Question about 1996 Oldsmobile Bravada

1 Answer

Fasher unit location for a 1996 bravada

I cannot find 1996 bravada turn signal 2 prong .where is it located under the dash i cannot find it

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that got 5 achievements.


    An expert who has written 20 answers of more than 400 characters.


    An expert who has answered 20 questions.

  • Contributor
  • 33 Answers

Are you trying to replace the Turn Signal Fuse?

First, remove the ash try.

Then, there is a small bolt that you need to remove. When you removed the ash try, the bolt is shown. it is on the dash on the top left of the opening of where you removed ash tray.

Next, get a #30 Torx Head, either Ratchet or Screwdriver. To the left of the ash tray, about a foot, and to the right of the steering column, there is a Torx Head Bolt. Remove that.

Now, remove the panel around the radio and air conditioner controls. You don't need to remove it completely. Just enough to allow that bottom portion of the plate where you removed the screws to be lowered. You should see the tabs that rest on the panel that you just removed. Push that panel down as far as you can. To the right of where you removed that Torx Screw you should see two round silver cylinders. They should have the number '522' stamped on them. The one on left is for the Turn Signals, Left and Right, and the one on the right is for the Emergency Flashers. It is best to replace them both. Use a pair of pliers and pull them straight out, don't turn them. You can wiggle them, but don't turn them left or right. You could damage the connectors.

Put the knee panel and the front panel back in the opposite of the directions.

If you need further help, I would recommend that you go to your local auto parts store and get a Haynes Manual. There are detailed instructions on the removal and replacement of those fuses listed in that manual.

Hope this helps!

Posted on Nov 07, 2010

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is turn signal relay located on a 1996 Ford Explorer

If you are talking about the "flasher" most times they are up under the dash - Driver's Side Usually square / Rectangular in space has Two (2) prongs on it. When working you can hear the clicking from it.

Dec 15, 2014 | Cars & Trucks

1 Answer

Turns signals not working but hazards are. help!

the turn signals have their own flasher unit, located under the dash on the driver side-these are inexpensive and usually not too bad to replace but you have to lie upsidedown under the dash, with a flashlight to locate the old one, disconnect the harness connector and install the new one, about $8

Apr 19, 2011 | 1997 Oldsmobile Bravada

1 Answer

My turn signals do not work

Blown fuse or the flasher relay is defective. It has 2 flasher relays. One for the hazard lights and one for the turn signal lights. The turn signal flasher relay can be located in 2 different locations on your year model. One place it on drivers side under the dash on the right side of the steering column, mounted near the cigarette lighter. It may also be located on the opposite side of the steering column under the dash.

Feb 19, 2011 | 1996 Chevrolet Blazer

2 Answers

Trying to find turn signal flasher on 87 elcamino

It is under the dash near the steering column,silver in color,or yellow.

Jun 28, 2010 | 1987 Chevrolet El Camino

1 Answer

Where is the flashers located to replace turning signals in a 1996 nissan maxima

The combination flasher relay is located under the dash panel, next to the center console near the Automatic Speed Control Device (ACSD) control box. If the turn signals operate in only one direction, a bulb is probably burned out. If they do not operate in either direction, a bulb on each side may be burned out, or the flasher may be defective.


The flasher is located next to the ACSD control unit under the dash panel on the driver side of the vehicle

Hope this help (remember rated this). Good luck.

Feb 08, 2010 | 1996 Nissan Maxima

3 Answers

Where is Signal Flasher located?

should be under your dash near the steering column and will be labeled electronic flasher module (unit)

Sep 17, 2009 | 1997 GMC Sonoma

1 Answer

Turn signal does not flash right or left. Where is flasher unit?

yes it is the same. the problem is most likely the turn signal switch which is located on the steering column. be sure to check all fuses, relays, and bulbs first. keep me posted thanks

Jan 31, 2009 | 1996 Chevrolet S-10 Pickup

4 Answers

Turn signal flasher location

Under dash passenger side of steering column just kinda hanging there. round and has two prongs.

Jan 22, 2009 | 1994 Cadillac Eldorado

2 Answers

Turn signal

Most common cause is the flasher unit, the other less common cause is the wrong bulbs or incorrectly installed bulbs.

Sep 28, 2008 | 1994 Pontiac Grand Am

Not finding what you are looking for?
1996 Oldsmobile Bravada Logo

149 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides