Question about 2008 GMC Sierra 3500HD 2WD

2 Answers

Lightbulb driver side 2008gmc 3500 6.6l

2008 gmc 6.6l how do you change the headlight bulb on the driver side

Posted by on

  • Anonymous Mar 19, 2014

    I wont to know if i CAN change just the mirror or all of the casing Whit ?



2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

How to change driver side headlight bulbs?

Posted on Jun 10, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 869 Answers

  • Set the parking brake and remove the keys from the ignition. Make sure the headlights are switched off, then open the hood using the primary and auxiliary release latches.
  • Remove pin on the headlight assembly by turning it up and pulling it straight out. Draw the headlamp assembly away from the truck and unplug its electrical connector.
  • Pull the headlight assembly away from the front of your truck. Be careful not to scratch the headlight's lens or the truck's exterior paint.
  • Detach the electrical connector from the back of the bulb, and then turn the bulb counterclockwise to remove it from the assembly. Dispose of the bulb immediately to prevent it from becoming a hazard.
  • Twist the new bulb clockwise into the socket and reattach the electrical connector.
  • Press the headlight assembly back into position and turn on the truck's engine. Test the new bulb to make sure it works before replacing the retaining pin and shutting the hood.

  • Posted on Jan 06, 2011


    1 Suggested Answer

    • 2 Answers

    SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

    A 6ya expert can help you resolve that issue over the phone in a minute or two.
    Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
    The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
    click here to download the app (for users in the US for now) and get all the help you need.
    Good luck!

    Posted on Jan 02, 2017

    Add Your Answer

    Uploading: 0%


    Complete. Click "Add" to insert your video. Add



    Related Questions:

    2 Answers

    How to change running light

    "You Tube" will have a video just for you. Punch in your information and I am sure there will be an answer there for you.

    Nov 26, 2015 | 2012 GMC Acadia SL 4dr SUV 3.6L V6 6-speed...

    1 Answer


    I would suspect the bulb is at fault or the connector to the bulb, but you don't say the type of headlights you have so that handicaps my diagnosis. As for aftermarket so called high intensity bulbs I would stay away from them.

    Sep 18, 2012 | 2000 Acura TL

    2 Answers

    How do I replace headlight bulb in passenger side 2009 gmc sierra truck


    Jan 12, 2011 | GMC Sierra 1500 Cars & Trucks

    1 Answer

    Need to change headlight bulb in gmc envoy 2003

    Drivers side- stick your hand behind the headlight and remove the rubber cover, and twist out the light.

    Passenger side- remove the air cleaner top, and move the air cleaner out of the way. You now have complete access to this side to remove the rubber boot covering the bulb.

    Dec 22, 2010 | 2003 GMC Envoy

    1 Answer

    How do I replace the driver's side headlamp?

    Lift the hood and remove the bulb from the inside rear of the headlamp. The bulb assembly has ears on it that you use to unscrew the bulb. Look at the autozone link below to see the bulb. Installation is reverse of removal. Note: DO NOT TOUCH THE NEW BULB GLASS WITH YOUR FINGERS!! They are halogen bulbs and will burnout.

    Sep 23, 2010 | 2008 GMC Yukon

    1 Answer

    How to change the headlight bulb on 2009 gmc sierra driver side

    1. Loosen only, do not remove, the lower outside hidden headlamp bolt (2). 2. Depress the housing support tab with a flat-bladed tool downward in order to release the headlamp assembly from the support. 3. Pull the lamp assembly slightly forward to access the electrical connection. 4. Disconnect the forward lamp harness main electrical connector from the headlamp harness.
    Headlamp Screws (Qty: 2)
    1 Caution: Refer to Fastener Caution .
    6 Nm (53 lb in)
    O Headlamp Screw (Hidden)
    6 Nm (53 lb in)
    3 Headlamp Housing Support

    Preliminary Procedure Remove Healamp
    Remove either the LF or RF headlamp assembly. Refer to Headlamp Replacement (Chevrolet) Headlamp Replacement (GMC HD)
    Headlamp Replacement (HD Diesel).
    Headlamp Bulb (Hi)
    Warning: Refer to Haiogen Bulb Warning .
    Tip: Rotate the bulb socket a quarter turn counterclockwise and remove the bulb from the headlamp.
    Headlamp Bulb (Lo)
    Tip: Rotate the bulb socket a quarter turn counterclockwise and remove the bulb from the headlamp.

    Need more come to

    change-headlight-bulb-2009-gmc-1pzbcmqursjjtd0qcfo11o2t-2-0.png change-headlight-bulb-2009-gmc-1pzbcmqursjjtd0qcfo11o2t-2-1.png

    Aug 14, 2010 | 2008 GMC Sierra 2500HD 2WD

    2 Answers

    2008 hhr ls can't get to drivers side headlight bulb to change Please help?

    This video will show you how to replace the headlight and also the bulb in the headlight of your HHR">

    May 20, 2010 | 2008 Chevrolet Hhr

    1 Answer

    I need help in changing headlight bulb on 2008 gmc sierra 2500

    You have to remove the air intake filter and then kind of reach around up in there to change it. It can be done, but is a lot of work. On the duramax, it is even harder to do the driver side because of the dual batteries. You have to remove the battery, then the battery seat plate, and undo the winshield washer fluid tank and lean it forward. Then you can just sort of reach in and change both headlights. A very big pain to change a couple of headlights, but if you want HID's.... for the average person, changing a headlight now means a trip to that garage.

    Nov 24, 2009 | 2008 GMC Sierra 2500HD 2WD

    1 Answer

    How do you change low beam headlight on the driver side of 2008 acadia?

    1)first open the hood
    2) check on the back of the headlight there is a socket coming out.
    3) remove this socket which is the one that holds the bulb inside
    4) replace bulb and put it back

    Nov 05, 2009 | GMC Acadia Cars & Trucks

    Not finding what you are looking for?
    Cars & Trucks Logo

    1,121 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top GMC Experts


    Level 3 Expert

    78936 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers

    Ronny Bennett Sr.
    Ronny Bennett Sr.

    Level 3 Expert

    6927 Answers

    Are you a GMC Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides