Question about 1994 Pontiac Grand Prix

2 Answers

Had intake gasket replaced and hasn't run since. replaced crank sensor and coil packs any suggestions

95 chevy monte carlo 3.1 liter will fire off but not run

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 29 Answers

HI,OK SINCE THE 3.1 HAS NO DISTRIBUTOR ,TIMING PROBABLY ISNT THE ISSUE. DOUBLE CHECK THE FOLLOWING: FIRING ORDER.SPARK PLUG CONDITION (ARE THE FULL OF FUEL) DID YOU HAVE TO REMOVE THE ROCKER ARMS OR LOOSEN THEM AS REQUIRED IN THE 3.4 ENGINES.WERE THEY ADJUSTED PROPERLY,WERE THE PUSH RODS INSTALLED IN THERE ORIGINAL LOCATIONS.WAS THE CAM SENSOR RECONNECTED.PERFORM COMPRESSION TEST,THIS COULD ANSWER ALL THE VALVE TRAIN QUESTIONS GOOD LUCK...RAY

Posted on Jun 21, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 74 Answers

Timming not set right restab dist.

Posted on May 31, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2002 Chevy Monte Carlo ss has a miss. Rpm gauge jumps up an down while driving. Has new air filter, plugs an wires. Other suggestions?


Stop by any good parts store and have them do an OBII scan (fault scan) Most will do it FREE. They'll pull codes and identify what is causing your "miss"

Apr 30, 2011 | 2002 Chevrolet Monte Carlo

1 Answer

Trying to hook up a tack and can't find the coil on a 97 chevy calvalier 2.2 liter


The coil packs (there are 2) are on the back side of the engine, towards the fire wall. They are positioned about half way up the block, above the crank knock, and cam sensors, and are near the centerline of the vehicle, a bit to the passenger side. They are crowded, but accessible from underneath. Access from above involves removing lots intake and throttle equipment to reach them. Also, if your tach is designed to run on a single coil ignition, it probably won't work if connected to a coil pack. You would be better off taking signal from the ECM or maybe the crank sensor..

Dec 30, 2009 | 1999 Chevrolet Cavalier

2 Answers

My car backfires and will not start.


Cmashaft or crank shaft position snesors. Find their location and clean them 1st then re-try.

Aug 04, 2009 | 1995 Chevrolet Monte Carlo

1 Answer

95 Monte Carlo Idle Fast and Have low oil pressure


95 monte carlo is idling high we just replaced the intake manifold gasket. How do I fix this and could I have caused it.

Jun 13, 2009 | 1995 Chevrolet Monte Carlo

1 Answer

No spark from ignition coil


did you reuse the balace shaft if you did have you check the teeth or it may ecm problem

Jun 09, 2009 | 1995 Chevrolet Monte Carlo

2 Answers

Out of blue 97 3.1 monte carlo engine start running bad


Check firing order 1,3,5 in the back next to firewall 2,4,6 in front check coil packs. If o.k you could have burnt valves. As for the knocking If its a heavy kock and it happens all the time even at idle it could be the main bearings on the crankshaft.

Mar 22, 2009 | 1997 Chevrolet Monte Carlo

1 Answer

95 chevy monte carlo vac leak


It sounds like the Intake Gasket may have slipped a little During the Install. This would cause the Preassure Problem. Let me know so we can go further if needed. Please Rate my Response, I need all the Help that I can get! Thanks!

Jan 26, 2009 | 1995 Chevrolet Monte Carlo

5 Answers

Multiple misfire 95 monte carlo 3.1 liter


check codes first. But sounds like crank position sensor mine does it all the time

Jul 07, 2008 | 1995 Chevrolet Monte Carlo

Not finding what you are looking for?
1994 Pontiac Grand Prix Logo

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8737 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...