When I start my 2013 Accent with remote starter installed by Hyundai the doors dont lock. I have to lock them with remote. They tell me thats the way the remote starter works on the Accent. I thinks security is greatly compermised, because if you any thing in your car and you started car with remote starter and forget to lock doors, you risk loosing anything inside. Is there a fix or do you know if this the case with the Accent?
SOURCE: My car alarm is blinking
you can try switching the key to the "on" position then open the hood and disconnect the negative terminal of the battery and reconnect after 2minutes. this will allow the alarm to be '"reset" and will recognize that you have the key for the vehicle.
SOURCE: remote starter does not work but will unlock and lock doors.
I have a 2003 sierra and my remote starter would not work, it would lock and unlock only, checked out this site found the solution, tried it and in two seconds i solved the problem, Just press the lock button and the start button and viola it works again, thanks for all your help , GGGreat site glad i found it John
SOURCE: Remote start and door locks will only work from 10 feet or less
i had the same problem... go through the menu until you see reprogram remote. hit the check mark button and hold the lock and unlock button until the horn honks. key has to be on car not running though. You will eventually have to do it again but for some reason it will work for a while.
SOURCE: Broken Hyundai 2002 Accent door handles
i have a 2005 hyundai both back doors would not open from the outside . after taking the panel off i found out that the handle is completely plastic and that it had broke in half because off stress . i removed the handle ( which was a pain ) and used quick drying epoxy on the crack . then i put a thin piece if aluminum on each side of the crack and used the same epoxy to hold it on . the next day i put the handles back on ( after letting the epoxy dry ) and it has worked perfect ever since. my next recourse , if it breaks again , is go to ebay . there is a seller if you type in hyundai door handles that sells 2 after market ones for $39.99. they fit 2001 to 2005 . i hope that this helps .
SOURCE: hyundai accent '02 inside door handle & Lock removal
Removing the door is very tricky, trust me on this. I ended up breaking it the first time, so please learn from my mistake.
1. Remove all visible screws: 2 at bottom of door, 3 on front near
hinge, 1 on inside the door lever. You will need an average size
phillips screwdriver to do this.
2. On the door handle itself, you will see two circles. Pop the front
one out. You will need a LARGE size phillips screwdriver to do this.
3. Once screws are removed, take a (standard) flat-head screwdriver,
preferable one with a large face, and pry the triangular piece of
plastic (that covers the outside SIDE mirror) off. This will aide in
puting the door panel back on...TRUST ME!!!
4. Take the same flat-head screwdriver, and pry behind the door lock
(at the same time, push forward toward the door hinge). The assembly
should pop out.
5. Gently pry the door panel from the door, making sure not to break
any unnecessary pieces along the way. The door panel should be hanging
by the window sill opening.
6. This is where it will get tricky. It is advised that you use help
with this part: Angle the door panel at a 45 degree angle. AT THE SAME
TIME, slightly bend and twist the door lock handle until it fits
through the hole. You will see the 3 pegs the held it in the door from
before. Also note: Be careful not to break the 2 poles that are
attached to the lock.
7. After popping the lock through the hole, you should be able to lift
the door upward, and off the sill. Repeat these steps in reverse order
to re-attach door panel.
Be careful not to rip sound-deadening paper found on inside of door
unless you intend to remove or replace it! Not only does it prevent
dirt and moisture from entering your door (and possible rusting it from
the inside out), but it makes your speakers sound better too!
-SportTunerFreak
**It is also recommended to put a tiny bead of silicone on the inside
of the door panel to help suppress any rattling, and prevent moisture
and dust from entering. It also helps your screws obtain a tighter fit.
Hope this helps!
http://schematicsdiagram.blogspot.in/2012/03/this-is-how-system-operates.html
This will help.
Thanks.
285 views
Usually answered in minutes!
×