Question about Oldsmobile Bravada

2 Answers

I need to replace the flasher unit 2 prong pulled in on 1996 bravada ihave the radio desk half out it is supposed to be below radio but i cannot find it im at wits in any help anyone

Posted by on

  • 1 more comment 
  • dansmith617 May 31, 2009

    by convience center are you talking about where all the fuses are i have put 1 of these in before and and i cant find this 1 itook this to a garage and he could find it i only have 1 car and have to work tomorrow

  • dansmith617 May 31, 2009

    i need help replacing the flasher button unit i was told yesterday on fixit it was in control unit under the radio i was told today left hand side of dash in control unit i have half dash out radio out looked everywhere still cannot find someone please make it easy thanks dan

  • dansmith617 May 31, 2009

    very helpful amazing that the flasher could be in such a small area under the radio panel thankyou dans

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,959 Answers

Your car has 2 flasher units: A signal flasher and a hazard light flasher. They are located in what is called the convenience center, a panel that swings down toward you. Here is a link to a diagram of the panel as well as it's location. There should be no need to remove the radio. Best of luck.
Greg

Convenience Center The convenience center is used to centrally locate various buzzers, relays, flashers and/or circuit breakers. On some earlier vehicles, it is a box-like, swing-down unit located on the underside of the instrument panel. Later vehicles use a bracket-like strip, mounted under the instrument panel to the right of the steering column. All components located in the convenience center are serviced by plug-in replacements.

http://www.chiltonlibrary.com/content/images/8538/images/85386120.pdf

Posted on May 31, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,614 Answers

Hi there,

it is located on the FRONT SEATING AREA, DRIVER SIDE, BEHIND LEFT HAND SIDE OF INSTRUMENT PANEL, MOUNTED ON CONVENIENCE CENTER.

let me know for any clarifications

Posted on May 31, 2009

  • micromaster
    micromaster May 31, 2009

    locate it on the left side of the dash board (on the driver side)

    Remove the cover from the fuse box. The cover should contain a chart
    telling what each fuse controls, or there may be a clear plastic cover
    over the fuses that gives this information.


×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My96 olds. Bravada blinkers wont work, when i turn on either blinker all 3 brake lights in back blink on and off (like emergencey flashers are on)I replaced both flashers andhave no burned out bulbs


You are going to have to register on BBB INDUSTRIES
FREE Documentation site...

because... These are REAL GM drawings &
Technical Service Bulletins... (TSBs).

Get onto your SIGNAL/BRAKE Schematic Drawing
and figure out where your "SHORT" (cross-over) is
happening...

This is where the REAL technicians use tone tracers...
and open circuits to halves (50, 50) to isolate FAULTED CIRCUITS.

If you don't "open" the circuits... the tone will travel
everywhere... or no where.

1996 OLDSMOBILE BRAVADA 4 3L V6 Turn Signal Switch RockAuto

1996 OLDSMOBILE BRAVADA 4 3L V6 Turn Signal Switch RockAuto 1996 OLDSMOBILE BRAVADA 4 3L V6 Turn Signal Switch RockAuto

Mar 19, 2017 | 1996 Oldsmobile Bravada

1 Answer

LXI. how do I replace flasher?


The Flasher is located: Behind A/C and heater control panel, in center console.

Flashers

Print
REPLACEMENT

Flashers are located either on the bottom of the fuse block or on a module under the dashboard. They are replaced by simply pulling them straight out. Note that the prongs are arranged in such a way that the flasher must be properly oriented before attempting to install it. Turn the flasher until the orientation of the prongs is correct and simply push it firmly in until the prongs are fully engaged.clink on link to see what flasher look's like.
http://www.autozone.com/electrical-and-lighting/turn-signal-flasher/novita-turn-signal-flasher/chrysler/sebring/1998/4-cylinders-y-2-0l-mfi-dohc/193143_0_7283

Aug 15, 2015 | 1997 Chrysler Sebring

1 Answer

The turn signals and emergency flashers do not work


replace flasher unit.
The turn signal and hazard flasher unit is located in the interior fuse panel located under the driver's left side knee protector. They are replaced by simply pulling them straight out. Note that the prongs are arranged in such a way that the flasher must be properly oriented before attempting to install it. Turn the flasher until the orientation of the prongs is correct and simply push it firmly in until the prongs are fully engaged.

looks like this:

jturcotte_0.jpg

Nov 04, 2010 | 1998 Mitsubishi Diamante

1 Answer

1996 ford ranger turnsignals not working fuse is good wondering about 6 prong relay is it the flasher


