Question about 1996 GMC Jimmy

1 Answer

Where is the clutch cycle switch located on 1996 GMC Jimmy? There is no power to the clutch and the fuses are okay, so I assume this is the problem

Posted by on

  • seanspin944 May 29, 2009

    Thanks for the extra information. It sounds like I will need it!!!

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • GMC Master
  • 3,854 Answers

The clutch cycle switch is on the accumulator by the A/C housing, it looks like a silver cylinder. You can replace the new cycle switch without discharging the system, just unscrew the old one and screw in the new one. Just make sure you hove the new switch ready and the O rings have oil on them, need to be quick so you don't lose that much R134.
After installing the new R134 check the R134 pressure and recharge if low. Good luck and hope this helps. Note: if the system is low on R134 the clutch will not activate or if the relay is bad too.
The relay is in the glove box, at the back of the glove box there is a access door labeled relay. There are three relay's in there, the fuel pump, rear brake light and the A/C. Think the middle one is the fuel pump and can't remember which is the brake light. If you have someone push on the brake's you can feel which relay is the brake light. You can always swap the relays around.
Good luck and hope this helps.

Posted on May 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ac clutch cycle switch 2003 kia sedona


usually right behind the pulley that holds the belt

Jun 27, 2014 | 1996 GMC Jimmy

2 Answers

Where is the turn signal flasher relay?


If you have the owner's manual there will be a fuse box diagram and it should include all relays. If not you can purchase a Haynes manual that will also include the diagrams. Most likely the flasher is in the high amp fuse box under the hood and there is usually a diagram on the cover or in the fuse box itself.

Feb 14, 2011 | 1996 GMC Jimmy

1 Answer

No bake lights hazard lights or turn signals on 1996 MC Jimmy


The first place to start is with the fuses, make sure all fuses are good, then move on to the signal light switch, brake lights run through signal switch but this sounds like a fuse or the switch.

Jul 15, 2010 | 1996 GMC Jimmy

1 Answer

96 jimmy 4wd will not engage fuse is okay no


those pannels go out on those! if the button goes out it wont engage. and it will shine on start up but its still out. goodluck joeyj35@live.com

Feb 12, 2010 | 1996 GMC Jimmy

1 Answer

1996 GMC Jimmy will not shift into overdrive.


4th gear failure is a common problem with this transmission, assuming it is an automatic. You should have the vehicle checked for codes by a qualified repair center with the proper scan tool. Also, check fluid level and condition. More often than not, the trans loses 3rd and 4th gear, as these are working off the same set of clutches. 3-4 clutches apply in 3rd, and when the 4th shift is made the 2-4 band applies giving you overdrive. If you have no engine braking in manual 3rd, you definitely have a mechanical failure, no 4th could be an electrical, or mechanical fault.

Nov 18, 2009 | 1996 GMC Jimmy

3 Answers

Is there a breaker or a fuse for the fuel pump and if so where do I locate it?


the fuel pump has a fuse, it is located in the under hood power distribution box, it just beside the fuel pump relay, believe it is marked ECM 1.

Sep 12, 2009 | 1996 GMC Jimmy

1 Answer

1996 gmc jimmy wont shift into park stops at neutral its a manual tansmission


a manual transmission don't have park i am assuming you have a automatic trans in vehicle and maybe the park interlock is not working properly check fuses 1st

Sep 08, 2009 | 1996 GMC Jimmy

1 Answer

1996 jimmy gmc fuse box


Look on the driver's side fender well under the hood. Should be a long black rectangular box there. That is the power center or fuse block. The relays and fuses are inside. The top is not hard to remove. Hope this helped and best wishes.

Sep 01, 2009 | 1995 GMC Jimmy

3 Answers

Cannot locate where the a/c clutch cycle switch is... there is no power in the wires to the clutch and fuses are okay.


The a/c clutch is attached to the front of your a/c compressor. It is the part that your serpentine belt runs on. It is either engaged or not based on the demand of the a/c system. It will not run if it senses low pressure in the freon supply line so you might try having the system checked for proper fill before replacing the clutch.

May 29, 2009 | 1996 GMC Jimmy

Not finding what you are looking for?
1996 GMC Jimmy Logo

300 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...