Driver side window went down and won't come back up. Is there a way to open the panel in order to fix the window?

2009 Door Problems - MyG37

www.myg37.com/forums/g37-sedan/253409-2009-door-problems.html

Dec 6, 2013 - 2009 Door Problems G37 Sedan. ... My problem is that my front driver side door will not open up from the inside or outside. My FOB key ... door wouldn't shut....now it won't open
Mar 5, 2015
Help! my windows roll down when i open the door!
Apr 10, 2013
Rattle in drivers side front door
Dec 11, 2010
Window Reset
Jul 28, 2008
More results from www.myg37.com

Driver's side door won't open!? - G35Driver

g35driver.com/...sedan-v36.../371407-driver-s-side-door-won-t-open.ht...

Mar 24, 2011 - I went to get in my car today and my driver's side door won't open - from inside or out. There's. ... The manual locker inside doesn't work. Problem with driver side door locking (and unlocking)
May 3, 2011
Dome light issues
Jul 3, 2010
More results from g35driver.com

Drivers door would not open - Nissan Forum ' Nissan Forums

forums.nicoclub.com/drivers-door-would-not-open-t466851.html

Dec 11, 2009 - My wife went around to the drivers side and used her key to see if she

if it is electric window check fuse box or the window motor or the connections or switch

take door panel off it has probably fell off runner

Try a slim jim first, down the side of the window. Or AAA or locksmith. If no luck, remove the seat first. Find the screws and bolts around the door handle and arm rest. Most Ford's have screws around the outer side of the panel. I don't believe your's does. The panel lifts or pops off. Once the panel is off, you can reach down and open the door. Just a note. I have done some to where the panel came out in pieces.

disconnect the window from the regulater and push it up then wedge a piece of wood under it

That is not true.
The handle fell off on the inside. You can remove all the screws, remove window and lock controls. Then take a large flat-tipped screwdriver gently pry off door panel. Pull up and off when loose. You will now have access to inside off door and put the rod back in the handle hole. If the plastic holder piece is broke you will need another one. Cheap.

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll see the innards of the door

you'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to pull off the seal in order to see inside the door. There should be two bolts holding down the inside guide rail and two bolts holding down the outside guide rail

You might have a faulty switch in the master!! Sounds like the lock and unloc has gone bad on you!!

When you open the drivers door you can see a wiring harness between the door and the body of the car.
You more than likely have wires broken in there.