Question about 1994 Chrysler LHS

1 Answer

My 1994 Chrysler LHS will not shift to a higher gear.

When I first take off with it it will shift to a higher gear. Then when I want to accelerate it sounds like it slips and then it goes into low and stays there.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 37 Answers

It sounds like its going into limp mode I would take it to a transmission shop and get it looked at. You might need to get it rebuilt or replaced

Posted on Jun 15, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2006 Chrysler Pacifica stuck in second gear will not


Not sure of your mileag but I had a LHS same engine, and when i had a spark plug go bad the computer limited the number of cylinders from firing. Engine would not allow full power so limits shifting.
did tune up replaced all spark plugs.
happened on LHS on 60,000 miles.

Sep 30, 2016 | 2006 Chrysler Pacifica

1 Answer

My 1999 LHS is not shifting up,it seems to be stuck in 1st. The speedometer isn't working also.The fluid is full and it starts and runs fine.I only have reverse and low gear.


Trans could be stuck in limp in mood, may just need to replace the speed sensor, or diagnose the no speedo problem.. Trans relies on speed sensor info to shift

Oct 18, 2015 | 1999 Chrysler LHS

2 Answers

Chrysler lhs transmission wont shift and my speedometer isnt working but all the other instruments are. what could it be?


It may be your speed sensor. When the speed sensor is not working, the speedometer will not work, the car will not shift past second gear, and the engine light should appear.

Oct 10, 2011 | 2000 Chrysler LHS

1 Answer

NONE OF THE GAUGES WORKS ON THE DASH


If you select drive on the shifter and drive the car does the transmission shift out of 1st gear? If not. I had the same problem. Take the cover off around the steering column, on the left side there is a wire connector that pulls loose when the steering column is tilted up and down. I plugged mine back together and DONT TILT the steering column ,you wont have any problems.

Nov 18, 2010 | 1994 Chrysler LHS

2 Answers

In a 94' Chrysler LHS what is the firing order? Took the plug wires off the housing unit.


1994 Chrysler LHS
3.5 liter SOHC V-6 VIN "F"56539136.gifI HOPE THIS IS WHAT YOU NEED. THANKS FOR USING FIX-YA. PLEASE KEEP ME POSTED. FEEL FREE TO COMMENT ON THE ASSISTANCE

Sep 06, 2009 | 1994 Chrysler LHS

1 Answer

1994 Saturn SL2 - Wont Accelerate/Shift, Overheats


replace tranny filter and fluid, do not do tranny flush, could cause more problem. just filter and fluid change

Jul 15, 2009 | 1994 Saturn Sl

1 Answer

1994 LHS STEERING BROKE - WHEEL FREELY SPINS


First thing I would check is the inner tie rod bushing, common failure on Chrysler products.

Feb 09, 2009 | 1994 Chrysler LHS

1 Answer

Chrysler lhs 3.5 engine


It sounds like it is in limp mode. This is to protect further damage to transmission. You need to take it to a trans shop for diagnostic

Dec 17, 2008 | 1995 Chrysler LHS

2 Answers

1996 Chrysler LHS shakes


A bad motor or trans mount could be the cause which allows the engine and trans assembly to shift mor to one side on a turn which changes the the axle length and lessens pressure on the CV joint causing the wobble. I mounts check ok then it is most likely a worn CV joint.

Jun 23, 2008 | 1996 Chrysler LHS

Not finding what you are looking for?
1994 Chrysler LHS Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...