James is right on location. left side of column right under dash not way back. but all you can see is the wires. my flasher is blue and square 1 1/4x 1 1/4 pull the whole thing and it slides out then unplug The problem is that I have a 6 prong flasher and no one has one only 5 prong and they wont work. pick n pull or dealer?
c932f399-7a8e-4654-a195-3a3c08dac916.jpg

Oct 23, 2010 | 1996 Ford Ranger SuperCab

3 Answers

Cant locate hazard flasher relay on my 1994 oldsmobile cutlass ciera s 2.2L 4 cyl.


ok i have found your answer but i found it on another website so i copied it for you to rummage thru I hope this is what u were seeking and glad to help.

flasher switch location The flasher switch for the 94 cutlass is not where you would think it would be it is behind and off to the side of the ashtray or below the radio.

New Answer Headline The above is accurate; getting to it is a little tricky. Open the glove box and remove the tether wire connection at the door by unscrewing the SHC screw with a T-15 Torx driver. This will expose 2 of the 4 fuse panel mounting screws. Use an 8mm socket to remove all four and wiggle the panel out. The flasher is behind and to the left in the harness itself, not on a terminal block. Use a straight blade screwdriver to gently pry the two prong connection from the unit (Mine was an OEM Wagner - bright yellow.)
Additional Answer
It depends if you're talking about the turn signal flasher or the emergency flasher. The emergency flasher is directly behind the glovebox. If you're referring to the turn signal flasher, I just replaced mine last night without having to mess with the fusebox or glovebox. It turns out that it was attached by a clip on the right side of the ashtray frame inside the dashboard. I took out the removable "cup" part of the ashtray, then removed the two upper and two lower ashtray frame screws. Next, I pulled the frame forward and disconnected the small ashtray light. The power wire for the cigarette lighter can stay attached. After I slide the frame out the rest of the way it was easy to get to and replace the flasher unit.

Apr 25, 2010 | 1994 Oldsmobile Cutlass Ciera

4 Answers

Where is the flasher on a 1994 toyota previa


The flasher is bolted to the firewall behind the right side of the instrument panel and you can't get to it from underneath the instrument panel. You will have to remove the center console fascia to get to the instrument cover screws and remove the instrument cover. Then you can get to the instrument holding screws and move the instrument panel out of the way. Either a service manual or AutoZone.com will have this information and pictures. Replace the flasher with a genuine Toyota flasher relay. The aftermarket relays might look like they fit but I have found out they don't work properly. The flasher is bolted to the firewall with a 13mm bolt. Take out the bolt and replace the flasher.

Jul 15, 2009 | 1997 Toyota Previa

1 Answer

Fasher unit location for a 1996 bravada


Are you trying to replace the Turn Signal Fuse?

First, remove the ash try.

Then, there is a small bolt that you need to remove. When you removed the ash try, the bolt is shown. it is on the dash on the top left of the opening of where you removed ash tray.

Next, get a #30 Torx Head, either Ratchet or Screwdriver. To the left of the ash tray, about a foot, and to the right of the steering column, there is a Torx Head Bolt. Remove that.

Now, remove the panel around the radio and air conditioner controls. You don't need to remove it completely. Just enough to allow that bottom portion of the plate where you removed the screws to be lowered. You should see the tabs that rest on the panel that you just removed. Push that panel down as far as you can. To the right of where you removed that Torx Screw you should see two round silver cylinders. They should have the number '522' stamped on them. The one on left is for the Turn Signals, Left and Right, and the one on the right is for the Emergency Flashers. It is best to replace them both. Use a pair of pliers and pull them straight out, don't turn them. You can wiggle them, but don't turn them left or right. You could damage the connectors.

Put the knee panel and the front panel back in the opposite of the directions.

If you need further help, I would recommend that you go to your local auto parts store and get a Haynes Manual. There are detailed instructions on the removal and replacement of those fuses listed in that manual.

Hope this helps!

May 29, 2009 | 1996 Oldsmobile Bravada

1 Answer

Flasher button location in 1996 oldsmobile bravada


Do you mean the Emergency Flasher?

This is located on top of the steering column. Push in to activate. Push again to deactivate.

Some models also have the switch located at the 4 o'clock position of the steering column. Just below the starter key and a bit further back. It is round and black. There is a collar that moves around the button. Push in the center of that button to activate. Pull on the collar to deactivate.

Hope this helps.

May 29, 2009 | 1996 Oldsmobile Bravada

1 Answer

Ihave a 1996 landrover discovery 2 audio problem


its the capasator needs replacing you blew it up.

Mar 26, 2009 | 1996 Land Rover Discovery

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

126 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...