Removal of Front Grill?

Check out the videos. Must be easy as the videos as short.

https://www.google.com/search?q=2001+Volvo+S80+remove+the+front+grill

..

https://www.chryslerminivan.net/threads/grill-removal.167059/

Videos

https://www.google.com/search?q=remove+front+grille+on+a+2016+Dodge+Grand+Caravan

..

Remove wheels. Remove fender liners front. Remove three nuts per side from inside fender wells. Remove fog lamp grilles. Remove vertical bolt just inside grilles--pointing up. Remove two screws per side under hood near front of fender. Put milk crate under front bumper. Remove belly pan first. Slide bumper forward onto milk crate, disconnect headlight washer line at quick disconnect if so equipped. Disconnect fog light connectors. Remove bumper.

Behind the grille, here's how to remove it to expose horn Thread How To Bumper Removal for Protege5 pics

may need to remove the plastic underpanel under the front bumper instead..parts store has the printout..or a body shop can direct you ..

I found a great thread about this:

http://newbeetle.org/forums/paint-body/54248-difinitive-98-fog-light-grill-removal.html

For agrivation go to walmart and have an oil change and ask them to change the headlight bulbs, they do NOT CHARGE EXTRA labor charges.

Otherwise, gently apply pulling pressure on the front grill every few inches to get the grill unhooked on the top and bottom nearest the headlight assembly. Then have someone hold the grill assembly out while you pull out the headlight assembly to access the rear of it to remove the hold down nut to remove the bulb's. Reverse removal procedure, which is actually harder to put the headlight assembly back into place then it is to remove.

The front grill and bumper has to be removed to reveal the 2 lower screws holding each lamp assembly. Removal of the hood latch is simple, just don't over do when you spread the plastic link cause it would break sometime. Do not loose the pivot pin and the locking clip of the plastic link to the latch handle. The front grill needs to be poke with a flathead screw driver on top to release it. Hopes this helps cause it really is just simple common sense to figure out.

the lower clips are pushed down with a long screw driver from the front , when the grill is removed the clips need to be removed from the vehicle and put in the grill then push the grill in

Jack up the front of the vehicle. Secure the vehicle with at least once JACK STAND. Open the hood of the car. Remove the front grill. Remove the fasteners on the head light assembly that are located on the exposed inner fender and the one that was under the front grill. Lay on your back and look between the front fender and the head light assembly. You only have about 4 inches. Remove that screw. All screws are either Phillips or torks.