Question about 2003 Honda Accord

2 Answers

Removing starter removing the starter on a 2003 honda accord 4 cyl

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 28 Answers

It's not that easy. Yes, 2 bolts hold the starter down but you have to remove the whole intake manifold to access the starter to remove it.

Posted on Sep 28, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

First disconnect neg battery cable.
Jack up car, use tape or marker to mark wires on solenoid. Than remove the two nuts that hold on wires. Disconnect the all three wires. Two have bolts, and one just unclips.
Than remove the 2 starter bolts and either pull up starter or drop down if there is room.

Posted on May 30, 2009

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 94 Answers

SOURCE: Replace starter on 2003 Honda Accord w/4 cylinder

disconnect the cable to the battery........there is 3 bolt holding the starter to the engine/transmission housing. You may need to remove the air intake manifold to gain access to the work area.

Posted on Mar 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the starter located on the 96 Honda accord LX 4 cyl


Behind the engine bottom side. Jack car up for better access

Mar 02, 2011 | 1996 Honda Accord

1 Answer

How do I replace the starter on a 2003 Camry?


1st to do, disconnect the battery and remove, also remove battery support , the starter is located between engine and transm. behind battery, now disconnect 2 wires from starter , loose 2 bolts 14mm wrench and starter will fall in your hand , note this procedure is for 4 cyl model , 6 cyl engine same

Jul 29, 2010 | 2003 Toyota Camry

1 Answer

How to rplace starter on 2003 honda accord dx 4cly


hello there:
you will need to disconnect the positive cable from the battery then you will need to locate the starter you will have two or three bolt that you will need to remove then disconnect the wiring from the starter and mark wires so you know where they to remove the starter and replace in reverse...hope this helps you out please leave a review thanks sincerely D.Jones

Jun 05, 2010 | 2003 Honda Accord

1 Answer

1997 Honda Accord, 4 cyl, auto trans. When I turn


The starter sit on top I belive on the passenger side above the transmission, have some one hold the key to start while you tap or even hit the starter some time it will crank over if it does replace it, not that big of a job. If it still dont start there a big wire that one comes from the battery and a small one that come from you ignition switch ( key ) jump those two wire's ( if stander transmission make sure you have it out of gear ) there should be voltage at big wire all the time, if it still dont crank over replace starter assembly.Hope this was very helpful.

May 11, 2010 | 1997 Honda Accord

1 Answer

Replace starter on 2003 Honda Accord w/4 cylinder. Steps to take to remove and install new starter.


disconnect the cable to the battery........there is 3 bolt holding the starter to the engine/transmission housing. You may need to remove the air intake manifold to gain access to the work area.

Mar 20, 2010 | 2003 Honda Accord

1 Answer

Abs light on always honda accord 2003 4 cyl


either your sensor is faulty, or you need t oservice your brakes. best to have a pro look at it unless you are experienced with brakes...they are quite important for safety, and you should not ignore the warning.

Sep 08, 2009 | 2003 Honda Accord

2 Answers

Where is the starter located in a 2004 honda accord?


i havnt worked on a 2004 but all the hondas i worked on the starter was on top of the trans runing inline with the valve cover on the 4 cyl i dont know what motor you have hope this helps some

Aug 18, 2009 | 2004 Honda Accord

1 Answer

Starter installation for a 1998 honda accord-4 cyl manual


easy DYI job ..discon battery ..two bolts to starter and remove /replace wiring from old to new and reverse

Dec 17, 2008 | 1998 Honda Accord

Not finding what you are looking for?
2003 Honda Accord Logo

Related Topics:

601 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...