Question about 1999 Chevrolet Tahoe

1 Answer

WON'T START I THOUGHT IT WAS A FUEL PUMP BUT GAS IT GETTING INTO THE LINES WHEN THE VALVE IS PRESSED DOWN GAS COMES OUT WHAT COULD IT BE?

1999 CHEVY TAHOE WON'T START I THOUGHT IT WAS A FUEL PUMP BUT GAS IT GETTING INTO THE LINES WHEN THE VALVE IS PRESSED DOWN GAS COMES OUT WHAT COULD IT BE?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

Bad gas ,water in the gas

Posted on May 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just replaced a fuel pump on my 1999 chevy 4.8l and now it will not start at all. I can hear the fuel pump turning on but when I try to start it, it is acting like it isnt getting any gas.. checked all...


Try this------- turn ignition on, wait for pump to stop, then turn back on, do this about 5 times so the pump can build up pressure in the line.
After the 5th time, hold the throttle down about half way, if there isn't some other problem, it should fire up.

Sep 10, 2011 | 1999 Chevrolet Silverado 1500

3 Answers

2002 jeep liberty turns over but will not crank. I hear the fuel pump at the gas tank but it still acts like it isn't getting any gas, I thought it was the gas because my husband's truck stopped...


Check for pressure at your fuel rail, If your fuel pump is working correctly you should be getting fuel spraying out of the rail when you press in on the needle valve (sometimes covered by a small cap)

This will let you know if your fuel pump is working, and at least if fuel is making it past your filter.

Aug 29, 2011 | 2002 Jeep Liberty

1 Answer

Won't start its like its not getting gas. I can turn the key and pump on the gas it will rev up and shut off. I thought it was the fuel pump so I changed it and that didn't solve the problem what else can...


maybe its bad gas, or an idle issue. you shouldnt have to pump the gas when you start that can actually lead to flooding the engine with gas. Turn the key on and wait about 30 secs before cranking this will ensure your getting proper amount of gas to injector lines. It may take a bit to get rid of gas in there but keep doing it until it starts properly. Also note in doing this do not continuously crank it as the starter and solenoid will fry. Also if you fear there is no gas going to engine look for a gas line bleeder valve. Looks like a tire valve head and usually is covered with a black plastic lid. If you push it in and gas squirts out then your getting gas to engine. If you release all gas and turn the key on and test gas line again and no gas comes out then its what is called a dry start, aka no gas getting to motor. Hence failure of fuel filter or fuel pump. Or a general clog in gas line.

Aug 18, 2010 | 1994 Chrysler Concorde

1 Answer

Stalls after strting. need to depress the gas to start it


the fuel pump pressure is bleeding down, this is not supposed to happen, the fuel pump has a check valve built into the out or pressure port, when this check valve ball starts leaking u get air in the lines and need to press the gas to help bleed it out, u will need to replace the fuel pump.

Jul 18, 2010 | 1999 Jeep Cherokee

1 Answer

Water in gas tank. how do i drop two tanks on 1999 chevy 3500 steak truck


Normally it's just a matter of removing filler tubes from side, disconnect fuel lines & electrical connections at fuel pump/sender, undo the 2 straps, & lower it down.

May 15, 2009 | 1999 Chevrolet 3500

1 Answer

2000 gmc jimmy wont start fuel pump comes on and cuts off but will not start.I have changed the fuel filter and that did not work. Is the pump not building the pressure it needs to start or would my...


When you hook the pressure test guage to shrader valve on fuel rail what it reads is what the pressure is from pump, around 60 p.s.i. all you need to do is hook up the guage and turn on key, you do not have to turn engine over, and if pump is good it will shoot up to 58 or 60 right now.

Feb 14, 2009 | 1999 GMC Jimmy

1 Answer

Runs good up to 35 miles'''' then wants to die ,giving more gas


ignition moduel were bad so were cats, dont rule out fuel filter or pump

Jan 12, 2009 | 1991 Chevrolet Lumina Apv

1 Answer

1999 chevy blazer fuel problem


probably not fuel filter . probably going to have to remove the upper intake and replace the fuel injector spider(fuel inj assebly) if it is droping fuel pressure it is leaking into the upper manifold

Nov 29, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
1999 Chevrolet Tahoe Logo

Related Topics:

225 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...