Question about 1995 Buick Park Avenue

1 Answer

How do I fix a 1995 buick park avenues front seat motors?

Two motors out of five don't work. The two that don't work try to. They make a clunk sound and ****, but that's it.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I had that problem with the motor for seat back tilt.
I had to remove the seat and take the cables out of the motor and connect the drive cables to 2 drills one in forward and one in reverse. I lubricated the threaded shafts and the drive unit with WD40 then ran the drills back and forward till it started moving again. then I lubed again with more wd40 and ran seat back all the way forward and back many times. reassembled and tested the motor by connecting 12 volt cordless drill batery to the motor to verify it is now working.
The problem that I am now having is no power to the drivers side and do have power on pasenger side, think they are the same fuse. Need schmatic/wire diagram to continue my trouble shooting . This should help with yours. test each motor with the cordless drill battery. reverse polarity to reverse direction.

Posted on Jun 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can i ger a wiring diagram for a 1995 park avenue trunk pull down motor


The motor is an integral component of the luggage compt lid pull- down assembly. Terminal A (ORG) connects to 20A FUSE 1 in the relay center. Terminal B (RED) connects to terminal C of the luggage compt lid latch switch. Terminal C (DK GRN) connects to terminal B1 of the trunk ajar indicator (if your Buick is equipped with a gages cluster). Terminal D connects to ground (BLK).

May 26, 2014 | 1995 Buick Park Avenue

1 Answer

1995 park avenue shuts off while drinvig


Remove and clean grounds at battery and on chassis underhood.

Mar 16, 2013 | 1995 Buick Park Avenue

3 Answers

2002 buick park avenue power drivers seat won't go up or down


The most common problem is the gear breaking under the seat. There is one motor to make the front go up and down and one motor to make the back go up and down. The front up/down motor is the easier one to replace. I have a video of one way to fix the up/down motors. I demo the back motor. Here is the link to my video: http://www.youtube.com/watch?v=wQLVvUf-9rs

Jun 30, 2012 | 2002 Buick Park Avenue

1 Answer

Turn signals on my 1992 Park Avenue blinked slower and now donot work at all. My emergency flashers work fine and all blink but I have no turn signals and nothing lights up when signal is left or righ


About your 1992 Buick Park Avenue 3.8L SFI OHV 6cyl. the Flasher is located:
Hazard flasher: Front seating area, driver side, under dash, mounted above kick panel

Turn signal: Front seating area, driver side, under dash, driver side of steering column, mounted on support bracket

Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Nov 11, 2011 | 1992 Buick Park Avenue

2 Answers

Drivers side electric seat will not raise or lower, but will move front to rear. 2000 buick park avenue.


the most common problem is the power seat switch is defective, next is the motor in the seat transmission, there are three motors, u can't buy just the motor, u must replace the whole unit

Mar 29, 2010 | 2000 Buick Park Avenue

1 Answer

Where are blower resistor and relay located on 1995 Park Avenue?


For most common location, open hood and look near cowl for a plug near the air conditioning box just forward of the windshield wipers. It should have several wipers and the resistor itself protrudes downward into the box held in place with two screws. Screws have 7mm, 8mm, or 1/4 inch hex head.

If not: look near blower itself under the dash on the passenger side. The resistor should protrude upwards into the HVAC housing near the blower.

Sep 17, 2009 | 1995 Buick Park Avenue

2 Answers

Tranny clunks when shifting gears


Check motor and transmission mounts.

Jun 15, 2009 | 1999 Buick Park Avenue

1 Answer

My 1995 buick park avenue will chokes and dies


Sounds like the catalyst converter is restricting the exhaust gasses from the engine causing the problem

Jun 10, 2009 | 1995 Buick Park Avenue

Not finding what you are looking for?
1995 Buick Park Avenue Logo

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...