Question about 2004 Chrysler Crossfire

1 Answer

Car problems i have a 04 crossfire the car alarm will go off at any ime it wants. i replaced the light bulbs so many times its not even funny! the stick shift will pop out of gear the sterio start to go hay wire so i pulled the fuse and have to turn it on maunally and it turns of by its self i dont know what to do with i any more

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,392 Answers

Sounds like you need a dealership. Those cars are very finicky, and require some special knowledge of how they work. It does sound like you have multiple problems though. Would venture to say your wireless control module is going bad. (alarm). Trans popping out of gear is an internal problem.

Posted on May 30, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Problem with the 2005 Buick Century Bulb replacement on climate control display HOW TO REPLACE & WHERE TO BUY THEM


You have to remove and dismantle each switche and solder in a new bulb on the inernal printed curcuit board ... time consuming and tediously precise work ... the bulbs are 14 volt 0.065 amp minature ... part number is 8111 (you need the ones with wire leads) and are available on eBay at US $1.00 each (search 8111 bulb) ... in my 04 LeSabre there were some 35 such bulbs throughout the all of the switches and buttons! By the way, if you ran the dash lights at half brightness the bulbs last a lot longer, even 2 volts less (than the rated 14 volts) extends the life more than 3x. Best wishes with the replacement!

Dec 22, 2010 | 2005 Buick Century

1 Answer

Passenger side headlight assembly removal, is there more than 2 bolts, if so where


You can replace the headlights on your Crossfire easily by yourself. headlight image by Carbonbrain from Fotolia.com

When a headlight burns out on your Chrysler Crossfire, you do not need to rush to the repair shop to have it replaced. You can access the headlights in your Crossfire from within the engine compartment, allowing you to change the headlight yourself. The Crossfire uses an H7U headlight bulb, which you can find at auto parts retail stores or at a Chrysler dealership.
Difficulty: Easy

  1. 1 Open the hood of your Crossfire to gain access to the headlight assemblies. Press down on the tab on top of the light assembly cover. Remove the cover and set it aside.
  2. 2 Pull the electrical connection free of the bulb socket. Press the spring clamps securing the bulb into the light assembly. Pull the bulb straight out of position.
  3. 3 Insert the new bulb in the same position. Ensure that the spring clamps secure the bulb. Press the electrical connection into place.
  4. 4 Replace the light assembly cover and press it into position until it clicks, securing it in place. Repeat the same process on the opposite headlight if required. Close the hood and test the headlight operation.



Dec 12, 2010 | 2004 Chrysler Crossfire

1 Answer

Need to replace headlight?


  • Open the hood of your Crossfire to gain access to the headlight assemblies. Press down on the tab on top of the light assembly cover. Remove the cover and set it aside.
  • 2 Pull the electrical connection free of the bulb socket. Press the spring clamps securing the bulb into the light assembly. Pull the bulb straight out of position.
  • 3 Insert the new bulb in the same position. Ensure that the spring clamps secure the bulb. Press the electrical connection into place.
  • 4 Replace the light assembly cover and press it into position until it clicks, securing it in place. Repeat the same process on the opposite headlight if required. Close the hood and test the headlight I would replace them both sides if i were you
  • Dec 02, 2010 | 2004 Chrysler Crossfire

    1 Answer

    I have a 2004 Chrysler Crossfire I cannot get the alarm system to turn off. Towing mode will not disable, every time a door is opened the alarm goes off and the alarm triggers again when I drive. I live...


    I have the same problem on my 2004 crossfire :(
    the alarm goes off out of the no where, even when i drive, the only way that i way able to turn it off was by taking one of the wires off the battery, then stops for a while but after a couple of day it happends again.
    How can i reset the alarm system?

    anyone knows?

    Sep 18, 2010 | 2004 Chrysler Crossfire

    4 Answers

    Chrysler Crossfire will not start


    It turns out that the fuel pump relay is the problem and that this (per chrysler) is a common problem with the crossfire.

    Jul 01, 2009 | 2004 Chrysler Crossfire

    1 Answer

    Fix Brakelight on Chrysler Crossfire 05


    They Are Removed From The Inside. On The Inside Of The Car Find The Opposite Side Of Where The Light Is. There Will Be Either Carpet Or A Panel There Remove That And It Will Give You Full Access To The Lights. Use A Twist And Pull Motion To Remove The Light From Its Housing Then Replace The Bulb.

    Jan 27, 2009 | 2004 Chrysler Crossfire

    1 Answer

    Brakelight


    Hi mount on a 2005 limited roadster (and maybe coupe?) is the string of brake lights under the spoiler. on other vehicles, it is simply the 3rd brake light.

    Jan 27, 2009 | 2004 Chrysler Crossfire

    4 Answers

    04 Crossfire not starting


    Same thing happened to me. It was giving me problems starting it. It died on me at the stop sign last week. I kept driving. On Friday it shut down on me while doing 60mph on the hwy. I towed it to the nearest dealer. The said they had top replace the cranck sensor and a cam sensor. I paid $1,043.01 for that. Today I couldn't start it....

    Sep 20, 2008 | 2004 Chrysler Crossfire

    1 Answer

    2002grand am daytime running lights


    99 - 04 grand am.

    I had the "service vehicle soon" light come twice with in 1 year. First the heald light bulbs were gone. Replaced the head light bulbs and after 2 starts the "service vehicle soon" light was gone.

    The second time the DRL - #194 amber bulbs were gone. Replaced these and the "service vehicle soon" light was gone after 2 starts. The DRLs are housed in the headlamp housing, the tiny bulbs beside the head light.

    Sep 06, 2008 | 2002 Pontiac Grand Am

    Not finding what you are looking for?
    2004 Chrysler Crossfire Logo

    295 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chrysler Experts

    yadayada
    yadayada

    Level 3 Expert

    76649 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8522 Answers

    Are you a Chrysler Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...