Question about 1999 Honda Accord

1 Answer

Latching system for a child car seat honda accord

I would like to how to instal a child car seat with latch to an 1999 honda accord, my old mitsubishi had a latch sistem behind the head rest on the back seat. I could not find it in the 1999 honda accord lx

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 145 Answers

IF YOU GO TO A HONDA DEALER THEY SELL A SET OF THREE ANCHORS IN KIT.(JUST ASK FOR REAR CHILD SEAT ANCHORS)THEY RUN ABOUT $25 FOR SET. AT THAT POINT YOU CAN HAVE THEM OR YOUR NORMAL MECHANIC INSTALL FOR YOU OR IF YOU CHOOSE TO INSTALL YOURSELF THEY'RE FAIRLY EASY TO DO.IF YOU OPEN UP TRUNK AND LOOK AT BOTTOM SIDE OF REAR DECK(BEHIND HEADRESTS)YOU WILL NOTICE 3 SPOTS WHERE NOTS ARE WELDED TO DECK SPACED EVENLY ACROSS DECK.ONCE YOU HAVE A BEARING OF THERE LOCATION YOU TAKE A RAZOR BLADE AND MAKE THREE SMALL CUTS FROM TOP SIDE IN DECK FELT WHERE THESE NUTS ARE LOCATED. THIS IS WHERE SEAT ANCHORS BOLT TO.THERE ARE ALSO IN THE CREASE OF SEATS SMALL HOOKS TO ANCHOR LOWER STRAPS OF CAR SEAT TO.YOU KIND OF HAVE TO FEEL AROUND FOR THEM BUT ONCE YOU FIND FIRST TIME YOU LL GO RT TO THEM EVERY TIME. GOOD LUCK! JOEL

Posted on Jul 25, 2009

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: drivers front seat latch doesn't work 2001 beetle

its the cable from the handle to the seat mechanism that locks the seat in place. an easy fix with new cable from vw .i think its a dealer only part !

Posted on Jun 12, 2009

  • 274 Answers

SOURCE: 2001 Honda accord trunk latch spring fell out

It probably goes on the outside of the casing One end arond the cable to hold the latch against the cable

Posted on Jul 10, 2009

  • 227 Answers

SOURCE: trunk latch 2000 Mitsubishi will not open with key

Sounds like the linkage to the latch has come undone. What sucks about that is you usually have to take the back seat out to gain access. Once you hae the trunk back open it is somewhat easy to reattach the linkage.

Posted on Aug 02, 2009

  • 1608 Answers

SOURCE: repair seat belt latch - stuck- 1998 buick park-

Seat belts are usually not repairable.The only thing that can be done is to check and make sure nothing is stuck in it or that it is not twisted.You have the kind that is in the seat back itself.These are a little more difficult to remove from the seat because it is so easy to break the plastic trim covers.Best thing to do if not familiar with auto repair to go to the dealer or auto repair shop that you trust and have them repair it.Good luck.

Posted on Dec 07, 2009

  • 566 Answers

SOURCE: Drivers seat will not latch into place

the latches that lock into the fixed slide rails ?if you look under seat you will see the latches ar connected via pivoted levers these pivots may be rusted or slightly seized in holding off position try spaying dw 40 or other type lube then physically manouver the latch arms till free ? lube the seat adjust rod too ? making sure it is working ok ?

Posted on Dec 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 99 diamante & my back passanger door will not stay closed is this door lock operaci?n by magnetic field to actuator


The lock actuator is a soliniod but sounds like your door latch is stuck or rusted on the inside you can try some wd40 inside the latch might help. also check that the child safety switch in the door is not in a middle position it's located on the door latch.

Oct 01, 2016 | 1999 Mitsubishi Diamante

1 Answer

I need new seat belt latches. Dog chewed plastic off; belts won't lock.


Junk yard. Google "junk yard" and your location and you should get some hits. Or I like car-part.com. Once you get them, you should be able to access the bolt that holds them in place by moving the seat all the way forward (assuming that we are talking about front seats). There should be a plastic cover that "pops" off with a little influence. Remove bolt, install new/used part.

