Question about 2002 Chrysler PT Cruiser

2 Answers

Front windows don't roll down

They go up and the back ones are fine i have the same problem. The front windows will go up, but not down. The back windows are fine.

Posted by on

  • michaelrusso Jun 05, 2009

    Fixed it! My back windows went down but not the front windows...they would only go up, not down. Bought a part from eBay for $45 from Walt & Verns. The part was called "02 Chrysler PT Cruiser Power Window Switch Panel Master" and was extremely easy to install. God bless the internet and eBay!!

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 32 Answers

Yes, the power window switch is often faulty, because there is some sensitive electronic making that "auto rolled down". The 4x-switch is quite expensive, 260EUR =( So, I make some new connection. The faulty electronic is only for front windows, so now I connect wires so that I can use front windows with read window switch. (Rear windows is still working by those 2xback window switch) which is located between seats. Here is the conncection, at one's own risk. That 4x-window switch has 14-pins connector: Connect the back windows wires 8(blue/white), 9(red/black), 1 (grey/blac ), 2 t(green/white) to the ground wire 4 (black). Front windows wires 14(blue)->8 13(white)->9 3(white/violet)->2 7(black/blue)->1 If the manufacturer didn't use that "auto rolled down" function, there is no worries of power windows. Also illumination of 4x-switch goes down quite soon, leds will be better. Here is a photo if you like replace bulbs to leds: http://www.ptcruiser.fi/ptgalleria/albums/userpics/10010/PT-Cruiser%20Power%20Window%20Switch%20-Lamp%20Replace.jpg

Posted on Jun 09, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 27 Answers

If the motor is accessible check for power and ground to the window motor. the window switches have two contacts one side (down) is power-ground other side (up) ground-power. the power change allows the motor to rotate forward and backwards to go up and down. usually if the motor works in one direction it is the switch that has the problem. sometimes the motor fails to reverse for the downward motion. check for power and ground while pressing the switch. if there is no problem there then replace the motor. if you do not have power or ground check the switch for adequate power and ground at the middle pins.

Posted on May 30, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an EOS VW 2009 and it had 5 window switches in the driver side door to the front windows and back windows and a switch to push all four windows down/up at the same time. But right now my passenger...


Hi Kimberli,

I suspect that since all windows can be powered up and down, you have issues with I believe 2 specific switches you mentioned that have problems - as a result of possible rain water, melting snow / ice or spillage of beverages. You might be able to clean them up - or replace the ones that are "flaky"

Good luck!

Mar 12, 2015 | 2009 Volkswagen Eos

1 Answer

The right front passenger power window will not go up


If it rolls down and not up then something in your switch has faulted. If it does not roll up or down then either bad switch, bad wiring, or blown fuse/ relay.

May 10, 2010 | 1998 Nissan Altima

2 Answers

The passenger rear window won't roll up or down from the drivers controle it clicks in the passenger front door. it will roll down in the passenger rear door but not up. the window modulator rolls up and...


I have the exact same problem on a Jeep Grand Cherokee 2004. The rear passenger window rolls down only from the rear passenger window and won't go up or down from the front. It has to be in the wiring because the problem was intermittent initially and a new window motor does the exact same thing. If you figured it out or have the wiring diagram please let me know.

Apr 22, 2010 | 2004 Jeep Grand Cherokee

1 Answer

They were working fine before but now both front windows will not roll down but the ones in the back work fine.


Check and see if the right front door window switch works. If so the master switch on the drivers door is at fault needing a replacement

Jan 30, 2010 | Land Rover Range Rover Sport Cars & Trucks

1 Answer

The windows don't work right


If the passenger front window switch operates up & down correctly the left drivers side switch is bad and needs a replacement switch

May 29, 2009 | 2001 Chrysler Concorde

1 Answer

Front windows don't roll down


Yes, the power window switch is often faulty, because there is some sensitive electronic making that "auto rolled down".
The 4x-switch is quite expensive, 260EUR =(
So, I make some new connection. The faulty electronic is only for front windows, so now I connect wires so that I can use front windows with read window switch.
(Rear windows is still working by those 2xback window switch) which is located between seats.

Here is the conncection, at one's own risk.

That 4x-window switch has 14-pins connector:
Connect the back windows wires 8(blue/white), 9(red/black), 1 (grey/blac ), 2 t(green/white) to the ground wire 4 (black).

Front windows wires
14(blue)->8
13(white)->9
3(white/violet)->2
7(black/blue)->1

If the manufacturer didn't use that "auto rolled down" function, there is no worries of power windows.

Also illumination of 4x-switch goes down quite soon, leds will be better. Here is a photo if you like replace bulbs to leds:
http://www.ptcruiser.fi/ptgalleria/albums/userpics/10010/normal_PT-Cruiser%20Power%20Window%

Mar 29, 2009 | 2002 Chrysler PT Cruiser

2 Answers

1994 jeep grand cherokee power window problem


most of the time it is wires in the drivers door that break in the loom

Feb 20, 2009 | 1994 Jeep Cherokee

2 Answers

Right-side power windows will not roll down


well check window switch on driver side first does it roll down from that side / does it roll down from passenger side/ next if not do you hear the motor if yes its the switch in driver door that is bad / if you don here the motor then its the regulator/motor that needs replacing/ Please rate my response thank you very much

Jan 28, 2009 | 1991 Acura Legend

1 Answer

Driver's window


I have the same problem, its more than likely a sticking motor. I just punch the door panel below the window switch (where the motor is) and it works. You may have to bang it a few times but i have to do it about once a week on the front right or my car.

Aug 24, 2008 | 1994 Buick LeSabre

Not finding what you are looking for?
2002 Chrysler PT Cruiser Logo

502 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8560 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...