Question about Jaguar Xj Series

1 Answer

1995 3.2 xj6. when igntion is turned off and key removed,instrument lights come on and there is a .4 amp drain which flattens battery in 3-4 days.instrument lights extinguish when engine is started and operate normaly whilst ignition is on????????? Please help as no w/s manual cct drawing is available.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,917 Answers

Hi,

Please find the links in the article bellow which would help you with teh w/s manual.

http://pdftown.com/search/node/jaguar+xj8+cooling+system+diagram

Thank You

Posted on May 31, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

St191 30 amp am2 circuit keeps blowing


I suspect you have a short somewhere between the ignition switch and the instrument panel fuse block. Here is what you can do. Unplug the igntion switch connector. Remove the ST fuse and the IGN fuse. Connect a test light to the POSITIVE side of the battery, Probe pin 3, black with white wire and pin 4, red wire at the ignition switch connector. If the test light illuminates that wire is shorted to ground somewhere between the switch and the fuse block.

Nov 06, 2015 | 2000 Toyota Corona

1 Answer

Battery drain vw


Look at things that drain a battery such as a door not completely closed, cabin light on, radio remaining 'on' etc. Also the igntion key removed at off position versus at a notch before. Nothing else TMK drains the battery.

Dec 08, 2013 | Cars & Trucks

2 Answers

Toyota camry starts, turn it off 4 hrs later battery is dead.


bad battery or glove box light may be on. check for lights in trunk under hood and such. if none take your battery for testing. probably a bad battery

Mar 24, 2013 | 1990 Toyota Camry

2 Answers

Parasitic battery drain


A stuck relay will do this.

Nov 27, 2012 | Cars & Trucks

1 Answer

No pwer at all going to driving light nor the instrument cluster, starter turns but it won't turn on .and on the fuse block some of the fuses have no power running to them .the fuses are still good


Sounds like you have a power drain (small-amperage short) in the wiring going to your instrument cluster. The short has disabled some of your instrument cluster lights, but, since is has high resistance, it has not blown a fuse (since it draws to few amps). Once the current drain has wasted enough amperage, there's not enough left in the battery to start the car.
Phase 1: Interim solution: (1) charge the battery with your battery charger (if you don't have a battery charger, attach the battery with jumper cables to the battery in a running car - its alternator will charge your battery).
(2) pull the fuse(s) to the instrument cluster, thus killing power to the short.
(3) start and use you car without instrument cluster lights until you can move
to phase 2 of your repair. If you're not sure that you've killed power to the short, disconect the battery each time you stop the engine.
Phase 2:
(1) isolate the problem (the short) to one specific fuse, meaning one specific branch circuit in the car.
(2) trace the wiring from the fuse block to the instrument cluster, looking for
burn marks, bare wires (all wires should be insulated), or anything touching
a frame ground. Also look for moisture iintrusion - water can cause these types of high resistance "shorts" - with the symptom that the problem disappears after the water dries up.
(3) correct wiring problem found in step 2, plug in fuse. done
(4) if replacing instrument cluster, use instructions below.

1995-99 Models

See Figure 4
Fig. 4: Common instrument cluster found in 1995-97 "S" series Pick-ups.
(see illustration at end of message)

1. Disconnect the negative battery cable.
2. Remove the sound insulators/trim panels.
3. If necessary for access, unfasten the steering column nuts and if necessary, the bolts at the lower flange, then lower the column for access.
4. Unfasten the instrument cluster bezel screws located at the lower edge of the bezel. If no screws are present, then remove the bezel by pulling it straight out.
5. Unfasten the four screws retaining the instrument cluster to the instrument panel, unplug any necessary cluster electrical connections, then remove the cluster.

To install.
6. Install the cluster to the instrument panel making sure the cluster is firmly seated onto the connector, attach any necessary electrical connections and tighten the cluster fasteners to 17 inch. lbs. (1.9 Nm).
7. Install the instrument cluster panel bezel by snapping it into position, then if equipped, install the screws along the bottom of the bezel.
8. If lowered, re-position the steering column and tighten retaining nuts to 22 ft. lbs. (30 Nm) on 1995 models. On 1996-99 models tighten the nuts to 20 ft. lbs. (27 Nm). If removed, tighten lower flange bolts to 120 inch lbs. (13 Nm).
9. Install the sound insulators/trim panels.
10. Connect the negative battery cable.

9_30_2011_9_51_04_pm.jpg

Sep 26, 2011 | 1996 Chevrolet Blazer

1 Answer

Help my xj6 1995 wont start, no lights, everything is dead but it worked perfectly ok yesterday, and I cannot open the boot to check the battery


Sounds like a total battery drain - something left on that you do not know of? Open the boot using manual over-ride (ignition key or cabin pull cord)

Jan 10, 2011 | 1995 Jaguar XJ6

1 Answer

1995 buick park avenue starting trouble, i changed the crank censor,changed the igntion module control, gave it a tune up,still has trouble wanting to start?


Fuel filter replaced? Check pressure after putting one on. Claen battery cables too. Turn key to run wait 2 or 3 seconds and then start.

Jul 06, 2009 | 1995 Buick Park Avenue

2 Answers

94 xj6 wont start immobilizer fault


remove the battery for 2 minutes. it might reset the problem. if not try a spare key

Jun 02, 2009 | 1995 Jaguar XJ6

2 Answers

My xj6 wont turn over


Check the battery first. next check the fuel supply and then the ignition system if these are all ok it could be the starter solenoid or starter motor.

Nov 04, 2008 | 1995 Jaguar XJ6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...