The engine starts, looks for the proper key code, doesn't see it, shuts down the injectors. There is a way to bypass this. Read thru this web page. Should find everything you need to know.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Jan 10, 2012 | Cars & Trucks

1 Answer

The malfunction indicator light on my 2004 Hyundai Elantra stays on from the time I start the car and stays on while driving. I know that it needs to be taken to have the code read but I was just...


Would you like to see how many different codes turn on the 'CHECK ENGINE' light? Too many to list here.

You're right when you state 'I know that it needs to be take to have the code read'

You already gave yourself the best advice

I salute you!

Jun 30, 2011 | 2004 Hyundai Elantra

1 Answer

I just replaced the ignition switch and lock in my 2000 alero and now it starts and runs fine but the security light is on and stays on. How do I reset this security light?


TURN THE IGNITION SWITCH TO THE ON POSITION FOR 10 MINUTES WITH ENGINE OFF.UNTIL SECURITY TURNS ITSELF OFF.THEN TURN OFF IGNITION SWITCH WAIT 5 SECONDS.THEN START THE ENGINE.IF SECURITY STILL ON DEALERSHIP HAS TO FIX.

Jan 18, 2011 | 1999 Oldsmobile Alero

1 Answer

Just wondering if you leave car door open or closed when trying to get security light to go off


YOU CAN TURN OFF SECURITY LIGHT BY PUTTING KEY IN THE IGNITION SWITCH.TURN IGNITION TO ON POSITION,WITH ENGINE OFF.LEAVE KEY IN THE SWITCH IN ON POSITION FOR 10 MINUTES UNTIL SECURITY LIGHT TURN OFF.IF IT DOES.TURN OFF IGNITION SWITCH.WAIT 5 SECONDS THEN TRY CRANKING CAR.IF THIS DONT WORK TRY ANOTHER KEY DO THE 10 MINUTES SWITCH TRICK.IF STILL THE SECURITY LIGHT DONT TURN OFF YOUR THEFT SECURITY SYSTEM IN FAULT THE DEALERSHIP HAS TO FIX AND REPROGRAM NEW KEY IN SWITCH OR BCM CONTROL MODULE..

Sep 13, 2010 | 1999 Oldsmobile Alero

1 Answer

1991 plymouth laser rs strange light comes on then turns off.


I would check the engine coolant, It should be filled to the COOL LINE when engine is cold.

Jan 05, 2010 | 1992 Plymouth Laser

1 Answer

How would I reset my 2001 Grand Am Gt! The security light stays on when I turn it to on....and no gas is getting to the engine! So everyone says that I need to reset it! BUT DONT KNOW HOW TO?


Turn key to run, click the engine but do not let it start then relax back to the run position. You will now see the security light on
After about ten minutes light will go off.
Turn key off and back on to run within 5 seconds

Repeat above procedure for a total of 3 ten minute relearns.

After done turn key off and Then start engine.

Dec 02, 2009 | 2001 Pontiac Grand Am SE

1 Answer

Check engine light


It is a computer code issue to start, as your check eng light came on. Now you need to put a scan tool on it and repair code related issues first. Idle may drop with A/C load but as you know the veh should run okey. I wonder about the recent work done and if some of the issues where not there before, you need answers not a new expense

Sep 28, 2009 | 2004 Honda Accord

2 Answers

Seccurity light staying on car starts and shuts right off gas gauge shows empty


Hello You can try resetting the security system by turning the key on and leaving it in the run position for 15 to 20 minutes, and then just start the truck don't turn to the off position until you have started the truck. after that all should be fine, And remember use the key with the chip on it too. Hope that gets you up and running. Thanks for using Fix Ya bear001

Jul 17, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
1995 Buick LeSabre Logo

Related Topics:

268 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...