Question about 2004 Jeep Grand Cherokee

1 Answer

Manual A/C blower switch all of a sudden only works on HIGH.

2004 Jeep Cherokee. All other positions don't do squat.I can't imagine the switch suddenly going out on all other positions. Is it something else?

Posted by on

  • robert_frenc Jun 09, 2009

    I was quoted $160 for the stupid thing- any way I can get a part number and shop around?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 323 Answers

Replace the blower resistor

Posted on May 31, 2009

  • chryslerguy Jun 09, 2009

    Your local Chrysler dealer can (and should) give you the part number along with the price. If it has auto temp control, it is a little pricy but 160 is a bit high I believe.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 Jeep Grand Cherokee fan switch works part time.


Probably the switch. Could be the blower resistor.
On most models the high position bypasses the resistor which cuts down voltage for lower speeds.

Jul 06, 2012 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Blower motor only works on high for 2004 jeep grand cherokee what is the fix ?


This is caused by a defective blower motor speed control resistor. The resistor is located next to the blower motor with one end going into the air ducting and the other sticks out with an electrical connector on it.

Jun 10, 2012 | 2004 Jeep Grand Cherokee

1 Answer

My 2005 Jeep Grand Cherokee heater only blows air on the high setting, I ohm tested the HVAC fuse under the hood and only get response on 1 leg.


when the blower motor resistor fails the blower switch defaults to the high position. autozone.com has a great tutorial on how to replace the blower motor resistor.

realfixesrealfast.com has a segment on blower motor resistors.

Nov 13, 2010 | 2005 Jeep Grand Cherokee

2 Answers

My 2004 Jeep Grand Cherokee limited is equipped with infrared dual zone climate control A/C and heater. The blower started to quit intermittently over a short period of time and finally has quit working...


sounds like it could be the motor ..if so nasty job .. you can download complete manuals on the internet for free ..then you can take it from there wether or not you wish to tackle the job yourself .. good luck

Oct 25, 2017 | 2004 Jeep Grand Cherokee

1 Answer

A/c Heat Fan in 1995 Jeep Cherokee doesnt work. I can feel cold or hot air right the vents but fan doesnt blow. Where is blower motor found in this car?


there is a blower motor resistor that cuts the voltage for the different fan speeds. this is most likely the culprit. check autozone.com, you can get access to location and wiring diagrams to be more familiar with it. you have to register and it's free. the switch or wiring might also be bad, when in the high position, the switch effectively bypasses any resistor. although the voltage still runs through the assembley. a repair manual is you best option

Feb 24, 2010 | 1995 Jeep Cherokee

1 Answer

2003 jeep, grand cherokee no heat or blower


this sounds like the blower or switch is bad. to test blower, first check the fuses, then if it still does not work, run 2 wires from a power source 1 for positive and 1 for negative(ground) disconnect connector at fan motor and try these wires to see if it runs. if not replace fan,if it runs on wire but not from switch, replace switch. or check wiring carefully.

Nov 28, 2009 | 2004 Jeep Grand Cherokee

1 Answer

1994 jeep grand cherokee fan switch suddenly only works on high


You need to find the blower resistor and relay and check them.

Jul 22, 2009 | 2004 Jeep Grand Cherokee

2 Answers

Heat/AC Blower fan speed only works on High


hello, this sounds like a bad blower motor resistor!! its cheap and easy to change..if you need more info on locations let me know,, good luck.....marty

May 27, 2009 | 2005 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Jeep Grand Cherokee Logo

Related Topics:

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...