Question about 2004 Ford Crown Victoria

1 Answer

Transmission Mount is broken

How do you replace the transmission mount on a 2004 crown victoria. police model ? Also, is this a very difficult job, or should i take it to the shop? Thank you!!

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Ford Master
  • 5,653 Answers

Check the frame crossmember at the mount. If it looks like the crossmember can be unbolted, it should be a simple job. You would remove the crossmember while supporting the tailshaft. Then unbolt the trans mount from the transmission, change out the parts and reinstall. Or have a shop put it on a lift and change it out in less than an hour.

Posted on May 31, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How can I tell if my crown victoria motor mounts are broken

You need to open the hood. You can have someone stand by the fender and look at the engine while you do this test. Now start the engine and put it into drive gear, apply the brake and step on the accelerator pedal to bring the RPM up a little. The helper must watch how much the engine as it lifts or twists. More than an inch or two you have a broken mount. Now do the same thing in reverse gear to check the other side. This vehicle is a rear wheel drive and will have 3 motor mounts. Left , right (both under the exhaust manifolds) and a rear mount at the rear of the transmission. This mount should be visually checked as well. I hope this helps.

Jul 12, 2015 | 1996 Ford Crown Victoria

1 Answer

How can I tell motor mounts are broken on crown victoria

basically pull the motor off the mount
if it is broken then the mount will part
inspection will reveal a shiny part of metal where the rubber is rubbing on the steel

Jul 12, 2015 | 1996 Ford Crown Victoria

1 Answer

I recently had a transmission installed four months ago, however twice it would not go in drive or reverse. It is a 1998 crown Victoria police interceptor.

I know you had a transmission installed but did you get the tourque converter as well as the transmission ... not all transmission shops will do a great job you need to find someone reliable you can trust ... personal opinion says find an older white guy thats been doing it for years worked well for me

Oct 14, 2014 | 1998 Ford Crown Victoria

1 Answer

Can an engine be rebuilt in a 2003 crown victoria police car

Yes it can, there are many parts around for a rebuild, even upgrade some parts, you can also rebuild your transmission too, even change gears. But you can also find used low mile engines around as well as a replacement , These are modular engines , Grand Marquis will work as well

Oct 04, 2014 | 2003 Ford Crown Victoria

1 Answer

How do i replace the motor mounts on my 1994 crown

I can only forewarn you about several things to watch for in hope of providing you with something to prevent you from breaking something.
You must also consider loosening the transmission mounts to free up the entire drivetrain. There may be some clearance problems at the rear of the motor and the Radiator hoses may not stretch, nor may the fixed A/C lines to the front A/C cooler allow much travel space.
The oil pan is not a lifting point, nor is the crankshaft pulley. The exhaust system is not flexible either.
Your best bet is to look at the actual motor mount and see whether the mount is flush or has protruding studs. Flush shaped will be easier to handle. An 1/4 inch of clearance would allow you to slide parts through the opening.
You could still get another Expert to answer. I owned a 1994 Crown Vic and was underneath it many times, but never changed a motor mount on it.

Oct 02, 2014 | 1994 Ford Crown Victoria

2 Answers

Why isn't speed odometer not working in my 2004 ford crown victoria

You need to change your cable that goes to your transmission from the odometer easy fix

Aug 29, 2014 | 2004 Ford Crown Victoria

2 Answers

94 gmc 1500 transmission mount broken??

Let me get this clear.. you did not remove the cross member to drop the pan?? WHY?.. If you broke the bolt loose that is made into the transmission mount.. you need to be able to tighten the mount somehow.. if you can't tighten the mount, yes, you need to replace the mount . NEXT TIME - Use a jack stand under the front of the drive shaft to hold up the transmission.. this will make the job easier!!

Jul 09, 2017 | 1994 GMC Sierra

2 Answers

I have a 1999 Ford Crown Victoria Police Interceptor with a bad transmission. Will any transmission from a 1999 or 2000 Crown Vic. or Grand Marquis work as a replacement?


Mar 04, 2011 | 1999 Ford Crown Victoria

1 Answer

I have a 1998 ford crown vic police intercepter and the transmission is sticking in first gear and when i let off the gas it shifts. what could be the problem? and oh i already did a trans flush.

thereis a transmission module i believe, and that tells it when to shift. if they didn't have them in that year model, then a vacuum line will also cause that

Nov 12, 2010 | 1998 Ford Crown Victoria

1 Answer

Lincoln ls engine swap with crown victoria

It should be doable, if the engine size is compatible to the Transmission mount. You may need to change the Engine mounts location. As far as if it is a good idea or not only you can as the owner can decide that.

May 11, 2010 | 2000 Lincoln LS

Not finding what you are looking for?
2004 Ford Crown Victoria Logo

Related Topics:

157 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

78238 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5653 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides