Question about 1987 Dodge Ram Maxivan

1 Answer

1987 dodge 4x4 no reverse

1987 dodge 100 4x4 318 automatic does not go in reverse at all all the other gears work it doesnt sound like its engaging at all

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 334 Answers

I hate to tell you but your tran is no goog. you will needto replace it. sorry to tell you this

Posted on May 31, 2009

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
csmock132
  • 4669 Answers

SOURCE: no reverse

Remove the bottom pan and check the rear band. It might be so loose the apply strut fell out and is laying in the bottom of the pan.

Posted on May 31, 2009

  • 1 Answer

SOURCE: no reverse

If all other gears work and no reverse the Low/reverse band is broken. The way to tell is to drive in reg. drive to about 15 mph then pull the shifter into manual low. If you don't feel it pull back like it normally would, its the band.You can also pull the pan and see if the rear servo apply lever is hanging down. The tranny will have to be pulled and torn down as the rear band goes in the case first.

Posted on Aug 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 99 dodge dakota v6 when im driving in 2


Put truck in reverse and zig zag backwards turning truck left and right will take it out of four wheel when stuck.

Aug 30, 2014 | 1999 Dodge Dakota

2 Answers

Audi a3 auto reverse gear doesn't move


run fault codes and look for faulty TCM and reverse servo .

Nov 29, 2013 | Audi Cars & Trucks

1 Answer

My 2000 dodge durago 5.2 starts right up but will not go into any gears or reverse. does this only mean my transmission is dead?


is you 2000 dodge manual or automatic gearbox?
manual: check on the properler shaft if its working while gear is engaged then selectors of a gear lever must be in correct possition
automatic: check on transmition oil filter and oil if in good condition

Jan 26, 2013 | Cars & Trucks

3 Answers

2001 Dodge ram -2500 automatic. transmission slow to engage, months later started not shifting into 3rd gear, then 1 months later slow to engage into 2nd , now only 1st gear......


sounds like filter could be clogged, if it hasn't been changed in a while. you can try to replace throttle position sencer, it is like your old trans kinkenge system, only now, it is elect. it tells trans when to shift, like your speed sencer on trans doe's. both can make it act like it is.

Jan 10, 2011 | 2001 Dodge Ram 2500 Truck

2 Answers

I have a problem with my mazda . My 4x4 doesnt work. Thank you.


I repaired a Mazda 4x4 pickup by replacing both front hubs that were vacuum operated. One of the hubs was not engaging causing t the 4x4 to be inop.

Nov 21, 2010 | 1998 Mazda Pickup

1 Answer

93 C/K 1500 z71 1st gear and Reverse grind when cluth let out


the throw out bearing is bad ,so change bearing and clutch

Jan 22, 2018 | 1993 Chevrolet K1500

1 Answer

1987 porsche 944 auto only works in reverse


sounds like a bad tranny. Gear shifter may be locked, have you checked the tranny fluid?

Aug 02, 2009 | 1986 Porsche 944

1 Answer

No reverse


Remove the bottom pan and check the rear band. It might be so loose the apply strut fell out and is laying in the bottom of the pan.

May 31, 2009 | 1987 Dodge W150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...