Apr 20, 2013 | 1999 Honda Accord

1 Answer

I need to know where to find the child anchor for a 1996 dodge caravan


There are no child anchors on a 96. This was around the time the latch system was under development. Just went through looking into this for my 1996 van. chico car seat fit well

The newer van seats will not fit either( I do have a 2007 seat for sale now ) as I tried to make one fit in my 1996 van with the latch system and it didnt fit. Wheels right spacing too wide for the anchor points.
Tom K. MN

Nov 11, 2011 | 1996 Dodge Caravan

1 Answer

To whom it may concern, I'm struggling to install our infant car seat in our Chrysler 300M, 2001. The base comes with hooks to attach to tethers or latches which should exist by the seat belt...


I would take the vehicle to a place where they install infant seats,because you can't put a price on a childs life.....hope this helps......cheers.

Jun 27, 2011 | Chrysler 300M Cars & Trucks

1 Answer

I have a 2003 2 door sunfire. I am installing a infant car seat base using the latch system instead of the seat belt. Can I do this in the middle of the back seat or does it have to go at one of the...


Ideally if there is a middle set of latches in the seat, you can install an infant car seat base there. If the seat has any kind of hump or other irregularity then it should not be installed there. Although the middle of the back seat is safest for a child, most vehicle do not have a latch system there. However most cars do have a lap belt for the center seat and that should be used if you decide to place your car seat.

Do not use the latches from either side of the right back and left seat. The latch system is designed to be a specific distance apart to work correctly. If you don' want to use the lap belt then you should put the child seat on either the left or right back seat using the latch system.

Aug 18, 2010 | 2003 Pontiac Sunfire

1 Answer

1995 Honda Accord Car seat install problem


I can't be of much help, except to indicate what Honda says about the seats, and to give you a URL to look at:
Using a Seat Belt Locking Clip
Always use a seat belt locking clip when you secure a child seat to your car with a lap/shoulder belt. This helps prevent the seat from shifting position or overturning. A locking clip is usually included with the child seat. If you need a clip, contact the seat's manufacturer or a store that sells child restraints.
The URL will take you to a more complete reference to your car manual regarding child restraints.
https://techinfo.honda.com/rjanisis/pubs/om/AC9595/AC9595O00020A.pdf
Hope this helps you.

Nov 18, 2009 | 1999 Honda Accord

2 Answers

Trunk/gas tank latch wont work (honda accord)


I have this problem now i got my trunk to lock by going in the trunk and removing the wire from the hook that was keeping it loose. Now i can lock my trunk but i am still looking for a way to get in my gas tank. Help me please if you can.

Dec 07, 2008 | 1999 Honda Accord

1 Answer

Hello i just purchased a 1999 mercury cougar and in the glove box was a hook up for a child restraint...it gave me little directions on how to use and the hook up but i followed those instructions and i...


I guess the first question is, do you need this? Your car is probably too old to have the LATCH system or the locking seat belt. The adapter that is provided is to lock the seatbelt to keep constant tension on the seatbelt when extended over the child in a booster seat. Is this the adapter you are trying to use?

Oct 24, 2017 | 1999 Mercury Cougar

1 Answer

Car Seat Installation


It is safe to use, just make sure to put your knee in the seat to compress it down while tightening the seat to make sure it gets a good fit. Most CPSTs prefer the noodles b/c a towel can get compressed too much.

How old is the child? If the child is past 7-9 months and hold their body and head up well already, the seat doesn't need to be at a 45 degree angle anymore. 45 degrees is only for when they can't hold their head up yet. It prevents them from choking when their head rolls forward. Older babies won't have this problem, and often prefer to be a little less reclined. You can have it anywhere between 30-45 degrees, though you have to just eyeball it, without an exact way to measure put the child in and adjust it till he/she looks comfy.

Definitely call your police station and ask about help installing a car seat, they'll direct you to a CPST who can help you install it.

Jul 06, 2008 | 2006 Ford Explorer

Not finding what you are looking for?
1999 Honda Accord Logo

Related Topics:

1,682 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...