Question about Nissan GT-R

1 Answer

Nissan skyline gts-t 33r

I cleaned the engine ,&next day started to run bad like hovering & bad air intake ,a switch goes off &engine starts to click,& the other way around.it runs smooth around 3000rpm.please help

Posted by on

  • sashatrifuno Jun 01, 2009

    no, tryed it .blowed everything out,maybe if i had a compressor to it would off done the job.                                                                                   THANK YOU FOR YOUR KINDNESS.......

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 67 Answers

You have got water in the coils! take a hair drier and dry the coils out it will be just fine and run like new! hope this have been helpful to you and good luck!!!

Posted on May 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2003 Nissan Altima 2.5L Service Engine Soon Light is on, Auto Zone says codes are for MAF and O2 Sensors. Car hard to start after driving a while but when starts appears to run smooth. Auto Zone thi


ok lets start with the codes they say your getting. P??? which 1's and how many. there are few o2 sensors, are they next to the Exhaust next to the converter? MASS AIR FLOW -MAF use this, for now i am guessing, until i see the correct codes your are getting. this could be the 1 you may have below, please read it........
  • P0103
    Mass Air Flow Sensor Circuit High Input
  • Possible causes
  • Faulty mass air flow sensor
    - Intake air leaks
    - Dirty mass air flow sensor
    - Dirty mass air filter
    - Mass air flow sensor harness is open or shorted
    - Mass air flow sensor circuit poor electrical connection
  • Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.
  • possible symptoms Engine Light ON (or Service Engine Soon Warning Light)
    - Engine stall
    - Engine running rough
    - Excessive fuel consumption
    - Excessive smoke
  • the code is generated when An excessively high voltage from the sensor is sent to Engine Control Module (ECM).
2003 NISSAN Altima Sedan OBDII Codes List

Oct 22, 2014 | 2003 Nissan Altima

1 Answer

My 2004 f-150 5.4 liter missfires on cylinders 5, 6 & 8. new plugs were installed one month ago. what could be the problem?


noby mentioned bad injectors
they are as important as plugs and are the principle causes for misfires

pull and clean the injectors and use a quality injector cleaner

May 28, 2017 | Ford F-150 Cars & Trucks

1 Answer

I have a 1997 skyline gts. Few days ago the ABS light just switched on in dashboard n when I stop the car removed key n thn I started car it was gone I face same problem again this evening I tried all...


When youy start the vehcile the ABS goes through function test at above 10 MPH if there is a fault the light comes on, This can be a faulty sensor ,a faulty tone ring,or the harness connection.

Mar 25, 2012 | 1997 Nissan Skyline

1 Answer

The other day my car randomly shut off while i was driving, now it does it everytime i go to drive it ...if i give it a lot of gas it wont shut off but if i dont give it any gas then it will shut off...


a few things to do. First, clean the MAF sensor heated short wires with spray carb cleaner or brake cleaner. It's on the big air intake tube. Wires are inside.
Next, check fuel pressure. should be 34 psi.

Last, replace distributor with one from Rich Porter on Ebay, the Import Experts. $200. There is a cam sensor inside that goes bad, not serviceable. Remove cap & rotor & cover & look for brown dust from bearing failure too. Usually they run good cold & quit when warm.

Please rate if helpful. report findings.

Sep 07, 2011 | 1997 Nissan Pathfinder

1 Answer

My 91 pathfinder has a looping idle..dosent do it all the time...ive changed fuel fillter, TPS, and cleaned air intake sencor.....will run and drive fine and then go to start and it will starve out and...


fuel pump or pump regulator cud be failin--distributer cap may be corroded--do a scan for bad codes--clean throttle body and idle control motor--get a haynes manual

May 11, 2011 | 1991 Nissan Pathfinder

1 Answer

Daewoo Lanos 2001 SE starts, runs briefly, misfires & stops


replace your intake air box filter (remember check to see what direction it faces) an arrow (indicating air flow direction) on the air filter should face the engine intake. next check your wide open throttle switch (located in the intake tube) for smooth flap movement or, a broken wire.

Apr 07, 2010 | 2001 Daewoo Lanos

1 Answer

I have a 1994 nissan altima gxe, the car runs fine but when the temperature gets normal it kills? what could that be?


DO THE FOLLOWING TO CLEAN THE AUTOMATIC IDLE SPPED CONTROL VALVE AND THROTTLE PLATE.

I want you to get a can of intake cleaner (ABOUT $5.00) from any local auto parts store like NAPA or Carquest, do not use carburetor spray, intake cleaner only or u will damage the Teflon coating inside the throttle valve and air bypass valve, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Mar 19, 2010 | 1994 Nissan Altima

1 Answer

Need fitting instructions for blitz dump valve with hard pipe for 1996 nissan skyline gts


Needs instructions on how to fit a diesel forge motorsport dumpvalve with kit on a skoda fabia 2005 1.9 tDI with the new pd engine as runs with drive by wire. cheers

Oct 21, 2009 | Nissan GT-R Cars & Trucks

2 Answers

Nissan R34 CRASH BAR


when saying crash bar do you mean roll bar? or the front bumper support?

if roll bar, i believe it will fit with minor adjustments on the floorboard.

if the bumper support. i dont think so. the r34 has a slightly more square design on the front end and would not make for a good switch.

in theory if you can weld you can get anything to fit. good luck hope they put a skyline section up for ya...ya lucky bastard. youve got my dream car. have a nice day

Oct 18, 2008 | 1996 Nissan 300ZX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...