Question about 1986 GMC Suburban

1 Answer

Key won't turn, how do you remove switch from 1986 gmc suburban?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,600 Answers

Lok for a small hole on the key ring if there is no hole the steering wheel has to come off and a screw has to be taken out for the tumbler and key switch comes out also the horn spring and tang has to be pulled out .

Posted on May 29, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When i turn the ignition key over the 1994 gmc suburban will not start. then when i turn the ignition key over again the vehicle will start with no problem. i dont do anything between turning the key over....


Neutral Safety Switch ? located at the bottom of the steering column. Mine is tricky, have to pull the shift lever while turning over to get it started. happened after i replaced ignition switch & Neutral Safety Switch

Aug 20, 2011 | 1994 GMC Suburban

1 Answer

1994 gmc surburban turns over fine but engine won't start


You can check to see if the fuel pump is bad..Remove gas cap and listen into tank while another person turns key on.If you here a buzzing noise the fuel pump is most likely OK...If you don't here anything Check owners manual for fuse location and check to see if there are any blown..There is also a fuel relay fuse under the hood

Jun 11, 2011 | 1994 GMC Suburban

1 Answer

86'Gmc Suburban, when the headlights are turned on the left turn signal will not work, durning the daylight hours when engaged all lights flash as if you had the 4way flashers on. I've replaced the...


have u repaced the turn switch they have had a lot or problems in the past if it is the harness usually the problems in the steering column

Jan 11, 2010 | 1986 GMC Suburban

1 Answer

1999 GMC Suburban K2500 7.4L 4x4 starting problems


I the fuses and relays are good for the pump it could be a bad pump especialy if you was having starting problems make sure you have power to the pump. Also do this before changing pump. Put your key in turn it on dont start wait 10 mins remove key wait 10 seconds repeat this a total of 3 times. If that dont work try a different key do the same thing. This relearns your key to the ignition it started with Gm cars and trucks from 1999 to to 2006. It is a big problem but there is no recall that I know of. If that dont work a dealer needs to probably replace and reprogram your ignition switch and keys

Dec 27, 2009 | 1999 GMC Suburban

2 Answers

1986 gmc suburban can't find fuse box


Check way up under the dash by the parking brake commonly referred to as emergency brake pedal

Nov 05, 2009 | 1986 GMC Suburban

1 Answer

1986 gmc suburban is original motor fuel injection???


No, fuel injected engines were not used in Suburbans until 1987

Jun 11, 2009 | 1986 GMC Suburban

1 Answer

1986 gmc suburban door panel removal


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Mar 25, 2009 | 1986 GMC Suburban

1 Answer

Key stays in ignition and will not turn off engine


you need to replace the ignition switch
Not a simple deal ....
LB

Sep 22, 2008 | 1991 GMC Suburban

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...